2000 SUBARU FORESTER Owners Manual

7-10NOTE Engine oil, engine coolant, brake fluid, washer fluid and other fluid
levels should be checked daily, weekly or at fuel stops.
Driving in foreign countries
When p lanning to use your vehic le in another c ountr
y:
Confirm the availab ility of the c orrec t fuel. (Refe r to Fuel Req uirement
sec tion in this c hap ter.) Comp ly with all reg ulations and req uirements of eac h c ountry.
Periodic inspections
To keep your vehic le in the b est c ond ition at all t imes, always have the
rec ommend ed maintenanc e servic es listed in the main tenanc e sc hed ule
in the “Warranty and Maintenanc e Booklet ” p erformed at the sp ec ified
time or mileag e intervals.
Ignition switch
WARNING
Never turn the ignition switch to “LOCK” while the vehicle is be-
ing driven or towed because that will lock the steering wheel, pre- venting steering control. And when the engine is turned off, it
takes a much greater effort than usual to steer.
The ig nition switc h has four p ositions: LOCK, ACC, ON and START.

Starting and operating7-11
–
CONTINUED –
HS0122
LOCK
The key c an only b e inserted or removed in this p os ition. The ig nition
switc h will loc k the steering wheel when you remove the key.
If turning the key is d iffic ult, turn the steering wheel slig htly to the rig ht
and left as you turn the key. n Automatic transmission vehicles:
HS0124
HS0123
The key c an b e turned from “ACC ” to “LOCK ” only when the selec tor
lever is in the “P ” p osition.

7-12n
Manual transmission vehicles:
HS0125
1
2
The key c an b e turned from “ACC ” to “LOCK ” only when the key is
p ushed in while turning it. ACC
In this p osition the elec tric al ac c essories (rad io, ac c essory p ower
soc ket, etc .) c an b e used . ON
This is the normal op erating p osition after the eng ine is started .
START
CAUTION
Do not turn the ignition switch to the “START” position while the
engine is running.
The eng ine is started in this p osition. The starter c ranks the eng ine to
start it. When the key is released (after the eng in e has started ), the
key automatic ally returns to the “ON ” p osition.
Key reminder chime
The remind er c hime sound s when the d river ’s d oor op ens and the key is
in the “LOCK ” or “ACC ” p ositions. The c hime stop s when the key is re-
moved from the ig nition switc h.

Starting and operating7-13
–
CONTINUED –

Key interlock release (AT vehicles only)
If the key c an not b e turned to the “LOCK ” p osition even when the selec -
tor lever is in the “P ” p osition:
HS0127HS0126
Vehicle front
Release lever
1. Take out the sc rewd river from the tool b ag .
2. Remove three sc rews sec uring the und erc over of th e steering c ol-
umn.
3. Remove the und er c over of the steering c olumn.
4. Turn the ig nition key while p ressing the key inte rloc k release lever.
Take your vehic le to the nearest SUBARU d ealer imme d iately to have the
key interloc k system rep aired .
Starting the engine
CAUTION
Do not operate the starter motor continuously for more than ten
seconds. If the engine fails to start after operating the starter forfive to ten seconds, wait for ten seconds or more before tryingagain.
Manual transmission vehicles
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.
3. Press the c lutc h p ed al to the floor and shift the shift lever into neu-

7-14tral. Hold the c lutc h p ed al to the floor while star
ting the eng ine. The
starter motor will only op erate when the c lutc h p ed al is p ressed fully
to the floor.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op era-
tion of the warning and ind ic ator lig hts. Refer to “Warning and ind ic a-
tor lig hts ” sec tion (Chap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without d ep ressing
the ac c elerator p ed al. Release the key immed iately after the eng ine
has started .
If the eng ine d oes not start within ten sec ond s, wa it a while and then
turn the ig nition switc h to the “START ” p osition ag ain while d ep ressing
the ac c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one off after the
eng ine has started . The fuel injec tion system autom atic ally lowers the
id le sp eed as the eng ine warms up . Automatic transmission vehicles CAUTION
If you restart the engine while the vehicle is moving, shift the se- lector lever into the “N” position. Do not attempt to place the se-
lector lever of a moving vehicle into the “P” position.
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.
3. Shift the selec tor lever to the “P ” or “N ” p osition (p referab ly “P ”
p osition).
The starter will only op erate when the selec t lever is at the “P ” or “N ”
p osition.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op era-
tion of the warning and ind ic ator lig hts. Refer to “Warning and ind ic a-
tor lig hts ” sec tion (Chap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without depress-
ing the accelerator pedal . Release the key immed iately after the en-
g ine has started .

