Page 321 of 348
6.3
ENGINE IDENTIFICATION PLATES (1/2)
Please quote the information on the
engine plate or label A in all corre-
spondence or orders.
(Location varies depending on engine)
1 Engine type.
2 Engine suffix.
3 Engine number.
A
12
3A
A
A
Page 322 of 348
6.4
ENGINE IDENTIFICATION PLATES (2/2)
C
Please quote the information on the
engine plate or label A in all corre-
spondence or orders.
(Location varies depending on engine)
1 Engine type.
2 Engine suffix.
3 Engine number.
C
12
3A
A
12
3
A
A
Page 323 of 348
6.5
1,446*
1,565 to 1,599
2,058
* Unladen
Five-door version
0,9212,6700,7681,574 to 1,596
4,359
DIMENSIONS (in metres) (1/3)
Page 324 of 348
6.6
0,9212,712 0,993 1,574 to 1,596
4,626
1,449*
1,565 to 1,599
2,058
DIMENSIONS (in metres) (2/3)
* Unladen
Estate versions
Page 325 of 348
6.7
0,9212,711 0,998 1,577 to 1,583
4,630
1,583 to 1,587
2,058
1,443*
* Unladen
DIMENSIONS (in metres) (3/3)
Four-door version
Page 326 of 348
6.8
ENGINE SPECIFICATIONS
Versions2.0 16V 1.2 TCe 1.6 16V 1.6 TCe 1.5 dCi 1.6 dCi
Engine type
(see engine plate) M4R H5F Turbo H4M M5M Turbo K9K
R9M
Cubic capacity (cc) 1995 11971598 1618 1 461 1598
Type of fuel
Octane rating It is
essential that you use unleaded petrol of the octane rating
stated on the label inside the fuel filler flap. Diesel
The label located in the fuel filler flap indicates authorised fuels.
Spark plugs Only use the spark plugs specified for your vehicle’s engine.
The type should be marked on a label affixed inside the engine com-
partment. If it is not then contact an approved Dealer.
Fitting spark plugs which are not to specification may damage the
engine. –
Page 327 of 348

6.9
WEIGHTS (in kg)
The weights indicated are for a basic vehicle without options: they may \
vary depending on your vehicle’s equipment.
Consult an approved Dealer.Five door Estate Four-door
Maximum permissible all-up weight (MMAC)
Maximum permissible all-up weight (MMTA)
Gross Train Weight (MTR) Weights are indicated on the vehicle identification plate (refer to
the information on “Vehicle identification plates” in Section 6)
Braked Trailer Weight* found by calculating: MTR - MMAC
Unbraked Trailer Weight* 630 665 660
Permissible nose weight* 75 75 75
Maximum permissible load on roof 80 kg (including the carrying device)
* Towing weight (Towing a caravan, boat, etc.)
Towing is prohibited when the MTR - MMAC calculation is equal to zero, or when the MTR is equal to zero (or is not listed) on the
identification plate.
– It is important to comply with the towing weights, governed by local leg\
islation in each country and, in particular, laid down in the Road Traffic Regulations. Contact an approved Dealer about any towing equipment.
– When towing, under no circumstances may the total train weight (vehicle + trailer) be exceeded . However the following is
permitted:
– rear axle MMTA exceeded by no more than 15%,
– maximum MMAC exceeded by no more than 10% or 100 kg (whichever is reach\
ed first).
In either case, the maximum speed of the towing assembly must not exceed\
60 mph (100 km/h) and the tyre pressure must be increased by 0.2 bar (3 PSI).
– The engine output and climbing capability are reduced with altitude. We recommend that the maximum load be reduced by 10% at an altitude of 1,000 metres and by an additional 10% for each 1,0\
00 metres thereafter.
Page 328 of 348
6.10
Original parts are based on strict specifications and are subject to hig\
hly-specialised tests. Therefore, they are of at least the same
level of quality as the parts fitted originally.
If you always fit genuine replacement parts to your vehicle, you will en\
sure that it performs well. Furthermore, repairs carried out
within the manufacturer’s Network using original parts are guaranteed according to the condition\
s set out on the reverse of the
repair order.
REPLACEMENT PARTS AND REPAIRS