Page 118 of 2543

INTRODUCTIONGLOSSARY OF SAE AND TOYOTA TERMS -
IN-7
GLOSSARY OF SAE AND TOYOTA TERMS
This glossary lists all SAE-J1930 terms and abbreviations used in this manual in compliance with SAE
recommendations, as well as their Toyota equivalents.
SAE
ABBREVIATIONSSAE TERMSTOYOTA TERMS
( )--ABBREVIATIONS
A/CAir ConditioningAir Conditioner
ACLAir CleanerAir Cleaner
AIRSecondary Air InjectionAir Injection (AI)
APAccelerator Pedal-
B+Battery Positive Voltage+B, Battery Voltage
BAROBarometric Pressure-
CACCharge Air CoolerIntercooler
CARBCarburetorCarburetor
CFIContinuous Fuel Injection-
CKPCrankshaft PositionCrank Angle
CLClosed LoopClosed Loop
CMPCamshaft PositionCam Angle
CPPClutch Pedal Position-
CTOXContinuous Trap Oxidizer-
CTPClosed Throttle Position-
DFIDirect Fuel Injection (Diesel)Direct Injection (DI)
DIDistributor Ignition-
DLC1
DLC2
DLC3Data Link Connector 1
Data Link Connector 2
Data Link Connector 31: Check Connector
2: Toyota Diagnosis Communication Link (TDCL)
3: OBD II Diagnostic Connector
DTCDiagnostic Trouble CodeDiagnostic Code
DTMDiagnostic Test Mode-
ECLEngine Control Level-
ECMEngine Control ModuleEngine ECU (Electronic Control Unit)
ECTEngine Coolant TemperatureCoolant Temperature, Water Temperature (THW)
EEPROMElectrically Erasable Programmable Read Only
MemoryElectrically Erasable Programmable Read Only Memory
(EEPROM),
Erasable Programmable Read Only Memory(EPROM)
EFEEarly Fuel EvaporationCold Mixture Heater (CMH), Heat Control Valve (HCV)
EGRExhaust Gas RecirculationExhaust Gas Recirculation (EGR)
EIElectronic IgnitionToyota Distributorless Ignition (TDI)
EMEngine ModificationEngine Modification (EM)
EPROMErasable Programmable Read Only MemoryProgrammable Read Only Memory (PROM)
EVAPEvaporative EmissionEvaporative Emission Control (EVAP)
FCFan Control-
FEEPROMFlash Electrically Erasable Programmable
Read Only Memory-
FEPROMFlash Erasable Programmable Read Only Memory-
FFFlexible Fuel-
FPFuel PumpFuel Pump
GENGeneratorAlternator
GNDGroundGround (GND)
HO2SHeated Oxygen SensorHeated Oxygen Sensor (HO2S)
IN016-02
Page 711 of 2543
A/C noise.Whining noise occurs when A/C is operating.
Fuel gauge noise.
NoiseNOISE PRODUCED WHEN ENGINE STARTS
Whistling noise which becomes high±pitched
when accelerator strongly depressed, disap-
pears shortly after engine stops.
Clicking sound heard when horn button is
pressed, then released. Whirring/grating sound
when pushed continuously.
Scratching noise occurs during sudden accelera-
tion, driving on rough roads or when ignition
switch is turned on.
Alternator noise.
Horn noise.
Ignition noise.
Turn signal noise.
Washer noise.
Murmuring sound, stops when engine stops.
Tick±tock noise, occurs in co±ordination with
blinking of flasher.
Noise occurs during window washer operation.
Scraping noise in time with wiper beat.
Scratching noise occurs while engine is running,
continues a while even after engine stops.
Other type of noise.
Engine coolant temp. gauge noise.
Wiper noise.
