2019 MAZDA MODEL CX-30 sound

Distance-between-vehicles
guideline
(at 80 km/h (50 mph) vehicle
speed)Indication on display
Indication on multi-information
displayIndication on active driving dis-
play
*1
Extremely short (about 25 m (82
ft))
*1 Displays a pop-up image when the CANCEL switch is operated.
NOTE
xThe distance-between-vehicles differs depending on the vehicle speed, and the
slower the vehicle speed, the shorter the distance.
xWhen the ignition is switched to ACC or OFF, the set distance-between-vehicles is
taken over automatically even when the engine is started again.

The function is temporarily cancelled.
Headway control function
When the following operations are performed, the headway control function is
temporarily cancelled and the CTS set indication (green) changes to the CTS standby
indication (white) at the same time.
xThe CANCEL switch is pressed one time.xThe brake pedal is depressed.x(Automatic transmission vehicle)
The selector lever is in the P, N, or R position.
x(Manual transmission vehicle)
The shift lever is in the R position.

In the following cases, the CTS cancel indication is displayed and a sound is
activated one time.
xThe DSC has operated.xThe Smart Brake Support (SBS) has operated.xThe vehicle is driven on a downslope for a long time.xThere is a problem with the system.xThe front radar sensor cannot detect target objects (during rain, fog, snow or other
inclement weather conditions, or when the radiator grille is dirty).
xThe parking brake is applied.xAny of the doors is opened.xThe driver's seat belt is unfastened.
When Driving
i-ACTIVSENSE
4-158

xThe operation frequency of the braking by the CTS control is high.x(Automatic transmission vehicle)
The parking brake is automatically applied during stop hold control.
x(Manual transmission vehicle)
xThe vehicle speed decreases below 25 km/h (15 mph).xThe shift lever is in the neutral position for a certain period of time.xThe clutch pedal is depressed for a certain period of time.xThe engine has stalled.

Steering assist function
If any of the following conditions occurs, the steering assist function is temporarily
cancelled.
xThe headway control function is cancelled.xWhite (yellow) lane lines cannot be detected or a vehicle ahead cannot be
recognised.
xYour vehicle speed is more than about 60 km/h (37 mph).xThe accelerator pedal is operated.xThe direction indicator lever is operated.xThe vehicle is being driven on a sharp curve.xThe width of a lane is excessively narrow or wide.xThe vehicle crosses a lane line.xThe driver takes his/her hands off the steering wheel.xThe steering wheel is operated abruptly.xThere is a problem with the system.xThe temperature in the Forward Sensing Camera (FSC) is too high or too low.xThe windscreen around the Forward Sensing Camera (FSC) is foggy.xThe windscreen around the Forward Sensing Camera (FSC) is blocked by an
obstruction, causing poor forward visibility.

NOTE
If you take your hands off the steering wheel (not holding the steering wheel), the
warning sound is activated and an alert is indicated on the multi-information display
and the active driving display.
When Driving
i-ACTIVSENSE
4-159

xIf the vehicle ahead starts moving
within 3 seconds after your vehicle is
stopped by the stop hold control,
headway control will continue even if
you do not resume driving your
vehicle, such as by depressing the
accelerator pedal.

Vehicle departure information
If you do not resume driving within a
few seconds after the vehicle ahead
starts moving during stop hold control,
the multi-information display
vehicle-ahead indication flashes to
urge the driver to resume driving. If you
do not resume driving after the
indicator light
flashes, a sound is
activated to urge you to resume
driving.
Lane-keep Assist System
(LAS)
*
▼Lane-keep Assist System (LAS)
The LAS provides steering assistance to
help the driver stay within the vehicle
lane if the vehicle might be deviating.
The forward sensing camera (FSC)
detects the white lines (yellow lines) of
the vehicle lane in which the vehicle is
travelling and if the system determines
that the vehicle may deviate from its
lane, it operates the electric power
steering to assist the driver’s steering
operation. The system also alerts the
driver by displaying an alert on the
multi-information display and the
active driving display. Use the system
when you drive the vehicle on roads
with white (yellow) lines such as
expressways and highways.
1. Forward sensing camera (FSC)
WARNING
Do not rely completely on the LAS:
¾The LAS is not an automated driving
system. In addition, the system is not
designed to compensate for a
driver’s lack of caution, and
over-reliance on the system could
lead to an accident.
When Driving
i-ACTIVSENSE
4-162*Some models.

