P10889
New Insulator
New O−Ring
New Grommet New O−Ring
SF0QK−03
S01951
Push
Spacer
S01967
Push
Turn
S01940
S01947
ConnectorUpward
Turn
− SFIINJECTOR
SF−23
1996 RAV4 (RM447U)
INSTALLATION
1. INSTALL INJECTORS AND SPACERS
(a) Install new insulator and grommet to each injector.
(b) Apply a light coat of gasoline onto 2 new O−rings, and
install them to each injector.
(c) Place the 2 spacers in position on the cylinder head.
(d) Push in the 4 injectors to the cylinder head.
2. INSTALL DELIVERY PIPE AND FUEL INLET HOSE
(a) Place the delivery pipe together with the 2 bolts between
the intake manifold and cylinder head.
(b) While turning the injector left and right, push it to the deliv-
ery pipe.
(c) Temporarily install the 2 bolts holding the delivery pipe to
the cylinder head.
(d) Check that the injectors rotate smoothly.
HINT:
If injectors do not rotate smoothly, the probable cause is incor-
rect installation of O−rings. Replace the O−rings.
(e) Position the injector connector upward.
R06184
SR0FI−02
R09732
− STEERINGSTEERING WHEEL
SR−9
1996 RAV4 (RM447U)
STEERING WHEEL
INSPECTION
1. CHECK STEERING WHEEL FREEPLAY
With the vehicle stopped and tires facing straight ahead, rock
the steering wheel gently back and forth with light finger pres-
sure.
Freeplay should not exceed the maximum.
Maximum freeplay: 30 mm (1.18 in.)
2. CHECK STEERING EFFORT
(a) Center the steering wheel.
(b) Remove the steering wheel pad (See page SR−12).
(c) Start the engine and run it at idle.
(d) Measure the steering effort in both directions.
Reference: 5.9 N·m (60 kgf·cm, 52 in.·lbf)
HINT:
Be sure to consider the tire type, pressure and contact surface
before making your diagnosis.
(e) Torque the steering wheel set nut.
Torque: 34 N·m (350 kgf·cm, 25 ft·lbf)
(f) Install the steering wheel pad (See page SR−19).
