Page 81 of 96
33
79
Starting – Riding – Parking
e Important:
Do not operate any powerful ra-
dio equipment on or near your
BMW C1. There is a slight risk
of it affecting operation of the
ABS.
* Optional extra
ABS checkStart-up is automatic when the
ignition is switched on.
Warning lights 1 and 2 light up.
ABS self-diagnosisAfter starting the engine and
riding away:
– Warning lights 1 and 2 go out
if the ABS is in correct work-
ing order
Anti-lock braking system (ABS)*
21
Page 82 of 96
33
80
Starting – Riding – Parking
Anti-lock braking system (ABS)*
ABS faults–If ABS warning lights 1 and 2
flash simultaneously or
remain on all the time:
the ABS function is not availa-
ble
Possible causes of faults:
– Battery voltage is low
Recharge the battery.
\f Note:
This cause of fault does not ne-
cessitate a visit to the work-
shop. The system is fully
operational following the next
positive ABS self-test.
e Important:
If the fault persists seek spe-
cialist advice, preferably from
an authorised BMW dealer.
* Optional extra
21
Page 83 of 96
33
81
Starting – Riding – Parking
Anti-lock braking system (ABS)*
ABS operatingThe ABS is taking effect:
–if pulsating counter-pressure
is felt at the left and/or right
handbrake lever when the
brakes are applied.
\f Note:
Pulsation at the handbrake le-
ver indicates that the ABS is in
action.
The ABS prevents the rear
wheel lifting, depending on rid-
ing style and the applicable
boundary conditions.
* Optional extra
d Warning:
If the handbrake lever can be
moved right to the limit of its
travel, this indicates a
mechanical or hydraulic fault.
Immediately consult a spe-
cialist workshop, preferably
an authorised BMW dealer.
Page 84 of 96
33
82
Starting – Riding – Parking
Anti-lock braking system (ABS)*
ABS is out of action:
d Warning:
If ABS is not operational, as
shown by warning lights 1 and
2, the safety reserves
afforded by ABS are not at the
rider's disposal until the fault
has been rectified.
There is a risk of dropping the
machine if the brakes are
applied too hard and the front
wheel locks or the rear wheel
lifts clear of the ground as a
result of a high level of tyre
adhesion.
Have the defect rectified im-
mediately by a specialist
workshop, preferably an au-
thorised BMW dealer. ABS is out of action:
–
at speeds below 6 km/h
(3 mph) (or 12 km/h (6 mph) if
handbrake lever was pulled
beforehand)
– when the ignition is switched
off
– if the battery is flat or has a
fault (indicated by ABS warn-
ing lights coming on)
– if there is an ABS fault (
b80)
The brakes remain fully
operational, though without
the reserves of safety
afforded by ABS.
*Optional extra
( ) Figure in brackets
bpage number for
description
Page 85 of 96
4
83
Arrive safely.Know-how…In recent years, technical
design features have become
more and more complex and
ambitious. BMS, electronic
ignition, the catalytic converter
or the use of four valves per cyl-
inder are clear signs that far
more than basic technical
knowledge may be needed to
solve certain problems. In addi-
tion, high-tech materials are
increasingly taking the place of
conventional ones, which again
calls for thorough and expert
knowledge if they are to be
handled correctly during repair
work.
To be sure of achieving the nec-
essary standard, it is always
advisable to consult your
authorised BMW dealer. Authorised BMW dealers
employs staff who attend regu-
lar and comprehensive training
courses.
Authorised BMW dealers also
receive all the current technical
information and are therefore
fully aware of the latest devel-
opments.
…
technical featuresThe BMW dealer's staff has the
experience and all the neces-
sary facts at its disposal when it
comes to solving problems
quickly and effectively. Work-
shops are equipped with the
latest technical facilities, for
example the special tools
developed by BMW such as the
BMW MoDiTeC or exhaust
emissions tester.
Reliability
Page 86 of 96
4
84
Arrive safely.
Reliability
Regular visits to the workshop
for routine servicing are
strongly recommended even
after the warranty period has
elapsed. They are the only way
to be genuinely certain that your
BMW C1 is being kept in per-
fect working order.
For generous treatment of
claims submitted after the war-
ranty period has expired, evi-
dence of regular maintenance
by an authorised BMW dealer is
essential.Certain signs of wear may not
otherwise be noticed until it is
too late to put them right at
moderate cost.
The staff in the authorised BMW
dealership or workshop know
every detail of your vehicle and
can take remedial action if nec-
essary before minor faults
develop into serious problems.
By having the necessary repairs
done properly and in good time,
you save time and money in the
long run.
… serviceYou can obtain accurate advice
in all cases, and make appoint-
ments with a firm completion
deadline which we will comply
with punctually.
But the most gratifying feeling
of all is that your BMW C1 is in
genuinely good shape when it
leaves the authorised BMW
dealer's workshop
–and above
all, safe.
Page 87 of 96
4
85
Arrive safely.
BMW Service
BMW Service Even a BMW C1 may come to
an unexpected standstill occa-
sionally. If it does, we've taken
steps to put things right with a
minimum of inconvenience to
you. In many countries of
Europe, for example, there is a
closely spaced network of
authorised BMW C1 dealers
and workshops.
\f Note:
Call us if you have any ques-
tions about the BMW dealer-
ship network. You can reach us
directly by hotline in any country
in Europe. The phone numbers
are listed in the
European Service booklet (see
on-board documentation). Or if
you prefer you can use the
homepage address to contact
us on the Internet.
BMW Emergency ServiceBut what happens if you and
your BMW C1 don't make it to
the next authorised BMW C1
dealer, if, for example, it is out-
side normal business hours and
you are, quite literally, standing
in the rain?
No problem – just call our Emer-
gency Service number from any
telephone. Our experts are on
duty there day and night to
arrange assistance for you.
They can provide the expert
advice which may often be all
you need to be able to continue
your journey safely.
Page 88 of 96
4
86
Arrive safely.
Environmental protection
Development…BMW C1 riders have an inten-
sive relationship with nature.
Here too, BMW has created the
best possible preconditions for
a successful future.
This not only because your new
BMW C1 has exhaust emission
control by closed-loop, three-
way catalytic converter as
standard.
…waste disposal …Behind the scenes, in the repair
shop, we don't neglect the pro-
environmental aspects of our
work either.
Wherever possible, we use
environmentally acceptable
materials that can be broken
down by biological methods.
We ensure strict compliance
with all environmental legisla-
tion, for example the correct
disposal of old oil, which is now
classified as hazardous waste
in many countries.…recyclingApart from the correct disposal
of materials that are potentially
hazardous to the environment,
recycling is being given
increasing priority by BMW.
For example, plastics are indi-
vidually marked so that they can
be returned to the materials
cycle. Remember: when it
comes to making repairs to
your vehicle, the authorised
BMW workshop is far better
equipped to protect the envi-
ronment than you are at home.
