2020 TOYOTA PRIUS C Owners Manual

972. Instrument cluster
2
Instrument cluster
PRIUS c_U
The indicators inform the driver of the operating state of the vehicle’s
various systems.
Indicators
Turn signal indicator
( P. 206) EV drive mode indicator
(
P. 199)
Headlight high beam
indicator ( P. 208)
Shift position indicator
(P. 203)
(U.S.A.)
Headlight indicator
(P. 208) “ECO MODE” indicator
(
P. 203)
(Canada)
Tail light indicator
(P. 208)EV drive indicator lamp
(P. 78)
(if equipped)
Front fog light indicator
(P. 212)
(if equipped)
Cruise control indicator
(P. 251)
*1Automatic High Beam
indicator ( P. 246)
(if equipped)
Cruise control set indica-
tor (P. 251)
(if equipped)
Immobilizer system indi-
cator (P. 88)*1, 2
Slip indicator ( P. 266)
*1VSC OFF indicator
(P. 267)
LDA indicator
(P. 241)
“READY” indicator
( P. 188, 192)
*1, 3PCS warning light
(P. 231)
“AIR BAG
ON/OFF” indi-
cator
(P. 52)*1
“AIR BAG
ON/OFF” indi-
cator
(P. 52)*1
(U.S.A.)
(Canada)

982. Instrument cluster
PRIUS c_U
*1: These lights turn on when the power switch is turned to the “ON” position
(vehicles without a smart key system) or the power switch is tu rned to ON
mode (vehicles with a smart key system) to indicate that a system check is
being performed. They will turn off after the hybrid system is on, or after a
few seconds. There may be a malfunction in a system if a light does not
come on, or turn off. Have the vehicle inspected by your Toyota dealer.
*2: The light flashes to indicate that the system is operating.
*3: This light turns on when the system is off.
*4: When the outside temperature is approximately 37°F (3°C) or lo wer, the
indicator will flash for approximately 10 seconds, then stay on .
*4Low outside tempera-
ture indicator (P. 99)
WARNING
■If a safety system warning light does not come on
Should a safety system light suc h as the ABS or SRS warning lig ht not
come on when you start the hybrid system, this could mean that these sys-
tems are not available to help protect you in an accident, whic h could result
in death or serious injury. Have the vehicle inspected by your Toyota dealer
immediately if this occurs.

992. Instrument cluster
2
Instrument cluster
PRIUS c_U
The units used on the meters may differ depending on the target
region.Speedometer
Displays the vehicle speed.
Shift position display
Displays the selected shift position. ( P. 202)
Outside temperature
Displays the outside temperature within the range of -40°F (-40 °C) to
122°F (50°C). Low outside temperat ure indicator comes on when the
ambient temperature is 37°F (3°C) or lower.
Clock
Change the time on the settings screen. ( P. 1 0 8 )
Multi-information display
Presents the driver with a variety of driving-related data. ( P. 103)
Fuel gauge
Displays the quantity of fuel remaining in the tank.
Odometer/trip meter
P. 1 0 0
Average fuel consumption
Depending on whether the odometer or trip meter is displayed, t he
displayed contents differ. Use the displayed average fuel consu mp-
tion as a reference.
● When the odometer is displayed: the average fuel consumption
since the hybrid system was started is displayed.
Gauges and meters
1
2
3
4
5
6
7
8

1002. Instrument cluster
PRIUS c_U
●When the trip meter is displaye d: the average fuel consumption
since the trip meter was reset is displayed. The average fuel c on-
sumption for trip meter A and trip meter B is displayed separat ely.
When the trip meter is reset, average fuel consumption is also reset.
( P. 100)
◆Changing the display
Items in this area are operated using the “TRIP” switch.
Press: Change displayed item
Each time the switch is pressed,
the displayed item will be
changed.
Press and hold: Reset
Display the desired trip meter
and press and hold the switch to
reset the trip meter.
◆Display items
■Odometer
Displays the total distance the vehicle has been driven.
■Trip meter A/trip meter B
Displays the distance the vehicl e has been driven since the met er
was last reset. Trip meters A and B can be used to record and d is-
play different distances independently.
To reset, display the desired trip meter and press and hold the “TRIP”
switch.
Odometer/trip meter

