15 INTRODUCTION
69G15X-005
5BU15X-003
Inspection note
When checking the continuity or voltage with a cir-
cuit tester, insertion of the test probe into the recep-
tacle connector may open the fitting of the connector
and result in poor contact.
Therefore, insert the test probe only from the wire har-
ness side.
Replacement of Terminal
Use the appropriate tools to remove the terminal, as
shown in the figure.
When installing a terminal, be sure to press it in until
it locks securely.
< Female Type No.1 >
Insert a push-tool or thin piece of metal from the ter-
minal side of the connector, and then, with the lock-
ing tabs of the terminal pressed down, pull the
terminal out from the rear side.
< Female Type No.2>
5BU15X-004
Same as the female type.
47U15X-012
15—4