1986 TOYOTA CAMRY V20 power steering fluid

(d) Coat the teflon rings with power steering fluid, and
carefully slide the tapered end of SST over the teflon
rings to seat the rings.
SST 09631±20081(c) Install the expanded teflon rings to the control valve
and snug them down with your fingers.
NOTICE: Be careful not to damage the rings.
6. IF NECESSARY, REPLACE UNION SEAT
(a) Using a screw extractor, remove the union seat.
(b) Using a plastic hammer and extension bar, tap in a
new union seat.
± STEERINGPower Steering (Gear Housing)SR±57

3. INSTALL RACK
(a) Install SST to the rack.
HINT: if necessary, scrape the burrs off the rack teeth end
and burnish.
SST 09631±20051 2. INSTALL CYLINDER HOUSING OIL SEAL AND
SPACER
Install a new oil seal and spacer to SST, and drive them
in with a plastic hammer.
SST 09631±12020, 09631±32010
ASSEMBLY OF GEAR HOUSING
(See page SR±51)
1. COAT POWER STEERING FLUID OR GREASE ON
FOLLOWING PARTS:
± STEERINGPower Steering (Gear Housing)SR±58

5. AIR TIGHTNESS TEST
(a) Install SST to the union of the cylinder housing.
SST 09631±12070
(b) Apply 400 mm Hg (15.75 in. Hg, 53.3 kPa) of vacuum
for about 30 seconds.
(c) Check that there is no change in the vacuum. 4. INSTALL CYLINDER END STOPPER, OIL SEAL AND
SPACER
(a) To prevent oil seal lip damage, wind vinyl tape on the
steering rack end, and apply power steering fluid.
(b) Install the oil seal by pushing it into the cylinder in the
direction shown in drawing, without tilting.
(c) Install the spacer and cylinder end stopper.
(d) Using SST, drive in the cylinder end stopper.
SST 09612±22011(b) Coat SST with power steering fluid.
(c) Insert the rack into the cylinder.
(d) Remove SST.
(e) Using snap ring pliers, install the snap ring.
± STEERINGPower Steering (Gear Housing)SR±59

9. INSTALL BEARING GUIDE NUT
(a) Apply sealant to 2 or 3 threads of the guide nut.
Sealant: Part No.08833±00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(b) Using SST, torque the bearing guide nut.
SST 09612±24014 (09612±10022)
Torque: 150 kg±crn (11 ft±Ib, 15 N±m)
7. INSTALL CONTROL VALVE HOUSING
(a) Align the matchmarks on the valve housing and rack
housing.
(b) Torque the two bolts.
Torque: 315 kg±cm (23 ft±Ib, 31 N±m)
(c) Using SST and torque meter, loosen the bearing
guide nut until the preload is within specification.
SST 09612±24014 (09612±10022), 09616±00014
Preload (tuming): 4.5 ± 6.5 kg±cm
(3.9 ± 5.6 in.±Ib, 0.4 ± 0.6 N±m) 6. INSTALL CONTROL VALVE
(a) Coat the teflon ring with power steering fluid.
(b) Push the control valve into the housing.
8. INSTALL CONTROL VALVE LOWER BEARING
± STEERINGPower Steering (Gear Housing)SR±60