2000 CHRYSLER CARAVAN Service Manual

TEST NS-2ACONTINUED - REPAIRING A NO RESPONSE CONDITION
*Perform Verification TEST VER-1A. **Check connectors - Clean / repair as necessary.
PROBE DIESEL POWER
RELAY CONNECTOR
CAVITY 86 (IN PDC).
FIG.1
CONNECT A JUMPER
WIRE BETWEEN ECM
HARNESS CONNECTOR
CAVITY 33 AND
GROUND.
FIG. 4
N
O
R
E
S
P
O
N
S
E
T
E
S
T
403
ProCarManuals.com

TEST NS-2ACONTINUED - REPAIRING A NO RESPONSE CONDITION
FIG. 1
N
O
R
E
S
P
O
N
S
E
T
E
S
T
404
ProCarManuals.com

TEST NS-2ACONTINUED - REPAIRING A NO RESPONSE CONDITION
*Perform Verification TEST VER-1A. **Check connectors - Clean / repair as necessary.
TEST NS-2A USING A JUMPER
CONTINUED FROM WIRE, CONNECT
THE PREVIOUS DIESEL POWER RELAY
PAGE. CAVITIES 30 AND 87
(IN PDC). FIG. 1
USING A VOLTMETER, REPAIR THE DIESEL
MEASURE THE DIESEL IS THE VOLTAGE YES POWER RELAY
POWER RELAY ABOVE 1.0 VOLT? CONTROL CIRCUIT
CONTROL CKT. FOR A SHORT TO
FIG. 1 VOLTAGE.*
NO
REPLACE THE DIESEL
POWER RELAY.*
N
O
R
E
S
P
O
N
S
E
T
E
S
T
405
ProCarManuals.com

TEST NS-2BREPAIRING A NO RESPONSE CONDITION
Perform TEST NS-2A Before Proceeding
FIG.1
FIG.2
N
O
R
E
S
P
O
N
S
E
T
E
S
T
406
ProCarManuals.com

TEST NS-2BREPAIRING A NO RESPONSE CONDITION
Perform TEST NS-2A Before Proceeding
*Perform Verification TEST VER-1A. **Check connectors - Clean / repair as necessary.
WAS THE IGNITION TURN IGNITION ON
START TEST ON WHEN THE "NO NO TO GET A RESPONSE.
NS-2B. RESPONSE" MESSAGE
WAS DISPLAYED? TEST COMPLETE.
YES
KEY ON. PROBE THE
ISO K-LINE CIRCUIT IS THE TEST LIGHT YES REPAIR THE ISO
USE A TEST LIGHT AT THE DLC. ON? K-LINE FOR A SHORT
IN THE FOLLOWINGTO VOLTAGE.*
STEP. FIG.1
NO
KEY OFF.
DISCONNECT DRB
DISCONNECT THE ECM FROM THE DATA LINK
HARNESS CONNECTOR.
CONNECTORS.**
MEASURE THE
USE AN OHMMETER IN RESISTANCE OF THE IS THE RESISTANCE YES REPAIR THE ISO
THE FOLLOWING ISO K-LINE AT THE BELOW 5.0 OHMS? K-LINE CIRCUIT FOR
STEPS. DLC CONNECTOR TO A SHORT TO GROUND.
GROUND FIG.1
NO
MEASURE THE
RESISTANCE OF THE IS THE RESISTANCE NO REPAIR THE OPEN
ISO K-LINE AT THE BELOW 5.0 OHMS? ISO K-LINE
DLC CONN. TO THE CIRCUIT.
ECM CONN. FIG.2
YES
MEASURE BETWEEN THE DLC CAVITIES REPAIR THE GROUND
CHASSIS GROUND AND 4 AND 5. IS THE RESISTANCE NO CIRCUIT(S) THAT
THE GROUND BELOW 5.0 OHMS FOR MEASURED ABOVE 5.0
CIRCUITS AT... EACH MEASUREMENT? OHMS FOR AN OPEN.*
FIG.1
YES
CONTINUE TEST
NS-2B ON THE
NEXT PAGE.
N
O
R
E
S
P
O
N
S
E
T
E
S
T
407
ProCarManuals.com

TEST NS-2BCONTINUED - REPAIRING A NO RESPONSE CONDITIONN
O
R
E
S
P
O
N
S
E
T
E
S
T
408
ProCarManuals.com

TEST NS-2BCONTINUED - REPAIRING A NO RESPONSE CONDITION
*Perform Verification TEST VER-1A. **Check connectors - Clean / repair as necessary.
TEST NS-2B CONNECT THE DRB TO
CONTINUED FROM A FUNCTIONAL DATA
THE PREVIOUS LINK ON ANOTHER
PAGE. VEHICLE.
REPLACE THE
WITH THE DRB, DID THE DRB NO INITIAL VEHICLE'S
TURN IGNITION ON. ATTEMPT TO READ DISPLAY "NO ENGINE CONTROL
TROUBLE CODES. RESPONSE"? MODULE.*
YES
SUBSTITUTE ANOTHER WITH THE DRB, DID THE DRB NO REPLACE THE DRB
DRB ADAPTER CABLE. ATTEMPT TO READ DISPLAY "NO ADAPTER CABLE.*
TROUBLE CODES. RESPONSE"?
YES
HAVE THE DRB
REPAIRED OR
REPLACED.*
N
O
R
E
S
P
O
N
S
E
T
E
S
T
409
ProCarManuals.com

TEST NS-3AREPAIRING - NO START
Perform TEST NS-SEL Before Proceeding
FIG.1
FIG.2
FIG.3
N
O
S
T
A
R
T
T
E
S
T
S
410
ProCarManuals.com