1996 Mercury Villager Owner's Manuals

Features
147
[FV08140(ALL)06/95]
If the batteries are removed for any reason other than
replacement, repeat the steps inReplacing the batteriesto test
your remote transmitter(s).
[FV08150(ALL)06/95]
n
An improperly disposed battery can hurt the environment.
Always confirm local regulations for battery disposal.
[FV08160(ALL)06/95]
n
The remote transmitter is waterproof; however, if it does get
wet, immediately wipe it completely dry.
[FV08170(ALL)06/95]
n
The operational range of the remote transmitter extends to
approximately 49 feet (15 meters) from the vehicle. This
range may vary with conditions.
*
[FV08175(ALL)06/95]
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
[FV08180(ALL)06/95]
Replacement/Additional Transmitters
[FV08190(ALL)07/95]
In the event a transmitter is lost or an additional remote
transmitter needs to be set, you must change the ID code.
Follow the steps below to change the ID code of your system,
or return the remaining transmitter(s) to your dealer for
reprogramming of your remote entry system. This is necessary
to prevent unauthorized use of the lost transmitter.
[FV08200(ALL)06/95]
ID Code Programming Procedure
[FV08210(ALL)06/95]
NOTE: All transmitters must be programmed (or
reprogrammed) at the same time. If the programming
mode is entered and the transmitters are not
programmed (or reprogrammed) at the same time, they
will not operate with the system.
[FV08220(ALL)06/95]1.
Enter vehicle and close and lock all doors.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

148
[FV08230(ALL)06/95]2.
Insert and remove key from ignition six times within ten (10)
seconds. The instrument panel lights will flash twice.
[FV08240(ALL)06/95]3.
Turn ignition key to the ACC position.
[FV08250(ALL)06/95]4.
Press the LOCK button on the remote transmitter once.
[FV08260(ALL)06/95]5.
To enter additional remote controllers (including the
original), unlock, then lock the driver's door using the power
door lock switch.
[FV08270(ALL)06/95]6.
Press the LOCK button on a new remote transmitter. The
instrument panel lights will flash twice, indicating code is
entered.
[FV08280(ALL)06/95]7.
Repeat steps 5 and 6 as needed (up to four remote
transmitters may be programmed).
[FV08290(ALL)06/95]
Anti-Theft System (If equipped)
[FV08300(ALL)06/95]
This system helps protect your vehicle against break-ins or theft
by monitoring all doors and the liftgate lock cylinder.
[FV08310(ALL)06/95]
When an unauthorized entry occurs, the system triggers and
will:
[FV08320(ALL)06/95]
n
flash the headlamps and hazard lamps
[FV08330(ALL)06/95]
n
honk the horn
[FV08340(ALL)06/95]
n
disable the starting circuit to prevent the vehicle from being
started
[FV08350(ALL)06/95]
To arm the system
[FV08360(ALL)06/95]1.
Remove the key from the ignition.
[FV08370(ALL)06/95]2.
Lock the doors by using either the power door lock switch
or by turning the key in either the driver or passenger door
lock cylinder. The parking lights will flash and the horn
chirps to let you know that the system has been armed. The
anti-theft indicator light on the right side of the steering
wheel will light and remain on.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

Features
149
[FV08375(ALL)06/95]
13-1/2 pica
art:0040329-A
Anti-theft indicator light
[FV08380(ALL)06/95]
NOTE: If your vehicle is equipped with a factory installed
keyless entry system or remote keyless entry system
(or both), the system can be armed by closing all the
doors and pressing the LOCK button on the remote
transmitter or by pressing the 7/8 and 9/10 buttons on
the keyless entry keypad.
[FV08390(ALL)06/95]3.
Close all doors. The anti-theft indicator light will stay on for
approximately 30 seconds and then flash once every 2.5
seconds.
[FV08400(ALL)06/95]
NOTE: Be sure to close all the doors completely. If the doors
are not completely closed, the alarm indicator light
will remain on steadily. The anti-theft system is
armed only when the anti-theft indicator light remains
on steadily for approximately 30 seconds after the last
door is closed, and then flashes every 2.5 seconds.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