Adjustable Speed Limiter
(ASL)
*
▼Adjustable Speed Limiter (ASL)
The ASL is a function to prevent the
vehicle from being driven at a vehicle
speed faster than a set speed. The
vehicle speed is controlled to kept it
below the set speed even if the
accelerator pedal is depressed.
The ASL can be set between 30 km/h
(19 mph) and 200 km/h (125 mph).
The vehicle speed may exceed the set
speed when the vehicle is driven on a
down slope, however, the system
notifies the driver by flashing the
display and operating a warning
sound.
WARNING
Always turn off the system when
changing drivers:
If the driver is changed and the new
driver is unaware of the ASL function,
the vehicle may not accelerate when
the driver depresses the accelerator
pedal, leading to an accident.
The system consists of the ASL display
and the speed limiter switch on the
steering wheel.
Multi-information display (Basic
display)
1. ASL set vehicle speed

Multi-information display
(i-ACTIVSENSE display)
1. ASL set vehicle speed

Active driving display
1. ASL set vehicle speed

When Driving
i-ACTIVSENSE
4-166*Some models.

Intelligent Speed
Assistance (ISA)
*
▼Intelligent Speed Assistance (ISA)
The ISA is a function which keeps the
vehicle speed below the speed limit
set from a speed limit sign or an
optionally set speed limit. The speed
limit can be set between 30 and 200
km/h (19-125 mph), and if the vehicle
speed exceeds the set speed limit
while driving on steep slopes, the
system notifies the driver using the
display and a warning sound.
The ISA recognises a speed limit sign
based on the
Tra ffi c Sign Recognition
System (TSR) or the navigation system
information.
Refer to
Tra ffi c Sign Recognition
System (TSR) on page 4-111.
WARNING
Always turn
off the system when
changing drivers:
If the driver is changed and the new
driver is unaware of the ISA function,
the vehicle may not accelerate when
the driver depresses the accelerator
pedal, leading to an accident.
Depending on the weather conditions
or problems with traffic signs, a traffic
sign may not be recognised or a traffic
sign
different from the actual
traffic
sign may be displayed. Always make it
your responsibility as a driver to check
the actual traffic signs. Otherwise, it
could result in an accident.
NOTE
The ISA operates only when the
navigation system's SD card (Mazda
genuine) is inserted. In addition, the
Adjustable Speed Limiter (ASL)
operates only when the navigation
system's SD card (Mazda genuine) is
not inserted. Refer to Adjustable
Speed Limiter (ASL) on page 4-166.
The system consists of the ISA display
and the speed limiter switch on the
steering wheel.

Multi-information display (Basic
display)
1. set vehicle speed

When Driving
i-ACTIVSENSE
4-170*Some models.

Smart Brake Support
(SBS)
*
▼Smart Brake Support (SBS)
The SBS alerts the driver of a possible
collision using the warning indications
in the display and a warning sound if
the front radar sensor and Forward
Sensing Camera (FSC) determine that
there is the possibility of a collision
with a vehicle ahead, pedestrian, or a
bicycle. Furthermore, if a collision is
unavoidable, the automatic brake
control is performed to reduce damage
in the event of a collision. In addition,
when the driver depresses the brake
pedal, the brakes are applied firmly
and quickly to assist.
(Vehicles with Driver Monitoring
(DM))
When the SBS determines that the
driver is not paying attention to the
road using the driver monitoring
camera and it determines that there is
the possibility of a collision with an
obstruction, the SBS activates the
collision warning earlier than normal.
WARNING
Do not rely completely on the
SBS:
The SBS is only designed to reduce
damage in the event of a collision.
The ability to detect obstructions is
limited depending on the obstructions,
weather conditions, or
traffic
conditions. Over reliance on the
system leading to the accelerator pedal
or brake pedal being mistakenly
operated could result in an accident.
CAUTION
In the following cases, turn the system
off to prevent an unexpected
operation.
¾The vehicle is being towed or when
towing another vehicle.
¾The vehicle is on a chassis roller.
¾When driving on rough roads such as
in areas of dense grass or off-road.
See the next page on how to turn
off
the system.
Refer to Stopping the Smart Brake
Support (SBS) System Operation on
page 4-177.
Operation conditions
The SBS operates when all of the
following conditions are met.
xThe ignition is switched ON.xThe SBS is on.xThe i-ACTIVSENSE warning
indication/warning light is not
turned on.
x(Object is vehicle ahead)
The vehicle speed is about 4 km/h
(2 mph) or higher.
x(Object is a pedestrian or bicycle)
The vehicle speed is between about
10 to 80 km/h (6.2 to 50 mph).
xThe DSC does not operate.
NOTE
xUnder the following conditions, the
SBS may not operate.
xIf there is the possibility of hitting
only a part of a vehicle or
obstruction ahead.
xYou are driving your vehicle at the
same speed as the vehicle ahead.
xWhen the driver deliberately
performs driving operations
(accelerator operation, steering
wheel operation).
When Driving
i-ACTIVSENSE
*Some models.4-175

