2019 MAZDA MODEL CX-30 sound

Parking Sensor System*
▼Parking Sensor System
The parking sensors use ultrasonic sensors which detect obstructions around the
vehicle when the vehicle is driven at low speeds, such as during garage or parallel
parking, and a buzzer sound and detection indicator notify the driver of the
approximate distance from the vehicle to the surrounding obstruction.

1. Front ultrasonic sensor*
2. Front corner ultrasonic sensor*
3. Rear ultrasonic sensor
4. Rear corner ultrasonic sensor
5. Rear side ultrasonic sensor
*
WARNING
Do not rely completely on the parking sensor system and be sure to
confirm the
safety around your vehicle visually when driving:
This system can assist the driver in operating the vehicle in the forward and
backward directions while parking. The detection ranges of the sensors are limited,
therefore, driving the vehicle while relying only on the system may cause an
accident. Always
confirm the safety around your vehicle visually when driving.
CAUTION
¾Do not install any accessories within the detection ranges of the sensors. It may
affect the system operation.
¾Depending on the type of obstruction and the surrounding conditions, the
detection range of a sensor may narrow, or the sensors may not be able to detect
obstructions.
NOTE
xThe system may not operate normally under the following conditions:
xMud, ice, or snow is adhering to the sensor area (Returns to normal operation
when removed).
When Driving
Parking Sensor System
4-252*Some models.

xThe sensor area is frozen (Returns to normal operation when the ice is thawed).xThe sensor is covered by a hand.xThe sensor is excessively shocked.xThe vehicle is excessively tilted.xUnder extremely hot or cold weather conditions.xThe vehicle is driven on bumps, inclines, gravel, grating , or grass covered roads.xAnything which generates ultrasonic waves such as another vehicle's horn, the
engine sound of a motorcycle, the air brake sound of a large-sized vehicle, or
another vehicle's sensors approaches the vehicle.
xThe vehicle is driven in heavy rain or in road conditions causing water-splash.xA commercially-available wing pole or an aerial for a radio transmitter is
installed to the vehicle.
xThe vehicle is moving towards a tall or square curbstone, or a steep grade.xAn obstruction is too close to the sensor.xThe vehicle is moving towards an uneven wall or stairs.xThere are multiple obstructions.xThe vehicle is driven in a place with low ceilings.xObstructions under the bumper cannot be detected. Obstructions which are
lower than the sensor or thin may not be detected even though they were
detected once.
xThe following types of obstructions may not be detected:
xThin objects such as wire, rope or polesxThings which absorb sonic waves easily such as cotton or snowxAngular shaped objectsxVery tall objects, and those which are wide at the topxSmall, short objectsxAlways have the system inspected at an expert repairer (we recommend an
Authorised Mazda Repairer) if any shock is applied to the bumpers, even in a
minor accident. If the sensors are deviated, they cannot detect obstructions.
xThe system may have a malfunction if the indicator light does not turn on even
when the parking sensor switch is turned on. Have your vehicle inspected by an
expert repairer (we recommend an Authorised Mazda Repairer).
xThe system may have a malfunction if a message indicating a system malfunction is
displayed. Have your vehicle inspected by an expert repairer (we recommend an
Authorised Mazda Repairer).
xA message may be displayed even when the ambient temperature is extremely
cold, or mud, ice, or snow adheres to the sensor area. Remove any foreign matter
from the sensor area.
xWhen installing a trailer hitch, consult an expert repairer (we recommend an
Authorised Mazda Repairer).
xIf a Mazda genuine trailer hitch is used, the rear side of the parking sensor system
is automatically turned
off.
When Driving
Parking Sensor System
4-253

Press the switch again to stop the
operation.
1. Indicator light
NOTE
When the ignition is switched OFF, the
system status before it was turned off is
maintained. For example, if the
ignition is switched OFF while the
parking sensor is activated, the system
will be activated when the ignition is
switched ON the next time.
Operation conditions
The parking sensor system can be used
when all of the following conditions
are met:
xThe ignition is switched ON.xThe parking sensor switch is turned
on.
NOTE
x(Automatic vehicle)
The detection indicator and buzzer
of the front sensors/front corner
sensors do not operate when the
selector lever is in the P position.
xThe detection indicator and buzzer
sound do not activate when the
parking brake is applied.
▼Obstruction Detection Indication
The position of a sensor which has
detected an obstruction is indicated.
The gauge illuminates in different areas
depending on the distance to an
obstruction detected by the sensor.
As the vehicle approaches closer to an
obstruction, the zone in the gauge
closer to the vehicle illuminates.
Without 360°view monitor
1. Front ultrasonic sensor gauge*
2. Right front corner ultrasonic sensor
gauge*
3. Right rear corner ultrasonic sensor
gauge/Right rear side ultrasonic
sensor gauge
*
4. Rear ultrasonic sensor gauge
5. Left rear corner ultrasonic sensor
gauge/Left rear side ultrasonic
sensor gauge
*
6. Left front corner ultrasonic sensor
gauge*
With 360°view monitor
1. Front ultrasonic sensor gauge
2. Right front corner ultrasonic sensor
gauge
When Driving
Parking Sensor System
4-256*Some models.

