2019 TOYOTA SUPRA engine

276
Supra Owner's Manual5-1. MOBILITY
5-1.MOBILITY
This chapter describes all standard,
country-specific and special equip-
ment available for the model series.
It may therefore describe equip-
ment and functions which are not
installed in your vehicle, for exam-
ple on account of the optional
equipment selected or the country
specification. This also applies to
safety-relevant functions and sys-
tems. Please comply with the rele-
vant laws and regulations when
using the corresponding functions
and systems.
Before refuelling, observe the notes
on fuel quality, see page 307.
When refuelling, insert the filler
nozzle fully into the filler neck. Lift-
ing the filler nozzle during refuelling
results in the following:
The fuel supply being cut off pre-
maturely.
Fuel vapour and fumes being
recovered less effectively.
The fuel tank is full when the filler
nozzle cuts out for the first time.
Please comply with the safety regu-
lations displayed at filling stations.1Briefly press the rear edge of
the fuel filler flap.
Refuelling
Vehicle equipment
Notes when refuelling
General
Safety notes
NOTICE
If the range drops below 50 km, 30
miles, the engine may no longer be
supplied with sufficient fuel. Engine
function is no longer ensured. There
is a danger of damage to property.
Refuel in good time.
NOTICE
Fuels are poisonous and aggressive.
Overfilling the fuel tank can damage
the fuel system. If fuel comes into
contact with paintwork, it can damage
them. This pollutes the environment.
There is a danger of damage to prop-
erty. Avoid overfilling.
Fuel tank cap
Opening

287
5
Supra Owner's Manual5-1. MOBILITY
MOBILITY
2Pull filler hose completely from
the cover of the sealant con-
tainer. Do not kink the hose.
3Push the sealant container into
the bracket on the compressor
housing, until it audibly
engages.
4Screw the filler hose of the seal-
ant container onto the tyre valve
of the faulty wheel.5Insert the plug into the socket in
the vehicle interior while the
compressor is switched off.
6Switch on the compressor with
standby state switched on or the
engine running.
Let the compressor run for approxi-
mately 10 minutes to fill the sealing
compound and achieve a tyre infla-
tion pressure of approximately 2.0
bar.
The tyre inflation pressure may rise
to approximately 5 bar during the
filling process of the sealing com-
pound. Do not switch off the com-
pressor during this step.

288
Supra Owner's Manual5-1. MOBILITY
1Switch off compressor.
2Read off the tyre inflation pres-
sure as shown on the tyre pres-
sure indicator.
To be able to continue the journey,
a tyre inflation pressure of at least 2
bar must be reached.
1Unscrew the filler hose of the
sealant container from the tyre
valve.
2Press the red unlocking device.
3Remove the sealant container
from the compressor.
4Pack and store the sealant con-
tainer to avoid soiling the boot.
1Unplug the connector from the
socket in the vehicle interior.
2Drive forwards and backwards
by 10 m, approximately 400
inches, to distribute the sealant
in the tyre.3Screw the connecting hose of
the compressor directly onto the
tyre valve.
4Insert the plug into the socket in
the vehicle interior.
5Switch on the compressor with
standby state switched on or the
engine running.
If the tyre inflation pressure of at least 2
bar is not reached, contact any author-
ized Toyota retailer or Toyota author-
ized repairer, or any reliable repairer.
If the tyre inflation pressure of at least 2
bar is reached, see Minimum inflation
pressure is reached.
6Unscrew the connecting hose of
the compressor from the tyre
valve.
7Unplug the connector from the
socket in the vehicle interior.
8Store Mobility System in the
vehicle. Checking and adjusting the
tyre inflation pressure
Checking
Removing and storing the sealant
container
Minimum tyre inflation pressure is
not reached

289
5
Supra Owner's Manual5-1. MOBILITY
MOBILITY
1Unscrew the connecting hose of
the compressor from the tyre
valve.
2Unplug the connector from the
socket in the vehicle interior.
3Store Mobility System in the
vehicle.
4Immediately drive for approxi-
mately 10 km/5 mi to evenly dis-
tribute the sealing compound in
the tyre.
Do not exceed a speed of 80 km/h/50
mph.
If possible, do not drive slower than 20
km/h/12 mph.
1Stop in a suitable area.
2Screw the connecting hose of
the compressor directly onto the
tyre valve.3Insert the plug into the socket in
the vehicle interior.
4Correct tyre inflation pressure to
at least 2.0 bar.
• To increase tyre inflation pres-
sure: switch on the compressor
with standby state switched on or
the engine running.
• To reduce tyre inflation pressure:
press the button on the compres-
sor.
5Unscrew the connecting hose of
the compressor from the tyre
valve.
6Unplug the connector from the
socket in the vehicle interior.
7Store Mobility System in the
vehicle.
Do not exceed maximum permitted
speed of 80 km/h, approximately 50
mph.
Reset the Tyre Pressure Monitor
(TPM), see page 290.
Have the punctured tyre and the
sealant container of the Mobility
System replaced as soon as possi- Minimum tyre inflation pressure is
reached
Adjusting
Resuming with journey