1012. Instrument cluster
2
Instrument cluster
PRIUS c_U
The brightness of the instrument panel lights can be adjusted by turn-
ing the dial.
Brighter
Darker
■The meters and multi-informat ion display illuminate when
Vehicles without a smart key system
The power switch is in the “ON” position.
Vehicles with a smart key system
The power switch is in ON mode.
■ The brightness of the instrument panel lights
When the tail lights are turned on, the brightness will be redu ced slightly
unless the control dial is turned up fully.
■ Outside temperature display
●In the following situations, the correct outside temperature ma y not be dis-
played, or the display may take longer than normal to change.
• When stopped, or driving at low speeds (less than 16 mph [25 k m/h])
• When the outside temperature has changed suddenly (at the entr ance/
exit of a garage, tunnel, etc.)
● When “ ” or “E” is displayed, the system may be malfunctioning.
Take your vehicle to your Toyota dealer.
■ Engine speed
On hybrid vehicles, engine speed is precisely controlled in ord er to help
improve fuel efficiency and reduce exhaust emissions etc.
There are times when the engine speed that is displayed may dif fer even
when vehicle operation and driving conditions are the same.
■ Unit of measure of the sp eedometer (on some models)
P. 108
Instrument panel light control
1
2

1022. Instrument cluster
PRIUS c_U
NOTICE
■To prevent damage to the engine and its components
This vehicle is not installed with an engine coolant temperatur e gauge.
Instead, is shown on the multi-information display. The engine may
be overheating if is shown on the multi-information display. I n this
case, immediately stop the vehicle in a safe place. ( P. 529)

1032. Instrument cluster
2
Instrument cluster
PRIUS c_U
The multi-information display presents the driver with a variety of driv-
ing-related data including the current outside air temperature.
● Drive information
Displays information such as the
hybrid system operating condi-
tions and fuel consumption.
●Settings and screen off
Perform operations such as chang-
ing the date/time and screen set-
tings.
●Warning messages ( P. 4 8 8 )
Automatically displayed if a malfunction occurs in one of the vehicle’s sys-
tems.
● Menu icons
Select a menu icon to display its content.
Drive information ( P. 104)
Select to display various drive data.
ECO ( P. 104)
Displays the fuel consumption information.
LDA (Lane Departure Alert) operational status ( P. 241)
Select to display the operational status of the LDA.
Settings display ( P. 108)
Select to change the meter display settings and other settings.
Multi-infor mation display
Display contents

1042. Instrument cluster
PRIUS c_U
◆Operating the meter control switches
The multi-information display is operated using the meter control
switches.
: Select menu icons
: Change displayeditem, scroll up/down
the screen and
move the cursor up/
down
Enter switch
Press: Enter/Set
Press and hold: Reset
Return to the previous screen
◆Drive Information
Depending on whether the odometer or trip meter is displayed, t he
displayed contents of average speed, driving time, and EV drivi ng
rate/EV driven distance differ.
● When the odometer is displayed: the record since the hybrid sys -
tem was started is displayed.
● When the trip meter is displayed: the record since the trip met er
was reset is displayed. The record for trip meter A and trip me ter
B is displayed separately.
When the trip meter is reset, the record is also reset. ( P. 100)
■
(average speed)
Average speed will be displayed.
■ (driving time)
Driving time will be displayed.
■ (EV driving rate/EV driven distance)
EV driving rate and driven distance (percentage and distance
driven using just the electric motor [traction motor] only) wil l be dis-
played.
1
2
Driving information
3
AV G