1995 CHEVROLET BLAZER Owners Manual

Downloaded from www.Manualslib.com manuals search engine To increase your speed in very small amounts, move the switch to R/A
(Resume/Accelerate). Each time you do this, your vehicle will go about 1
mph (1.6 kdh) faster.
To Reduce Speed While Using Cruise Control
Push in the button at
the end
of the lever
until you reach the
lower speed you want,
then release it.
To slow down in very small amounts, push the button for less than half a
second. Each time you do this, you'll go 1 mph (1.6 kdh) slower.
Passing Another Vehicle While Using Cruise Confrol
Use the accelerator pedal to increase your speed. When you take your foot
off the pedal, your vehicle will slow down to the Cruise Control speed you
set earlier.
2-45

Downloaded from www.Manualslib.com manuals search engine Using Cruise Control on Hills
How well your Cruise Control will work on hills depends upon your speed,
load, and the steepness of the hills. When going up steep hills, you may
want to step on the accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear to keep your speed
down. Of course, applying the brake takes you out of Cruise Control. Many
drivers find this to be too much trouble and don’t use Cruise Control on
steep hills.
To Get Out of Cruise Control
There are two ways to turn off the Cruise Control:
r
Step lightly on
the brake pedal
or
push the clutch
pedal,
if you have
a manual
transmission.
Move the Cruise
switch to
OFF.
To Erase Speed Memory
When you turn off the Cruise Control or the ignition, your Cruise Control
set speed memory
is erased.
2-46

Downloaded from www.Manualslib.com manuals search engine Lamps
Push the top switch with the parking lamps symbol
Parking Lamps
0 Sidemarker Lamps
0 Taillamps
0 License Plate Lamps
0 Instrument Panel Lamps Your
switches are
on
the driver’s side of
your instrument panel.
on it
to turn on:
Transfer Case Indicator Light (if you have one)
Push the bottom switch with the master lighting symbol
on it to turn on all
the lamps listed above as well as the headlamps.
Push the side
of the switch marked OFF to turn off your lamps.
Turn the switch next to the headlamp switch up to make your \
instrument panel and transfer case lights brighter. Turn the switch all the way up to turn
on the interior lamps.
You can switch your headlamps from high to low beam by pulling on the
multifunction lever.
A circuit breaker protects your headlamps. If you have an electrical
overload, your headlamps will flicker on and
off. Have your headlamp
wiring checked right away if this happens.
2-47

Downloaded from www.Manualslib.com manuals search engine Fog Lamps (Option)
Use your fog lamps
for better vision in
foggy or misty
conditions. Your
parking lights and/or
low beam headlamps
must be on or your
fog lamps won’t work.
The fog lamp switch is on the instrument panel under the INT
LIGHTS
switch I
$0 OFF-
FOG LAMPS
Press the side of the
switch with the light
to turn the fog lamps
on, and OFF
to turn
them
off. A light will
glow
in the switch
when the fog lamps
are on.
Remember, fog lamps alone will not give
off as much light as your
headlights.
Never
use your fog lamps in the dark without turning on your headlights.
Fog lamps will
go off whenever your high beam headlamps come on. When
the high beams go
off, the fog lamps will come on again.
2-48

Downloaded from www.Manualslib.com manuals search engine Daytime Running Lamps (DRL) Indicator Light
You may have this
light on the instrument
panel. It goes on whenever the Daytime
Running Lamps are
on, the ignition is on,
the headlamp switch is
off, and the parking
brake is released.
Daytime Running Lamps
Vehicles sold in the United States may or may not have this feature. DRL is
required on new vehicles sold in Canada.
The high beam headlamps will come on at reduced brightness in daylight
when:
0 The ignition is on,
0 The headlamp switch is off, and
The parking brake is released.
When you turn on your headlamps, the DRL will switch
off and the exterior
lights will come
on. When you turn off the headlamps, the exterior lights
will go out and the high beams will change to the reduced brightness
of
DRL again.
The
DRL indicator light on the instrument panel will go on whenever the
DRL is
on. This light means that only the DRL is on. When you turn on
your exterior lights, this light will go out.
If the DRL indicator light is on at dawn or dusk, it is a reminder to turn on
your headlamps.
Of course, you may still turn on the headlamps any time you need to.
To idle your vehicle with the
DRL, off, set the parking brake. The DRL will
stay
off until you release the parking brake.
Headlamps-On Reminder
A reminder tone will sound when your headlamps or parking lamps are
turned on and your ignition is in OFF, LOCK or ACC. To turn the tone off,
press the OFF switch.
2-49

Downloaded from www.Manualslib.com manuals search engine Dome Lamps
The interior lights will
come on when the
front door handles are
lifted or the side doors
are opened. They will
remain
on for
approximately
30
seconds or until the
ignition is turned
on.
You can also turn the dome lamp on by turning the INT LIGHTS dimmer
switch up until it clicks.
The rear dome lamp has a switch that lets
you turn it on from the rear of the
vehicle.
Press the side
of the
switch with the light
symbol to turn
on the
front and rear dome
lamps. Pressing the
other side
of the
switch will turn all
interior lights off,
even when the endgate
and doors are open.
2-50

Downloaded from www.Manualslib.com manuals search engine Inside Mirror
Press the tab under the
mirror to reduce glare
from headlamps
behind
you.
If your vehicle has the lighted mirror, the lights will automatically come on
for approximately
15 seconds when either front door is opened, or until the
ignition is turned to
RUN or ACC. The lights will also stay on for
approximately
15 seconds after you exit the vehicle.
They will also stay
on for 15 seconds when the interior light switch on the
dash is turned on then
off, while the ignition is off.
You can also turn me
mirror lights on and
off by pressing the
switch near each light.
2-51

Downloaded from www.Manualslib.com manuals search engine Outside Mirrors
Adjust your outside mirrors
so you can
just see
the side of
your vehicle.
Some mirrors are manually adjustable, and
some mirrors come with an
optional remote control adjustment switch. Find the switch
on the driver’s
door armrest.
Turn the knob in the
switch
to L or R to
choose the mirror,
then press the arrows
on the outside switch
ring to adjust the mirror.
If you have the manually adjustable mirror, you can fold it before entering a
canvash. To fold, pull the mirrors in towards the vehicle. Push the mirrors
back out when finished.
2-52