▼Parking Sensor Warning Beep
Informs the driver of the approximate distance from the vehicle to the obstruction
using warning beeps depending on the distance. If multiple obstructions are
detected at the same time, warning beeps are activated according to the distance to
the nearest obstruction. The warning beeps are activated as follows while the system
is operating. However, the warning beeps are not activated while the seat belt
reminder is operating.
Front ultrasonic sensor
*, Rear ultrasonic sensor
Distance De-
tection areaDistance between vehicle and obstruction
Beeper sound*1Front ultrasonic sensorRear ultrasonic sensor
Farthest dis-
tanceApprox. 100Š60.0 cm
(39.3Š23.6 in)
Approx. 150Š60.0 cm
(59.0Š23.6 in)
Slow intermittent
sound
Far distanceApprox. 60.0Š45.0 cm
(23.6Š17.7 in)
Approx. 60.0Š45.0 cm
(23.6Š17.7 in)
Medium intermit-
tent sound
Middle dis-
tanceApprox. 45.0Š35.0 cm
(17.7Š13.7 in)
Approx. 45.0Š35.0 cm
(17.7Š13.7 in)
Fast intermittent
sound
When Driving
Parking Sensor System
4-258*Some models.

Distance De-
tection areaDistance between vehicle and obstruction
Beeper sound*1Front ultrasonic sensorRear ultrasonic sensor
Close distanceWithin approx. 35.0 cm (13.7
in)
Within approx. 35.0 cm (13.7
in)
Continuous
sound
*1 The rate at which the intermittent sound beeps increases as the vehicle approaches the obstruction.
Front corner ultrasonic sensor*, Rear corner/Rear side* ultrasonic sensor
Distance Detection
areaDistance between vehicle and obstruction
Beeper sound*1Front corner ultrasonic sensor/Rear corner,
Rear side ultrasonic sensor
Far distanceApprox. 55.0Š38.0 cm (21.6Š14.9 in)
Medium intermittent
sound
Middle distanceApprox. 38.0Š25 cm (14.9Š9.8 in)
Fast intermittent sound
When Driving
Parking Sensor System
*Some models.4-259

Distance Detection
areaDistance between vehicle and obstruction
Beeper sound*1Front corner ultrasonic sensor/Rear corner,
Rear side ultrasonic sensor
Close distanceWithin approx. 25 cm (9.8 in)
Continuous sound
*1 The rate at which the intermittent sound beeps increases as the vehicle approaches the obstruction.
NOTE
xIf an obstruction in the same area excluding the close area is detected
continuously for 6 seconds or longer, only the warning beeps stop activating.
(Detection is indicated) If the detection area changes to the close side, the
warning beeps resumes. (If the detection area changes to the far side, the warning
beeps remain off)
xThe sound volume (each of front and rear) can be changed.
Refer to the Settings section in the Mazda Connect Owner's Manual.
▼When Warning Indicator/Beep is Activated
The system notifies the driver of an abnormality by activating the beep sound and
the indicator light.
Indicator/Beep How to check
A message indicating a sys-
tem malfunction or sensor
malfunction is displayed.There may be a problem with the system. Have your vehicle inspected
by an expert repairer (we recommend an Authorised Mazda Repairer)
as soon as possible.
A message indicating that the
sensor is dirty is displayed.Remove any foreign matter from the sensor area. If the system does not
recover, have the vehicle inspected by an expert repairer (we recom-
mend an Authorised Mazda Repairer).
A certain obstruction detec-
tion indication is continuous-
ly displayed.Foreign matter may have gotten on the sensor area corresponding to
the detection indicator. If the system does not recover, have the vehicle
inspected by an expert repairer (we recommend an Authorised Mazda
Repairer).
When Driving
Parking Sensor System
4-260

No. Menu Explanation
(6) SettingsYou can change the settings for the Mazda Connect screen, sound set-
tings, and the vehicle functions.

In-Vehicle Displays:
Configures settings and content for all in-vehicle displays.
Sound Settings:
Configures the in-vehicle listening experience.
Safety Settings:
Configures safety and driver assistance features.
Vehicle Settings:
Configures vehicle convenience features.
Connectivity Settings:
Configures Bluetooth and other device connectivity settings.
System Settings:
Configures language, time, and other general settings.
(7) Apple CarPlayYou can use Apple CarPlay by connecting an iPhone compatible with
Apple CarPlay to the USB slot.
(8) Android AutoYou can use Android Auto™ by connecting an Android™ Smartphone
compatible with Android Auto™ to the USB port.
WARNING
Always adjust Mazda Connect while the vehicle is stopped:
Do not adjust Mazda Connect with the Commander switch while driving the
vehicle. Adjusting Mazda Connect with the Commander switch while driving the
vehicle is dangerous as it could distract your attention from the vehicle operation
which could lead to a serious accident.
Even if the audio remote control switches are equipped on the steering wheel, learn
to use the switches without looking down at them so that you can keep your
maximum attention on the road while driving the vehicle.
Do not allow the connection plug cord to get tangled with the shift lever (manual
transmission)/selector lever (automatic transmission):
Allowing the plug cord to become tangled with the shift lever (manual
transmission)/selector lever (automatic transmission) is dangerous as it could
interfere with driving, resulting in an accident.
Interior Features
Mazda Connect
5-15

Do not adjust a mobile device or a similar product while driving the vehicle:
Adjusting a mobile device or a similar product while driving the vehicle is dangerous
as it could distract your attention from the vehicle operation which could lead to a
serious accident. Always adjust a mobile device or a similar product while the
vehicle is stopped.
CAUTION
For the purposes of safe driving, adjust the audio volume to a level that allows you
to hear sounds outside of the vehicle including car horns and particularly emergency
vehicle sirens.
NOTE
xDo not use Mazda Connect for a long time with the engine stopped. Otherwise,
the battery power could be depleted.
xIf a mobile phone or CB radio is used in or near the vehicle, it could cause noise to
occur from the audio system. However, this does not indicate a problem.
Interior Features
Mazda Connect
5-16