2019 MAZDA MODEL CX-30 sound

CAUTION
¾Do not disassemble the Mazda ERA-GLONASS. Otherwise, it could become
damaged and may not function in an emergency.
¾The Mazda ERA-GLONASS has a special built-in battery so that it can operate even
if the power supply from the vehicle is cut such as in an accident.
Heed the following cautions. If the Mazda ERA-GLONASS is not used correctly it
may not operate.
¾The built-in battery is not a rechargeable type battery. Do not attempt to
recharge the battery.
¾The built-in battery life is 3 years. Have the built-in battery replaced at an
Authorised Mazda Repairer periodically.
¾If the built-in battery power is low due to natural discharge and the system
determines that there is a problem, the Mazda ERA-GLONASS cannot be used.
If the system determines that there is a problem, the indicator light (red) in the
Emergency call switch turns on to notify the driver. Have the vehicle inspected at
an Authorised Mazda Repairer. Refer to Indicator light/Beep sound on page
7-19.
NOTE
xThe Mazda ERA-GLONASS can be used when the ignition is switched ON.xThere are two ways the Mazda ERA-GLONASS makes calls; automatically or
manually.
xThe Mazda ERA-GLONASS may not make a connection under the following
conditions or depending on the use environment. If the Mazda ERA-GLONASS
does not connect, make a call from another telephone such as the nearest
available public telephone.
xThe vehicle is outside of a mobile phone network areaxThe vehicle is in a weak radio wave transmission environment (such as inside
tunnels, underground parking areas, shadow of buildings, and mountain areas)
xThe vehicle does not receive an impact of a certain level or more even if an
accident has occurred.
xAn extremely serious collision occurs resulting in damage to the Mazda
ERA-GLONASS.
xThe position information cannot be obtained when signals cannot be received
from the GNSS satellites, however, voice calls are possible.
xWhen a voice call is made by the Mazda ERA-GLONASS, the audio system is
muted so that it does not interfere with the call.
xIt may take some time for the call centre to respond after the Mazda
ERA-GLONASS
first starts operating.
xIf you are unable to respond to an operator's questions after the voice call begins,
the operator may proceed with emergency procedures at their own discretion.
xEven if it is
difficult for you to hear the operator's voice, your voice may be heard
by the call centre. Continue explaining your circumstances.
If Trouble Arises
Mazda
ERA-GLONASS
7-15

2. The indicator light (green) on the Emergency call switch flashes slowly (0.5
second intervals) and the call is made to the call centre.
1. Green
3. When the connection is established with the call centre, the indicator light
(green) flashes somewhat quickly (0.3 second intervals) and the beep sounds
simultaneously, and the transmission of the vehicle information begins.
4. When the transmission of the vehicle information is completed or about 20
seconds have elapsed since the transmission began, the beep sounds and the
voice call with the call centre starts.
5. If the connection fails, the indicator light (red) turns on and the indicator light
(green) flashes quickly (0.15 second intervals) and the beep sounds
simultaneously.
In this case, make a manual connection using the Emergency call switch because
an automatic connection is not possible.
1. Red (Turns on)
2. Green (Flashes)
Manual emergency calls
With the ignition switched ON, long-press the Emergency call switch and after
releasing your
finger from the switch, the vehicle information is automatically
transmitted to the call centre.
When the transmission of the vehicle information is completed or about 20 seconds
have elapsed since the transmission began, the voice call with the call centre starts.
If Trouble Arises
Mazda
ERA-GLONASS
7-17

NOTE
xOnly make calls manually for conditions requiring urgent treatment such as illness
or serious injury.
xWhen making emergency calls manually, stop the vehicle in a safe location before
making the call.
xThe call centre will end an emergency call. The user cannot end the emergency
call.
xIf a call is disconnected or a call cannot be made to the call centre correctly, an
automatic call is made again to the call centre. To cancel the redialing, refer to
Manual emergency call cancellation.
1. Make sure that the ignition is switched ON.
2. Long-press the Emergency call switch on the overhead console and then release
your finger from the switch.
1. Emergency call switch
3. The indicator light (green) on the Emergency call switch flashes slowly (0.5
second intervals) and the call is made to the call centre.
1. Green
4. When the connection is established with the call centre, the indicator light
(green) flashes somewhat quickly (0.3 second intervals) and the beep sounds
simultaneously, and the transmission of the vehicle information begins.
5. When the transmission of the vehicle information is completed or about 20
seconds have elapsed since the transmission began, the beep sounds and the
voice call with the call centre starts.
If Trouble Arises
Mazda
ERA-GLONASS
7-18

