Remove the two batteries by snapping open the lid of the remote
transmitter. The transmitter can be snapped apart by twisting
a thin coin between the two halves of the transmitter. Replace the
batteries with new ones as shown in the above illustration.
Close the lid securely. Press both the LOCK and the UNLOCK
button two or three times to test the remote transmitter operation.
If the batteries are removed for any reason other than
replacement, repeat the steps inReplacing the batteriesto test your
remote transmitter(s).
mAn improperly disposed battery can hurt the environment.
Always confirm local regulations for battery disposal.
mThe remote transmitter is waterproof; however, if it does get
wet, immediately wipe it completely dry.
mThe operational range of the remote transmitter extends to
approximately 49 feet (15 meters) from the vehicle. This
range may vary with conditions.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
Replacement/Additional Transmitters
In the event a transmitter is lost or an additional remote
transmitter needs to be set, you must change the ID code. Follow
the steps below to change the ID code of your system, or
return the remaining transmitter(s) to your dealer for
reprogramming of your remote entry system. This is necessary to
prevent unauthorized use of the lost transmitter.
Controls and Features
11 5
and water. Reinstall the cables when you are done cleaning them,
and apply a small quantity of grease to the top of each battery
terminal to help prevent corrosion.
Battery Replacement
If your original equipment battery requires replacement while
under warranty, it will be replaced with a Motorcraft service
battery, identical in design technology. Like the original
equipment battery, it should not require water addition during its
normal life of service; however, for severe service usage or in
high temperature climates, check your battery electrolyte level, at
least every 24 months or 24,000 miles (40 000 km). Do not
overfill the battery cells.
NOTE: If your battery has a cover/shield, make sure it is
re-installed after the battery is replaced.
If the electrolyte level in your battery gets low, you can add plain
tap water to the battery, as long as you do not use hard water
(water with a high mineral or alkali content). If possible, however,
try to only fill the battery cells with distilled water. If the
battery needs water often, have the charging system checked.
Help Us Protect Our Environment
Ford Motor Company strongly recommends that used lead-acid
batteries be returned to an authorized recycling facility for
disposal.
Battery recycling symbol
294