298
Supra Owner's Manual5-1. MOBILITY
Tyres with special approval: the
system will not function correctly if
a reset has not been carried out, for
example, a flat tyre is reported in
spite of the correct tyre pressure.
• A wheel without TPM wheel elec-
tronics is fitted, for example
emergency wheel: have the
wheels checked if necessary.
• Malfunction: have the system
checked.
• Fault due to systems or devices
with the same radio frequency:
the system is automatically reac-
tivated upon leaving the field of
interference.
• In the case of tyres with special
approval: the system was unable
to complete the reset. Perform a
system reset again.For run-flat tyres or when using a
flat tyre kit, it is not always neces-
sary to change a wheel immedi-
ately if tyre inflation pressure is lost
due to a flat tyre.
If required, the tools for changing
wheels are available as optional
accessories from any authorized
Toyota retailer or Toyota authorized
repairer, or any reliable repairer. Reset not carried out
Malfunction
Message
The yellow warning lamp
flashes and is then illumi-
nated continuously. A
vehicle message is
shown. Tyre pressure
losses cannot be
detected.
Measure
Wheel change
General
Safety notes
WARNING
The jack is only intended for raising
the vehicle briefly during a wheel
change. Even if the safety measures
are complied with, there is a risk of
the raised vehicle falling over due
tothe jack slipping. There is a danger
of injury or even death. If the vehicle
is raised with the jack, do not lie
underneath the vehicle and do not
start the engine.
WARNING
Supports such as wooden blocks
under the vehicle jack can prevent it
from achieving its load capacity due
to the restricted height. The load
capacity of the wooden blocks may be
exceeded, causing the vehicle to tip
over. There is a danger of injury or
even death. Do not place supports
under the vehicle jack.

305
5
Supra Owner's Manual5-1. MOBILITY
MOBILITY
This chapter describes all standard,
country-specific and special equip-
ment available for the model series.
It may therefore describe equip-
ment and functions which are not installed in your vehicle, for exam-
ple on account of the optional
equipment selected or the country
specification. This also applies to
safety-relevant functions and sys-
tems. Please comply with the rele-
vant laws and regulations when
using the corresponding functions
and systems.
1Filler neck for washing fluid
2Starting assistance, negative battery terminal
3Starting assistance, positive battery terminal
4Oil filler neck
5Additional coolant tank cooling
6Engine coolant tank
7Vehicle identification number
Engine compartment
Vehicle equipment
Overview

306
Supra Owner's Manual5-1. MOBILITY
1Pull the lever, arrow 1.
The bonnet is released.
2After releasing the lever, pull the
lever again, arrow 2.
The bonnet is opened.
Bonnet
Safety notes
WARNING
Incorrectly performed work in the
engine compartment can damage
components and lead to a safety risk.
There is a danger of accidents or
damage to property. Have work in the
engine compartment undertaken by
any authorized Toyota retailer or
Toyota authorized repairer, or any reli-
able repairer.
WARNING
The engine compartment contains
moving components. Certain compo-
nents in the engine compartment can
also move when the vehicle is
switched off, for example the radiator
fan. There is a danger of injury. Do
not reach into an area where there
are moving parts. Keep articles of
clothing and hair away from moving
parts.
WARNING
The bonnet has protruding parts on
the inside, for example locking hooks.
There is a danger of injury. When the
bonnet is open, watch out for protrud-
ing parts and keep these areas clear.
WARNING
If the bonnet is not correctly locked, it
can come open during the journey
and impair visibility. There is a danger
of accidents. Stop immediately and
close the bonnet correctly.
WARNING
Parts of the body can become
trapped when opening and closing
the bonnet. There is a danger of
injury. When opening and closing,
make sure that the area of movement
of the bonnet is kept clear.
NOTICE
When wipers are folded away from
the windscreen, they can be trapped
when the bonnet is opened. There is
a danger of damage to property.
Before opening the bonnet, make
sure that the wipers with wiper blades
fitted are in contact with the wind-
screen.
NOTICE
When closing, the bonnet must lock
into place on both sides. Applying
additional pressure can damage the
bonnet. There is a danger of damage
to property. Open the bonnet again
and close it firmly. Avoid applying
additional pressure.
Opening

308
Supra Owner's Manual5-1. MOBILITY
You can fill up with fuels with a
maximum ethanol content of 25 %,
for example E10 or E25.
The engine has knock control. This
means that different petrol grades
can be used.
Super, RON 95.
Unleaded petrol, RON 91.
Engine oil consumption depends on
the driving style and operating con-
ditions.
Therefore check the engine oil level
regularly each time you fill up with
fuel by taking a detailed measure-
ment.
Engine oil consumption can be
increased, for example in the fol-
lowing situations:
• Dynamic driving style.
• Running in the engine. Safety notes
NOTICE
Even small quantities of the wrong
fuel or wrong fuel additives can dam-
age the fuel system and engine. In
addition, the catalytic converter will be
permanently damaged. There is a
danger of damage to property. Do not
use the following fuel or additives with
petrol engines:
• Leaded petrol.
After filling the wrong fuel, do not
press the start/stop button. Contact
any authorized Toyota retailer or
Toyota authorized repairer, or any reli-
able repairer.
• Metallic additives, for example
manganese or iron.
NOTICE
Incorrect fuels can damage the fuel
system and engine. There is a danger
of damage to property. Do not refuel
with fuel with a higher ethanol content
than recommended. Do not refuel
with fuel containing methanol, for
example M5 to M100.
NOTICE
Fuel below the specified minimum
quality can adversely affect engine
function or lead to engine damage.
There is a danger of damage to prop-
erty. Do not refuel with petrol below
the specified minimum quality.
Petrol grade
Minimum grade
Engine oil
General