2020 CITROEN C5 AIRCROSS DAG Handbook (in English)

23
+
+Hill start assist
Fixed. The system has a fault.
Carry out (3).
Power steering Fixed. The power steering has a
fault.
Drive carefully at moderate speed, then carry out (3).
Stop & Star tFixed, accompanied
by the display of
a


message. The Stop & Start system is
deactivated.
The engine will not switch off at the next traffic stop.
Press the button to reactivate the Stop & Start.
Warning/indicator lamp
StateCause Actions/Observations
Green warning/indicator lamps
Stop & Star tFixed.When the vehicle stops, the Stop &
Start puts the engine into STOP mode.
Flashing temporarily. STOP mode is momentarily
unavailable or START mode is
automatically triggered.
(1) : You must stop as soon as it is safe to do
so and switch off the ignition. (3)
: Go to a
CITROËN dealer or a qualified
workshop.
(2): Contact a
CITROËN dealer or a qualified
workshop.
1
Instruments

24
Warning/indicator lampStateCause Actions/Observations
Park Assist Fixed. The function is active.
Active Lane
Keeping Assist Fixed.
The function has been activated. All the conditions have been met: the system is
operating.
Direction
indicators Flashing with audible
signal. The direction indicators are on.
Sidelamps Fixed. The lamps are on.
Dipped beam
headlamps Fixed.
The lamps are on.
+
or Automatic
headlamp
dipping
Fixed.
The function has been activated in
the touch screen (Driving/Vehicle
m e n u).
The lighting control stalk is in the
"AUTO" position.
Instruments

25
Front foglampsFixed. The front foglamps are on.
Automatic
wiping Fixed.
Automatic front wiping is activated.
Blue warning/indicator lamps
Main beam
headlampsFixed.
The main beams are on.
Warning/indicator lamp
StateCause Actions/Observations
Black/white warning/indicator lamps
(grey)Hill Assist
Descent
Fixed.
The function has been activated,
but is currently paused because the
speed is too high. Reduce the vehicle speed to below 19 mph (30 km/h).
1
Instruments

26
Indicators
Service indicator
The ser vice indicator is displayed on the instrument panel. Depending on the vehicle version:
- t he distance recorder display line indicates the distance remaining before the next ser vice is
due, or the distance travelled since it was due preceded by the sign "-".
-

a
n alert message indicates the distance remaining, as well as the period before the next ser vice
is due or how long it is overdue.
Warning/indicator
lamp State
CauseActions/
Observations
Ser vice
spanner Lights up temporarily
when the ignition is
switched on.
Between 620 and
1 ,860 miles (1,000 and
3,000
km) remain before
the next ser vice is due.
Fixed, when the
ignition is switched
on. The ser vice is due in
less than 620
miles
(1,000


km).Have your vehicle
serviced very soon.
+ Ser vice
spanner
flashing
Flashing then fixed, when
the ignition is switched on.
(With BlueHDi Diesel
engines, associated
with the Ser vice warning
lamp).The servicing interval
has been exceeded.
Have your vehicle
ser viced as soon as
possible.
Resetting the service indicator
The ser vice indicator must be reset after each
service.
If you have carried out the ser vice on your
vehicle yourself:
F

s
witch off the ignition,
F

p
ress and hold this button,
F

s
witch on the ignition; the distance recorder
display begins a


countdown,
F

r
elease the button when =0 is displayed; the
spanner disappears.
Following this operation, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the reset
to be registered.
Instruments

27
Retrieving the service
information
You can access the ser vice information at any
time in the instrument panel.The distance indicated (in miles or
kilometres) is calculated according to the
distance covered and the time elapsed
since the last ser vice.
The alert may be triggered close to a
due
date.
F

P
ress this button to temporarily display the
service information.
Engine oil level indicator
(Depending on version.)
On versions fitted with an electric oil level
indicator, the state of the engine oil level is
displayed in the instrument panel for a
few
seconds after switching the ignition on, after
the ser vicing information, in the form of
messages. The level read will only be correct if the
vehicle is on level ground and the engine
has been off for more than 30
minutes.
Low oil level
This is indicated by the display of a message
p rompting you to top up, accompanied by the
Service warning lamp and an audible signal.
If the low oil level is confirmed by a
check using
the dipstick, the level must be topped up to
avoid damage to the engine.
For more information on Checking levels ,
refer to the corresponding section.
Oil level indicator fault
This is signalled by the display of the " Oil
level measurement invalid " message in the
instrument panel.
Contact a
CITROËN dealer or a qualified
workshop. In the event of a
fault with the electric
indicator, the oil level is no longer
monitored.
If the system is faulty, you must check the
engine oil level using the manual dipstick
located under the bonnet.
For more information on Checking levels ,
refer to the corresponding section.
Engine coolant temperature
gauge
With the engine running:
- i n zone A , the temperature is correct,
-

i
n zone B , the temperature is too high; the
associated warning lamp and the central
STOP warning lamp come on in red in the
instrument panel, accompanied by the
display of a