6. If the connection fails, the indicator light (red) turns on and the indicator light
(green) flashes quickly (0.15 second intervals), and the beep sounds
simultaneously.
Make a manual emergency call again.
1. Red (Turns on)
2. Green (Flashes)
NOTE
If a call to the call centre does not connect even though the indicator light shows a
call is possible, make a call to the police or other authority by means other than the
Mazda
ERA-GLONASS.
Manual emergency call cancellation
A manual emergency call can be cancelled even after the Emergency call switch has
been pressed by pressing the switch again, as long as the call with the call centre has
not begun. If the call cannot be cancelled and the call with the call centre has
begun, tell the operator that the call is mistaken.
▼Indicator Light/Beep Sound
The indicator light turns on/flashes and beep sounds are activated to notify the
driver of the system operation status or if there is a problem with the system.
StatusIndicator light
Beep sound
statusOn/flashing conditions
Green Red Flash interval
Diagnosis Turns on Turns onŠŠWhen the ignition is switched
ON, it turns on and then
turns off after a few seconds.
NOTE
A manual emergency call is
not possible during diagnosis.
Normal Turns off Turns offŠŠThe system is operating nor-
mally.
If Trouble Arises
Mazda
ERA-GLONASS
7-19

StatusIndicator light
Beep sound
statusOn/flashing conditions
Green Red Flash interval
Malfunction Turns off Turns onŠ3 beeps
(Slow intermit-
tent sound)
xA system malfunction is
detected.
xThe remaining power of
the built-in battery is low.
CAUTION
If the indicator light (red) re-
mains on constantly, the sys-
tem will not operate normal-
ly. Have the vehicle inspected
at an expert repairer (we rec-
ommend an Authorised Maz-
da Repairer) as soon as possi-
ble.
Call being
made with call
centreFlashes Turns offSlow
(0.5 second
intervals)The beep does
not sound, but
the ringback
tone can be
heard.An emergency call is being
made by the Mazda
ERA-GLONASS.
Vehicle infor-
mation is be-
ing transmittedFlashes Turns
offSomewhat
quick
(0.3 second
intervals)Continuous in-
termittent
soundVehicle information is being
transmitted to the call centre.
Start of voice
callTu r n s o n Tu r n s o ffŠ1 beep
During a voice call with the
call centre.
During voice
callTu r n s o n Tu r n s
offŠŠ
Connection
failureFlashes Turns onQuick
(0.15 second
intervals)3 beeps
(Fast intermit-
tent sound)When an emergency call fails
to connect.
▼Te s t M o d e
The test mode function makes sure that the Mazda ERA-GLONASS can operate
normally.
Have your vehicle tested at an Authorised Mazda Repairer when performing the test
mode.
Method to start test mode
Switch the ignition ON while the parking brake is applied, and wait 2 minutes with
the vehicle stopped.
If Trouble Arises
Mazda
ERA-GLONASS
7-20

If a Warning Light Turns
On or Flashes
▼If a Warning Light Turns On or
Flashes
If any warning light turns on/flashes,
take appropriate action for each light.
There is no problem if the light turns
off, however if the light does not turn
off or turns
on/flashes again, consult
an expert repairer (we recommend an
Authorised Mazda Repairer).
The details for some warnings can be
viewed on the centre display or
multi-information display in the
instrument cluster.
Centre display
1. Select “Information” on the home
screen.
2. Select “Vehicle Status Monitor”.
3. Select the applicable warning to
view the warning details.
NOTE
You can also display the currently
occurring warning by sliding the
commander knob to the left while on
the home screen of the centre display.
Multi-information display
1. Press the INFO switch on the
steering switch to display the
warning indication screen.
Refer to Multi-information Display
on page 4-23.
▼Brake System Warning Indication/
Warning Light (Red)
This warning has the following
functions:
Warning light inspection
For an operation check, make sure that
the light turns on when the ignition is
switched on, and turns off a few
seconds later or when the engine is
started.
When the light turns on
If the brake system warning light
remains illuminated the brake fluid
may be low or there could be a
problem with the brake system. Park
the vehicle in a safe place immediately
and contact an expert repairer (we
recommend an Authorised Mazda
Repairer).
Refer to Inspecting Brake/Clutch Fluid
Level on page 6-30.
WARNING
Do not drive with the brake system
warning light illuminated. Contact an
expert repairer (we recommend an
Authorised Mazda Repairer) to have
the brakes inspected as soon as
possible:
Driving with the brake system warning
light illuminated is dangerous. It
indicates that your brakes may not
work at all or that they could
completely fail at any time. If this light
remains illuminated, after checking
that the parking brake is fully released,
have the brakes inspected
immediately.
CAUTION
¾In addition, the
effectiveness of the
braking may diminish so you may
need to depress the brake pedal
more strongly than normal to stop
the vehicle.
¾(With M Hybrid)
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-49

