2000 CHRYSLER CARAVAN Service Manual

TEST TC-74ACONTINUED - REPAIRING - EMERGENCY STOP PLAUSIBILITY IN AFTER-RUN
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-74A KEY OFF.
CONTINUED FROM DISCONNECT THE REMOVE THE DIESEL
THE PREVIOUS FUEL PUMP AND ECM POWER RELAY.**
PAGE. HARNESS
CONNECTORS.**
WITH A JUMPER WIRE, KEY ON. USING A REPAIR THE FUEL
CONNECT DIESEL POWER VOLTMETER, MEASURE IS THE VOLTAGE YES SHUTDOWN SOLENOID
RELAY CONN. CAVITIES THE FUEL SHUTDOWN ABOVE 1.0 VOLT? CONTROL CIRCUIT
30 AND 87 (IN PDC). SOL CONTROL CKT. FOR A SHORT TO
FIG.1 FIG.2 VOLTAGE.*
NO
RECONNECT THE
ENGINE CONTROL KEY ON. USING DRB
MODULE HARNESS ACTUATE THE "FUEL
CONNECTORS. SHUT-OFF SOL."
WITH THE DRB FUEL PUMP HARNESS DOES VOLTMETER
ACTUATING THE CONNECTOR CAVITY 6. CHANGE FROM YES REPLACE FUEL PUMP
SOLENOID, USE A BATTERY VOLTAGE TO ASSEMBLY.*
VOLTMETER TO BELOW 1.0 VOLT?
PROBE... FIG.2
NO
NOTE: BEFORE
REPLACING ECM, DID THE FUEL YES REPLACE THE ENGINE
PERFORM TEST NTC-3A INJECTION PUMP CONTROL MODULE.*
TO CHECK INTERNAL PASS TEST NTC-3A?
FUEL PUMP CIRCUITRY.
NO
REPLACE THE FUEL
INJECTION PUMP
ASSEMBLY.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
235
ProCarManuals.com

TEST TC-75AREPAIRING - REDUNDANT EMERGENCY STOP POWERSTAGE DEFECTIVE
Perform TEST DTC Before Proceeding
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
236
ProCarManuals.com

TEST TC-75AREPAIRING - REDUNDANT EMERGENCY STOP POWERSTAGE DEFECTIVE
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
START TEST WITH THE DRB,
TC-75A. ERASE CODES.
CYCLE THE IGNITION DOES THE DRB
ON AND OFF SEVERAL WITH THE IGNITION DISPLAY "REDUNDANT YES CONTINUE TEST
TIMES, PAUSING FOR ON ENGINE OFF, EMERG STOP TC-75A ON THE
TEN SECONDS AT KEY READ CODES. POWERSTAGE NEXT PAGE.
ON AND OFF. DEFECTIVE"?
NO
AT THIS TIME THE REVIEW THE CIRCUIT
CONDITION FOR DESCRIPTION FOR A WERE ANY PROBLEMS YES REPAIR AS
SETTING THE CODE PROPER UNDERSTANDING FOUND? NECESSARY.*
IS NOT PRESENT. OF THIS CODE. CHECK
FIG.1 FOR PROBLEMS.
NO
REFER TO GENERAL
INFORMATION 3.3.2 YES
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
237
ProCarManuals.com

TEST TC-75ACONTINUED - REPAIRING - REDUNDANT EMERGENCY STOP POWERSTAGE
DEFECTIVE
FIG.1
FIG.2
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
238
ProCarManuals.com

TEST TC-75ACONTINUED - REPAIRING - REDUNDANT EMERGENCY STOP POWERSTAGE
DEFECTIVE
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
TEST TC-75A KEY OFF.
CONTINUED FROM DISCONNECT THE
THE PREVIOUS FUEL PUMP AND ECM
PAGE. HARNESS
CONNECTORS.**
MEASURE THE
USE AN OHMMETER IN RESISTANCE OF THE IS THE RESISTANCE NO REPAIR OPEN FUEL
THE FOLLOWING FUEL SHUTDOWN BELOW 5.0 OHMS? SHUTDOWN SOLENOID
STEPS. SOLENOID CONTROL CONTROL CIRCUIT.*
CIRCUIT. FIG.1
YES
MEASURE THEREPAIR THE FUEL
RESISTANCE OF THE IS THE RESISTANCE YES SHUTDOWN SOLENOID
FUEL SHUTDOWN SOL. BELOW 5.0 OHMS? CIRCUIT FOR A
CONTROL CIRCUIT TO SHORT TO GROUND.*
GROUND. FIG.2
NO
RECONNECT THE
ENGINE CONTROL KEY ON. USING DRB
MODULE HARNESS ACTUATE THE "FUEL
CONNECTORS. SHUT-OFF SOL."
WITH THE DRB FUEL PUMP HARNESS DOES VOLTMETER
ACTUATING THE CONNECTOR CAVITY 6. CHANGE FROM YES REPLACE FUEL PUMP
SOLENOID, USE A BATTERY VOLTAGE TO ASSEMBLY.*
VOLTMETER TO BELOW 1.0 VOLT?
PROBE... FIG.2
NO
NOTE: BEFORE
REPLACING ECM, DID FUEL INJECTION YES REPLACE THE ENGINE
PERFORM TEST NTC-3A PUMP PASS TEST CONTROL MODULE.*
TO CHECK INTERNAL NTC-3A?
FUEL PUMP CIRCUITRY.
NO
REPLACE THE FUEL
INJECTION PUMP
ASSEMBLY.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
239
ProCarManuals.com

TEST TC-76AREPAIRING - SMART START RELAY SHORT CIRCUIT
Perform TEST DTC Before Proceeding
FIG.1
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
240
ProCarManuals.com

TEST TC-76AREPAIRING - SMART START RELAY SHORT CIRCUIT
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-1A. **Check connectors - Clean / repair as necessary.
REPLACE THE
START TEST STARTER RELAY WITH
TC-76A. A KNOWN GOOD
RELAY.
FIG.1
FULLY DEPRESS THE
CLUTCH PEDAL AND DOES THE ENGINE YES REPLACE THE
ATTEMPT TO CRANK CRANK? INITIAL STARTER
THE ENGINE RELAY.
NO
KEY OFF.
REMOVE THE STARTER REMOVE THE DIESEL
DISCONNECT THE ECM RELAY.** POWER RELAY.**
HARNESS
CONNECTORS.**
WITH A JUMPER WIRE, KEY ON. USING A REPAIR THE STARTER
CONNECT DIESEL POWER TEST LIGHT, PROBE IS THE TEST LIGHT YES RELAY CONTROL
RELAY CONN. CAVITIES THE STARTER RELAY ON? CIRCUIT FOR A
30 AND 87 (IN PDC). CONTROL CIRCUIT. SHORT TO VOLTAGE.*
FIG.1 FIG.1
NO
REPLACE THE ENGINE
CONTROL MODULE.*
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
241
ProCarManuals.com

TEST TC-79AREPAIRING - SOLENOID VALVE CONTROLLER OPEN CIRCUIT
Perform TEST DTC Before Proceeding
FIG.1
FIG.2
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
242
ProCarManuals.com