message and an audible signal.
1
Instruments

28
You must stop the vehicle as soon as it is
safe to do so.
Wait a few minutes before switching off the
engine.
After switching off the ignition, carefully
open the bonnet and check the coolant
level.
For more information on Checking levels ,
refer to the corresponding section.
AdBlue® range indicators
(BlueHDi)
The Diesel BlueHDi engines are equipped with
a
system that associates the SCR (Selective
Catalytic Reduction) emissions control system
and the Diesel particle filter (DPF) for the
treatment of exhaust gases. They cannot
function without AdBlue
® fluid.
The engine starting prevention system
required by regulations is activated
automatically once the AdBlue
® tank is
empty. It is then no longer possible to
start the engine until the minimum level of
AdBlue
® has been topped up.
Manual display of the range
While the range is greater than 1,500 miles
( 2,400 km), it is not displayed automatically.
F

P
ress this button to temporarily display the
driving range.
Actions required related to a lack
of AdBlue®
The following warning lamps light up when the
quantity of AdBlue® is lower than the reser ve
level corresponding to a range of 1,500 miles
(2, 4 0 0


k m).
Together with the warning lamps, messages
regularly remind you of the need to top up to
avoid engine starting being prevented. Refer to
the Warning and indicator lamps section for
details of the messages displayed.
For more information on AdBlue
®
(BlueHDi engines) , and in particular on
topping up, refer to the corresponding
section. Warning/
indicator
lamps lit
Action
Remaining
range
To p u p .
Between 1,500 miles
a nd 500 miles
(2,400
km and 800 km)
Top up as soon
as possible.Between 500 miles
a nd 62 miles
(800
km and 100 km)
A top-up is
vital, there is
the risk that the
engine will be
prevented from
starting. Between
62
miles
and 0
miles
(100
km and
0


k m)
To be able
to restart the
engine, add at
least 5
litres of
AdBlue
® to its
tank. 0
miles (0 km)
Instruments

29
Malfunction of the SCR
emissions control system
Malfunction detection
If a malfunction is detected,
t hese warning lamps come on,
accompanied by an audible signal
and the display of an "Emissions
fault" message.
The alert is triggered while driving as soon
as the fault is detected for the first time, then
when switching on the ignition for subsequent
journeys, while the fault persists. If it is a
temporary fault, the alert
disappears during the next journey,
after self-diagnostic checks of the SCR
emissions control system.
Malfunction confirmed during the
permitted driving phase (between
685
miles and 0 miles (1,100 km and 0 km))
If the warning lamp is still on after 31 miles
( 50 km) of driving, the fault in the SCR system
is confirmed. Have the system checked by a
CITROËN
dealer or a qualified workshop as soon as
possible.
Starting prevented
Every time the ignition is switched on, the
message "Emissions fault: Starting prevented"
is displayed.
To be able to restart the engine, call
on a
CITROËN dealer or a qualified
workshop.
The AdBlue warning lamp flashes,
accompanied by the display of a
message
("Emissions fault: Starting prevented in x
miles") indicating the remaining range in miles
or kilometres.
While driving, the message is displayed every
30

seconds. The alert is repeated when
switching on the ignition.
You can continue driving for up to 685 miles
(1,100 km) before the engine star ting
prevention system is triggered.
Manual test in the
instrument panel
This function allows you, at any time, to check
certain indicators and display the alerts log.
F

W
ith the engine running, briefly press this
button.
The following information is displayed in the
instrument panel:
-

t
he engine oil level,
-

w
hen the next ser vice is due,
-

t
he driving range for the AdBlue and the
SCR system for BlueHDi Diesel versions,
-

d
isplay of the state of pressure of the tyres,
-

c
urrent alerts.
This information is also displayed
automatically every time the ignition is
switched on.
1
Instruments

30
Distance recorders
The total and trip distances are displayed for
thirty seconds when the ignition is switched off,
when the driver's door is opened and when the
vehicle is locked or unlocked.When travelling abroad, you may need to
change the units of distance and speed:
The display of distance and speed must
be expressed in the official unit of the
country (km or miles). The change of units
is done via the screen configuration menu,
with the vehicle stationary.
Total distance recorder
It measures the total distance travelled by the
vehicle since its first registration.
Trip distance recorder
It measures the distance travelled since it was
reset by the driver.
Resetting the trip recorder
F

W
ith the ignition on, press the button until
zeros appear.
Lighting dimmer
This system allows the brightness of the
instruments and controls to be adjusted to suit
the ambient light level.
With buttons With CITROËN Connect
Radio
F Press this button to select the
Settings menu.
F

Sel
ect "Brightness ".
F

A
djust the brightness by pressing
the arrows or moving the slider.
The settings are applied immediately.
F

P

ress outside the settings window to exit.
With the lamps on, press button A to increase
the brightness of the instruments and controls You can also switch off the screen:
F

P
ress this button to select the
Settings menu.
F

Sel
ect "Dark ".
The screen goes off completely.
F

P

ress the screen again (anywhere on its
sur face) to activate it.
and the vehicle's ambient lighting or button B
to reduce it.
Release the button when the desired level is
reached.
Instruments