xThe accelerator pedal is depressed
abruptly.
xThe brake pedal is being
depressed.
xThe steering wheel is being
operated.
xThe selector lever is being shifted.xThe direction indicator lever is
being operated.
xWhen warnings and messages,
such as a dirty windscreen, related
to the Forward Sensing Camera
(FSC) or front radar sensor are
being displayed on the
multi-information display.
xThe SBS may operate under the
following conditions.
xThere is an object in the road at
the entrance to a curve (including
guardrails and snow banks).
xPassing an approaching vehicle
while rounding a curve.
xWhen crossing a narrow bridge,
and passing through low gates,
narrow gates, car washing
machines, or tunnels.
xWhen passing through a toll gate.xWhen entering an underground
parking area.
xThere is a metal object, bump, or a
protruding object on the road.
xIf you suddenly come close to a
vehicle ahead.
xThere is an animal, wall, or tree.xNotifies the driver with a warning
indication on the multi-information
display and the active driving display
(vehicles with active driving display)
while the system is operating.
xIf a malfunction is detected or the
system temporarily stops the
function due to dirty sensors (such as
radar sensor or Forward Sensing
Camera (FSC)), the i-ACTIVSENSE
warning indication/warning light
turns on and a message is displayed
on the multi-information display.
xOn a manual transmission vehicle,
the engine stops if the clutch pedal is
not depressed when the vehicle is
stopped by the SBS brake operation.
xIf the vehicle is stopped by the SBS
brake operation and the brake pedal
is not depressed, the SBS brake is
automatically released after about 2
seconds.
▼Collision Warning
When there is a possibility of a
collision with a vehicle ahead, the
collision warning sound is activated
continuously and a warning is
displayed on the multi-information
display and the active driving display.
Multi-information display
1. “BRAKE!” message is displayed

Active driving display
When Driving
i-ACTIVSENSE
4-176

1. “BRAKE!” message is displayed
NOTE
xThe collision warning sound is
activated intermittently while the SBS
brake or brake assist (SBS brake
assist) is operating.
xThe operation distance and volume
of the collision warning can be
changed.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
▼Stopping the Smart Brake Support
(SBS) System Operation
The SBS can be changed to inoperable.
Refer to the Settings section in the
Mazda Connect Owner's Manual.
When the SBS is cancelled, the SBS
OFF indicator light turns on.
NOTE
When the ignition is switched OFF
while the SBS is cancelled, the SBS is
automatically enabled the next time
the ignition is switched ON.
Smart Brake Support
[Rear] (SBS-R)
*
▼Smart Brake Support [Rear]
(SBS-R)
The SBS-R is a system which is
designed to reduce damage in the
event of a collision by operating the
brake control (SBS brake) when the
system’s sensors detect an obstruction
at the rear of the vehicle while driving
at a speed of about 2 to 8 km/h (2 to
4 mph) and the system determines that
a collision is unavoidable.
WARNING
Do not rely completely on the SBS-R
system:
¾The
SBS-R system is only designed to
reduce damage in the event of a
collision. Over reliance on the system
leading to the accelerator pedal or
brake pedal being mistakenly
operated could result in an accident.
¾To assure the correct operation of
the
SBS-R, heed the following
cautions.
When Driving
i-ACTIVSENSE
*Some models.4-177