± BODY ELECTRICAL SYSTEMAUDIO SYSTEMBE±109
Page 1038 of 2543
1. Check that the battery cables are connected to the correct terminals.
2. Disconnect the battery cables when the battery is given a quick charge.
3. Do not do these tests with a high voltage insulation resistance tester.
4. Never disconnect the battery while the engine is running.
PREPARATION
SST (SPECIAL SERVICE TOOLS)
Injection Pump Camshaft Bearing
Cone Replacer
Front Hub & Drive Pinion Bearing
Tool Set
Replacer
Alternator Rear Bearing Puller
Alternator Rear Bearing Replacer
Alternator Pulley Set Nut Wrench
Set
Puller B Set
Rotor rear bearing cover
Rotor front bearing
Rotor rear bearing
Rectifier end frame
RECOMMENDED TOOLS
TOYOTA Electrical Tester Set
Engine Adjust Kit
CH±2± CHARGING SYSTEMPREPARATION
Page 1206 of 2543

GLOSSARY OF SAE AND TOYOTA TERMS
This glossary lists all SAE±J1930 terms and abbreviations used in this manual in compliance with SAE
recommendations, as well as their Toyota equivalents.
SAE ABBREVI±
ATIONS
SAE TERMS
TOYOTA TERMS
( ) ±± ABBREVIATIONS
A/C Air Conditioning Air Conditioner
ACL Air Cleaner Air Cleaner
AIRSecondary Air InjectionAir Injection (AI) AP Accelerator Pedal ± B+ Battery Positive Voltage +B, Battery Voltage BARO Barometric Pressure ±
CAC Charge Air Cooler Intercooler
CARB Carburetor Carburetor
CFI Continuous Fuel Injection ±
CKP Crankshaft Position Crank Angle
CLClosed LoopClosed Loop CMP Camshaft Position Cam Angle CPP Clutch Pedal Position ±
CTOX Continuous Trap Oxidizer ±
CTP Closed Throttle Position Idle ON (IDL ON)
DFI Direct Fuel Injection (Diesel) Direct Injection (DI)
DI Distributor Ignition ±
DLC1
DLC2
DLC3
Data Link Connector 1
Data Link Connector 2
Data Link Connector 3
1: Check Connector
2: Toyota Diagnosis Comunication Link (TDCL)
3: OBD II Diagnostic Connector
DTC Diagnostic Trouble Code Diagnostic Code
DTM Diagnostic Test Mode ±
ECL Engine Control Level ±
ECM Engine Control Module Engine ECU (Electronic Control Unit)
ECT Engine Coolant Temperature Coolant Temperature, Water Temperature
(THW)
EEPROM
Electrically Erasable Programmable Read Only
Memory
Electrically Erasable Programmable Read Only
Memory (EEPROM),
Erasable Programmable Read Only Memory
(EPROM)
EFE
Early Fuel Evaporation
Cold Mixture Heater (CMH), Heat Control Valve
(HCV)
EGRExhaust Gas RecirculationExhaust Gas Recirculation (EGR) EI Electronic Ignition Toyota Distributorless Ignition (TDI) EM Engine Modification Engine Modification (EM) EPROM Erasable Programmable Read Only Memory Programmable Read Only Memory (PROM)
EVAP Evaporative Emission Evaporative Emission Control (EVAP)
FC Fan Control ±
FEEPROM Flash Electrically Erasable Programmable
Read Only Memory ±
FEPROM
Flash Erasable Programmable Read Only
Memory
±
FF Flexible Fuel ±
FP Fuel Pump Fuel Pump
GEN Generator Alternator
GND Ground Ground (GND)
HO2SHeated Oxygen SensorHeated Oxygen Sensor (HO2S)
± INTRODUCTIONGLOSSARY OF SAE AND TOYOTA TERMSIN±39
Page 1620 of 2543
PREPARATION
SST (SPECIAL SERVICE TOOLS)
Injection Pump Spline Shaft
Puller
Alternator Rear Bearing Replacer
Armature bearing
Armature front bearing
RECOMMENDED TOOLS
TOYOTA Electrical Tester Set
EQUIPMENT
Dial indicator Commutator Magnetic finger Steel ball
Pull scale
Brush spring
Sandpaper Commutator
Torque wrench
V±block Commutator
Vernier calipers Commutator, Brush
ON±VEHICLE INSPECTION
NOTICE: Before changing the starter, check the following items again:
wConnector connection
wAccessory installation, e.g.: theft deterrent system
ST±2± STARTING SYSTEMPREPARATION