150
[FV08410(ALL)06/95]
Disarming an untriggered anti-theft system
[FV08420(ALL)06/95]
Unlock either door with the door key or by pressing the
UNLOCK button on the remote keyless entry transmitter (if
equipped) or by entering your personal code on the keyles entry
keypad (if equipped). This will disarm the system. When you
unlock the door with the key, make sure you fully rotate the
key in the lock. If you do not, the system may not disarm, and
will trigger when a door is opened.
[FV08430(ALL)06/95]
If the system is armed and you remain in your vehicle, simply
insert the key into the ignition and turn it to ACC. This disarms
the system and allows you to open the door to exit without
triggering the system. Remember to rearm the system by using
the power door lock, the remote transmitter (if equipped), or
the keyless entry keypad (if equipped) to lock the doors.
[FV08440(ALL)06/95]
The remote keyless entry system is designed to work with the
factory installed anti-theft system. It may not work with other
anti-theft systems.
[FV08450(ALL)06/95]
Triggering the anti-theft system
[FV08460(ALL)06/95]
The armed system will be triggered if:
[FV08470(ALL)06/95]
n
any door is opened without using the door key, the keyless
entry keypad (if equipped), or the remote keyless entry
transmitter (if equipped)
[FV08480(ALL)06/95]
n
the liftgate is opened or unlocked
[FV08490(ALL)06/95]
n
the hood is opened
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

Features
151
[FV08500(ALL)06/95]
Disarming a triggered anti-theft system
[FV08510(ALL)06/95]
The alarm can be disarmed by using one of the following
methods:
[FV08520(ALL)06/95]
n
unlocking the driver or passenger doors
[FV08530(ALL)06/95]
n
unlocking the doors using the keyless entry keypad (if
equipped) or with the remote keyless entry transmitter (if
equipped)
[FV08540(ALL)06/95]
n
putting the key in the ignition and turning it to the ACC
position
[FV08550(ALL)06/95]
NOTE: The flashing lights and honking horn will shut off
automatically within 2 minutes 30 seconds after the
system is triggered. It will trigger again if another
intrusion occurs. However, the starter circuit remains
disabled until the system is disarmed.
[FV08560(ALL)06/95]
NOTE: Both remote keyless entry systems will only operate
with the ignition in the OFF position.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

152
*
[FV08600(ALL)06/95]
Liftgate
[FV08610(ALL)06/95]
Opening the Liftgate
[FV08620(ALL)06/95]
To unlock the liftgate with the key, insert the key into the lock
and turn it counterclockwise. To make the gate swing up to the
fully opened position, pull back and upward on the handle. The
liftgate will not unlock if the optional liftgate window is open.
[FV08630(ALL)06/95]
17-1/2 pica art:0040121-F
Opening the liftgate
[FV08640(ALL)06/95]
You can also unlock the liftgate using the optional power door
lock system, or the optional keyless entry system. However, it
cannot be opened until you release the latch by reaching under
the license plate light shield and lifting up on the handle.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

Features
153
[FV08670(ALL)06/95]
Opening the Liftgate Window (If equipped)
[FV08700(ALL)07/95]
To open the liftgate window only, turn the key clockwise. The
window unlatches and the rear wiper falls out of the way. Do
not force the wiper down by hand Ð it moves when the key is
turned. To close, push downward until it latches.
[FV08800(ALL)09/93]
13-1/2 pica
art:0040098-A
The liftgate window in the open position
[FV08900(ALL)01/93]
RWARNING
Never drive the vehicle with the liftgate window open.
Dangerous exhaust fumes can be drawn into the vehicle
with the window raised and the vehicle moving.
[FV09000(ALL)01/93]
Closing the Liftgate
[FV09100(ALL)01/93]
To close the liftgate, reach up and pull the handle on the inner
trim panel downward.
[FV09200(ALL)01/93]
When you have pulled down the liftgate enough so that you
can reach the license plate light shield, push the shield down
and forward to close the liftgate. At this point, the liftgate is not
locked.
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996

154
[FV09300(ALL)01/93]
The liftgate has an intermediate and a fully closed position.
Make sure the liftgate is fully closed before you drive your
vehicle.
[FV09400(ALL)09/93]
24 pica art:0040099-D
Locking the liftgate using the lock lever
File:08vxfvn.ex
Update:Mon Jun 3 14:49:33 1996