2020 MAZDA MODEL CX-5 Owners Manual (in English)

Page 585 of 714

MAZDA MODEL CX-5 2020  Owners Manual (in English) 7If Trouble Arises
Helpful information on what to do if a problem arises with the vehicle.
Parking in an Emergency................. 7-2 Parking in an Emergency..............7-2
Flat Tire..............

Page 586 of 714

MAZDA MODEL CX-5 2020  Owners Manual (in English) Parking in an Emergency
The hazard warning lights should always
be used when you stop on or near a
roadway in an emergency.
 
The hazard warning lights warn other
drivers that your vehicle is a traffi

Page 587 of 714

MAZDA MODEL CX-5 2020  Owners Manual (in English) Spare Tire and Tool Storage
Spare tire and tools are stored in the locations illustrated in the diagram.
Tiedown eyelet Flat tire hold-down bolt
Jack lever
Lug wrench Spare tire
Jack
Type A
Type B
Spa

Page 588 of 714

MAZDA MODEL CX-5 2020  Owners Manual (in English) ▼Jack
To remove the jack
1. Open the luggage board, and lift it.
2. Remove the jack.
To secure the jack
Perform the removal procedure in reverse.
Maintenance
Always keep the jack clean.
Make s

Page 589 of 714

MAZDA MODEL CX-5 2020  Owners Manual (in English) Do not use a tire chain on this tire
because it will not fit properly.
 Do not use your temporary spare tire
on any other vehicle, it has been
designed only for your Mazda.
 Use only one temp

Page 590 of 714

MAZDA MODEL CX-5 2020  Owners Manual (in English) hold-down bolt counterclockwise and
remove the spare tire.
Spare tire hold-down bolt
To secure the spare tire
Store the spare tire in the reverse order of
removal. After storing, verify that the
spare

Page 591 of 714

MAZDA MODEL CX-5 2020  Owners Manual (in English) 2. Put a vehicle with an automatictransaxle in Park (P), a manual
transaxle in Reverse (R) or 1, and turn
off the engine.
3. Turn on the hazard warning flasher.
4. Have passengers get out of the vehic

Page 592 of 714

MAZDA MODEL CX-5 2020  Owners Manual (in English) not remove any lug nuts until the tire
has been raised off the ground.
 
3. Place the jack on the ground.
4. Turn the jack screw in the directionshown in the figure and adjust the jack
head so that it