1998 Mercury Villager Owner's Manuals

WARNING
Handle a halogen headlamp bulb carefully and keep out
of children's reach. Grasp the bulb only by its plastic
base and do not touch the glass. The oil from your hand
could cause the bulb to break the next time the headlamps
are operated.
Do not remove the burned out bulb unless you can immediately
replace it with a new one. If a bulb is removed for an
extended period of time, contaminants may enter the headlamp
and affect its performance.
Removing the headlamp bulb
1. Make sure that the engine is off and the headlamp switch on
the instrument panel is in the OFF position.
2. Remove the electrical connector from the bulb by pulling the
connector away from the bulb assembly.
The headlamp bulb assembly
Maintenance and Care
317

3. Remove the bulb retaining ring by turning it counterclockwise
1/8 of a turn to free it from the socket. Then slide the ring off
the plastic base.Keep the ring.You must use it again to
hold the new bulb in place.
4. Carefully remove the bulb assembly from its socket by
gently pulling it rearward without turning.
5. Do not touch the bulb with your skin or you could shatter the
bulb. Always grasp the bulb assembly from the plastic base.
6. Be sure that you have the proper replacement bulb ready before
you discard the burned out bulb.
Removing the headlamp bulb retaining ring
318

Installing the headlamp bulb
1. With the flat side of the bulb's plastic base facing upward,
insert the glass end of the bulb into the socket. You may
need to turn the bulb left or right to line up the grooves in the
plastic base with the tabs in the socket. When the grooves
are aligned, push the bulb into the socket until the plastic base
contacts the rear of the socket. Do not touch the glass with
your fingers.
2. Slip the retaining ring over the plastic base until it contacts the
rear of the socket. Lock the ring into the socket by rotating it
until you feel a ªstop.º
3. Push the electrical connector into the rear of the plastic base
until it snaps, locking it into place.
Headlamp bulb replacement
Maintenance and Care
319

4. Turn the headlamps on and make sure that they work
properly. If the headlamp was correctly aligned before you
changed bulbs, you should not need to align it again.
Replacing the Bulbs
There are several different types of replacement bulbs for your
vehicle. The following illustration indicates the proper method of
removal and installation for each bulb.
The illustrations in this section will provide you with reference for
changing many of the bulbs on your vehicle.
The replacement bulbs
320

Bulb locations
Maintenance and Care
321

Bulb replacement chart
322

Maintenance and Care
323

324