Starting and operating7-15
–
CONTINUED –
If the eng ine d oes not start within ten sec ond s, wa
it a while and then
turn the ig nition switc h to the “START ” p osition ag ain while d ep ressing
the ac c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one out after
the eng ine has started . The fuel injec tion system a utomatic ally lowers
the id le sp eed as the eng ine warms up .
While the eng ine is warming up , make sure that the selec tor lever is at
the “P ” or “N ” p osition and that the p arking b rake is ap p lied .
During cold weather below – 4F ( – 20 C)
If the eng ine is d iffic ult to start using the norma l method (without d e-
p ressing the ac c elerator p ed al), turn the ig nition switc h to the
“ START ” p osition while slig htly d ep ressing the ac c elerator p ed al.
Flooded engine
If the eng ine d oes not start, it may b e flood ed (ex c essive fuel in the
eng ine).
In c ase of a flood ed eng ine, turn the starter motor for five sec ond s
with the ac c elerator p ed al fully d ep ressed . Rep eat this two or three
times until the eng ine starts. Release the ig nition switc h and ac c elera-
tor p ed al as soon as the eng ine starts.
Stopping the engine
WARNING
Do not stop the engine when the vehicle is moving. This will
cause loss of power to the power steering and the brake booster,making steering and braking more difficult. It could also result in
accidental activation of the “LOCK” position on the ignition
switch, causing the steering wheel to lock.
The ig nition switc h should b e turned off only when the eng ine is id ling .

7-16Manual transmission
WARNING
Do not drive the vehicle with the clutch disengaged (i.e., when the clutch pedal is depressed) or with the shift lever in the neutralposition. Engine braking has no effect in either of these condi-tions and the risk of an accident is consequently increased.
CAUTION
Shift into reverse ONLY when the vehicle has completelystopped. It may cause damage to the transmission to try shiftinginto reverse when the vehicle is moving.
The manual transmission is a fully sync hromeshed 5- forward and 1-re-
verse sp eed transmission.
HS0128
The shift p attern is shown on the shift lever knob . When shifting from 5th
g ear to reverse g ear, first return the shift lever to the neutral p osition then
shift into reverse g ear.
To c hang e g ears, fully d ep ress the c lutc h p ed al, mo ve the shift lever,
and g rad ually let up on the c lutc h p ed al.
If it is d iffic ult to shift into g ear, p ut the tran smission in neutral, release the
c lutc h p ed al momentarily, and then try ag ain.

Starting and operating7-17
–
CONTINUED –

Shifting speed
n Recommended shifting speeds
The b est c omp romise b etween fuel ec onomy and vehic l e p erfor-
manc e d uring normal d riving is ensured b y shifting up at the sp eed s
listed in the following tab le.
Shift up
mp h (km/h)
1st to 2nd15 (24)
2nd to 3rd25 (40)
3rd to 4th40 (65)
4th to 5th45 (73)
nMaximum allowable speeds
WARNING
When shifting down a gear, ensure that the vehicle is not travel- ling at a speed exceeding the Maximum Allowable Speed for thegear which is about to be selected. Failure to observe this pre-caution can lead to engine over-revving and this in turn canresult in engine damage.In addition, sudden application of engine brakes when the vehicleis travelling on a slippery surface can lead to wheel locking; as a
consequence, control of the vehicle may be lost and the risk ofan accident increased.
The following tab le shows the maximum sp eed s that a re p ossib le with
eac h d ifferent g ear. The tac hometer ’s need le will enter the red area if
these sp eed s are exc eed ed .
With the exc ep tion of c ases where sud d en ac c elerati on is req uired ,
the vehic le should not b e d riven with the tac homete r’s need le insid e
the red area. Failure to ob serve this p rec aution c a n lead to exc essive
eng ine wear and p oor fuel ec onomy.