When starting the engine, the brake
system warning light may turn on and
the warning indication may be
displayed. In this case, park the
vehicle in a safe location and release
the brake pedal.
If the brake system warning light/
warning indication does not turn off
even after parking the vehicle, have
the vehicle inspected by an expert
repairer (we recommend an
Authorised Mazda Repairer).

▼Electronic Brake Force Distribution
System Warning
If the electronic brake force
distribution control unit determines
that some components are operating
incorrectly, the control unit may
illuminate the brake system warning
light and the ABS warning light
simultaneously. The problem is likely to
be the electronic brake force
distribution system.
WARNING
Do not drive with both the brake
system warning light and ABS warning
light illuminated. Have the vehicle
towed to an expert repairer (we
recommend an Authorised Mazda
Repairer) to have the brakes inspected
as soon as possible:
Driving when the brake system warning
light and ABS warning light are
illuminated simultaneously is
dangerous.
When both lights are illuminated, the
rear wheels could lock more quickly in
an emergency stop than under normal
circumstances.
▼Charging System Warning
Indication/Warning Light
If the warning light illuminates while
driving , it indicates a malfunction of
the alternator or of the charging
system.
Drive to the side of the road and park
off the right-of-way. Consult an expert
repairer (we recommend an
Authorised Mazda Repairer).
CAUTION
Do not continue driving when the
charging system warning light is
illuminated because the engine could
stop unexpectedly.
▼Engine Oil Warning Indication/
Warning Light
This warning light indicates low engine
oil pressure.
CAUTION
Do not run the engine if the oil
pressure is low. Otherwise, it could
result in extensive engine damage.
If the light illuminates or the warning
indication is displayed while driving:
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-50

1. Drive to the side of the road and
park off the right-of-way on level
ground.
2. Turn off the engine and wait 5
minutes for the oil to drain back
into the sump.
3. Inspect the engine oil level (page
6-27). If it's low, add the
appropriate amount of engine oil
while being careful not to overfill.
CAUTION
Do not run the engine if the oil
level is low. Otherwise, it could
result in extensive engine damage.
4. Start the engine and check the
warning light.

If the light remains illuminated even
though the oil level is normal or after
adding oil, stop the engine
immediately and have your vehicle
towed to an expert repairer (we
recommend an Authorised Mazda
Repairer).
▼High Engine Coolant Temperature
Warning Indication
Displays if the engine coolant
temperature has increased excessively.
“Elevated Engine Coolant Temp. Drive
Slowly” displayed
Drive slowly to reduce engine load
until you can find a safe place to stop
the vehicle and wait for the engine to
cool down.
“Excessive Engine Coolant Temp. Stop
the Vehicle in a Safe Location”
displayed
This indicates the possibility of
overheating. Park the vehicle in a safe
place immediately and stop the
engine.
Refer to Overheating on page 7-44.
CAUTION
Do not drive the vehicle with the high
engine coolant temperature warning
light illuminated. Otherwise, it could
result in damage to the engine.
▼Power Steering Malfunction
Indication/Indicator Light
The message is displayed if the electric
power steering has a malfunction.
If the message is displayed, stop the
vehicle in a safe place and do not
operate the steering wheel. There is no
problem if the indication turns off
when the engine is restarted after
some time has passed. If the indication
displays even after the engine is
restarted, contact an expert repairer
(we recommend an Authorised Mazda
Repairer) if the message is displayed
continuously.
NOTE
xIf the message is displayed, the
power steering will not operate
normally. In this case, the steering
wheel can still be operated,
however, the operation may feel
heavy compared to normal, or the
steering wheel could vibrate when
turning.
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
7-51