Page 185 of 323

Parking on Hills
You really should not park your vehicle,
with a trailer attached, on a hill. If
something goes wrong, your rig could
start to move. People can be injured,
and both your vehicle and the trailer can
be damaged.
But if you ever have to park your rig on
a hill, here’s how to do it:
1 . Apply your regular brakes, but don’t
shift into
P (Park) yet.
2. Have someone place chocks under
the trailer wheels.
3. When the wheel chocks are in place,
release the regular brakes until the
chocks absorb the load.
apply your parking brake, and then shift to
P (Park).
4. Reapply the regular brakes. Then
5. Release the regular brakes.
When You Are Ready to Leave After
Parking on a Hill
1. Apply your regular brakes and hold
the pedal down while you:
Start your engine;
Shift into a gear; and
Release the parking brake.
2. Let up on the brake pedal.
3. Drive slowly until the trailer is clear
4. Stop and have someone pick up and
of the chocks.
store the chocks.
Maintenance When Trailer
Towing
Your vehicle will need service more
often when you’re pulling a trailer. See
the Maintenance Schedule for more on
this. Things that are especially
important in trailer operation are
automatic transaxle fluid (don’t overfill)
engine oil, belts, cooling system, and
brake adjustment. Each
of these is
covered in this manual, and the
Index
will help you find them quickly. If
you’re trailering, it’s a good idea to
review these sections before you
start
your trip.
Check periodically
to see that all hitch
nuts and bolts are tight.
183
ProCarManuals.com
Page 186 of 323
dotes
n
4'
ProCarManuals.com
Page 187 of 323
.....
Here you'll find what to do about
some problems that
can occur on the
road .
Part 5
Problems on the Road
Hazard Warning Flashers .... ............................... 186
Jumpstarting .................................................... 187
Towing Your Oldsmobile ........................................... 191
Engine Overheating ............................................... 195
If a Tire Goes Flat ................................................ 203
ChangingaFlatTire
.............................................. 204
Compact Spare Tire
............................................... 212
If You're Stuck: In Sand, Mud. Ice or Snow ............................ 213
ProCarManuals.com
Page 188 of 323
Problems on the Road
I
Hazard Warning Flashers
Your hazard warning flashers let you
warn others. They
also let police know
you have a problem. Your front and rear
turn signal lights will flash on and off.
But they won’t flash if you’re braking. Your
hazard warning flashers switch is
on the steering column below the
ignition switch. Press the button in to
make your front and rear turn signal
lights flash on and off.
Your hazard warning flashers work no
matter what position your key is in, and
even if the key isn’t in.
L
To turn off the flashers, pull out on the
collar.
When the hazard warning flashers are
on, your turn signals won’t work.
Other Warning Devices
If you carry reflective triangles, you can
set one up at the side of the road about
300 feet (100 m) behind your vehicle.
ProCarManuals.com
Page 189 of 323
Jump Starting
If your battery has run down, you may
want to use another vehicle and some
jumper cables to start your Oldsmobile.
But please follow the steps below to do
it safely.
MU I IUIV
I; Batteries can hurt you. They
h can be dangerous because:
They contain acid that can burn
They contain gas that can
They contain enough electricity
If you don’t follow these steps
exactly, some or all
of these things
can hurt you.
you.
explode
or ignite.
to burn you. Ignoring
these steps could result in
costly damage to your vehicle that
wouidn’t becovered by your
warranty.
Trying to start your Oldsmobile
b
pushing or pulling it won’t work,
and it could damage your vehicle
To Jump Start Your Oldsmobile:
1. Check the other vehicle. It must have
a 12-volt battery with a negative
ground system.
ProCarManuals.com
Page 190 of 323
Problems on the Road
i
I
I
I
I88
Jump Starting (CONT.)
2. Get the vehicles close enough so the
jumper cables can reach, but be sure
the vehicles aren’t touching each other.
If they are, it could cause a
ground connection you don’t want.
You wouldn’t be able to start your
Oldsmobile, and the bad grounding
could damage the electrical systems.
You could be injured
if the
L vehicles roll. Set the parking
brake
firmly on each vehicle. Put
an automatic transaxle in
P (Park)
or a manual transaxle
in N (Neutral).
3. Turn off the ignition on both
vehicles.
Turn off all lights that aren’t
needed, and radios.
This will avoid
sparks and help save both batteries.
And it could save your radio!
4. Open the hoods and locate the
batteries.
r An electric fan can start up
even when the engine is not
I
I uming and can injure you. Keep
hands, clothing and tools away
from any underhood electric fan.
Find the positive
(+) and negative
(-) terminals on each battery.
ProCarManuals.com
Page 191 of 323

Your Oldsmobile has a remote positive
(+) jump starting terminal. The terminal
is in the red box on the same side
of the
engine compartment as your battery.
You should always use the remote
positive
(+) terminal instead of the
positive
(+) terminal on your battery.
To open the remote positive (+)
terminal box, pull the tab and open the
cover.
A
Using a match near a battery
can cause battery gas to
explode. People have been
hurt
doing this, and some have been
blinded. Use a flashlight if you
need more light.
You don’t need to add water to the
Delco Freedom@ battery installed
in every new
GM vehicle. But if a
battery has filler caps, be sure the
right amount of fluid is there. If
it
is low, add water to take care of
that first. If you don’t, explosive
gas could be present.
Battery fluid contains acid that can
bum you. Don’t get it on
you. If
you accidentally get it in your eyes
or
on your skin, flush the place
with water and get medical help
immediately.
5. Check that the jumper cables don’t
have loose or missing insulation. If
they do, you could get a shock. The
vehicles could be damaged, too.
Before you connect the cables, here are
some things you should know. Positive
(+) will go to positive (+) and negative
(-) will go to negative (-) or a metal
engine part. Don’t connect
(+) to (-) or
you’ll get a short that would damage the
battery and maybe other parts, too.
Fans
or other moving engine
parts can injure you badly.
Keep your hands away bm
moving parts once the engines are
running. I
I89
ProCarManuals.com
Page 192 of 323
Jump Starting (CONT.)
6. Connect the red positive (+) cable to
the positive
(+) terminal of the
vehicle with the dead battery. Use a
remote positive
(+) terminal if the
vehicle has one.
0
7. Don’t let the other end touch metal.
Connect
it to the positive (+)
terminal of the good battery. Use a
remote positive (+) terminal if the
vehicle has one.
8. Now connect the black negative (-)
cable to the good battery’s negative
(-) terminal.
Don’t let the other end touch anything
until the next step. The other end
of the
negative cable
doesn’t go to the dead
battery. It goes to a heavy unpainted metal part on the engine of the vehicle
with the dead battery.
9. Attach the cable at least 18 inches
(45 cm) away from the dead battery,
but not near engine parts that move.
The electrical connection is just as
good there, but the chance of sparks
getting back to the battery is much
less.
ProCarManuals.com