2018 Peugeot iOn service indicator

7
Instrument panel
Dials
1.Main battery state of charge indicator.
Reminder of the drive selector position.
2. Energy consumption/generation indicator.
3. Speedometer.
Engine brake temporary reduction
i n d i c a t o r.
4. Display screen.
Display screen
A.Total distance recorder.
B. Trip distance recorder ( journey A or B).
C. Instrument panel lighting dimmer.
D. Distance remaining until service due.
E. Time remaining until service due.
F. Under-inflation detection.
G. Remaining range indicator.
Warning and indicator lamps
Visual identifiers informing the driver that
a system is in operation, switched off (on/
off indicator lamps) or has developed a fault
(warning lamp).
When the ignition is switched on
Certain warning lamps come on for a few
seconds when the vehicle's ignition is switched
on.
When the vehicle is started, these same
warning lamps should go off.
If they remain on, before driving refer to the
information on the warning lamp concerned.
Associated warnings
The illumination of certain warning lamps may
be accompanied by an audible signal.
There are two types of lighting for warning
lamps, fixed (continuous) or flashing.
Certain warning lamps may come on in
one of two modes. Only by relating the
type of lighting to the operating status of
the vehicle can it be ascertained whether
the situation is normal or whether a fault
has occurred.
5.
Display screen management button.
Displays the different functions
su c c e s s i ve l y.
Resets the selected function to zero (trip
distance recorder or service indicator).
Sets the lighting dimmer intensity.
Panel that brings together the different dials
and vehicle operation indicator lamps.
1
Dashboard instruments

16
Lighting dimmer
System that allows the brightness of the
instruments and controls to be adjusted
manually to suit the ambient light level.
With the headlamps on or off, press button A to
select the function, then hold it down to adjust
the brightness of the instruments and controls
lighting to "day" or "night".
The brightness of the lighting increases every
time you press button A.
When the lighting reaches the maximum
setting, press again to move to the minimum
setting.
Release button A as soon as the lighting
reaches the desired brightness.
The setting is registered as soon as you
release button A and is stored when the ignition
switch is turned to OFF.
Service indicator
System which informs the driver when the
next ser vice is due, in accordance with the
manufacturer's servicing schedule.
This due date is calculated from the last reset
of the service indicator.
There are two different ways to indicate when
the next ser vice is due:
-

r
emaining distance (in kilometres or miles),
-

t
ime (in months) left before the next
service.
Once the ignition is switched on, press
button
A successively until the ser vice indicator
is displayed in the desired units.
Operation
1. The display shows the distance or time
remaining before the next service.
2. The display shows that the ser vice is due.
Each time the ignition is switched on, the
ser vice spanner is displayed for a few
seconds to notify you that the ser vice
must be carried out very soon.
3. Once the ser vice has been completed,
the distance or the time remaining before
the next ser vice is displayed.
Dashboard instruments

17
Resetting the service indicator
After each service, the service indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:
F
T
urn off the ignition (switch to LOCK or
ACC position).
F

P
ress the reset button A in succession until
the service indicator is displayed.
F

P
ress and hold the reset button down for a
few seconds to make the spanner flash .
F

P
ress the reset button whilst the spanner
is flashing to move the display " ---" to
" CLEAR ".
The distance (or the time) remaining before
the next ser vice is displayed. The distance "
---" indicating that the
ser vice is now due is reset automatically
after a certain time and a certain distance
travelled. The display will then indicate the
remaining time before the next service.
Under-inflation detection
You must reinitialise the under-inflation
detection system after adjusting one or more
tyre pressures and after changing one or more
wheels.
The procedure for this is as follows.
F

P
ress button A to select the system.
F

P
ress and hold button A down for at least
three seconds .
An audible signal sounds and the under-
inflation warning lamp flashes slowly until
reinitialisation has been completed.
1
Dashboard instruments

47
Emergency or assistance
call
Peugeot Connect SOS
* In accordance with the general conditions of use for the ser vice available from dealers
and subject to technological and technical
limitations.
**

A
s per the geographic coverage of
"Peugeot Connect SOS", "Peugeot Connect
Assistance" and the official national
language chosen by the owner of the vehicle.
The list of countries covered and PEUGEOT
CONNECT services is available from dealers
or on the website for your country.
In an emergency, press this
button for more than 2

seconds.
The flashing green indicator lamp and the voice
message confirm that the call has been made
to the "Peugeot Connect SOS" call centre*. Pressing this button again
immediately cancels the request.
The green indicator lamp goes
of f.
The green indicator lamp remains on (without
flashing) when communication is established.
It goes off at the end of the call. expressly declined, the call is sent directly
to the emergency services (112) without the
vehicle location.
"Peugeot Connect SOS" immediately locates
your vehicle, contacts you in your own
language** and – if necessary – requests that
relevant emergency services be dispatched**.
In countries where the ser vice is not available,
or when the locating ser vice has been If an impact is detected by the airbag
control unit, and independently of the
deployment of any airbags, an emergency
call is made automatically.
If you benefit from the Peugeot Connect
Packs offer with the SOS and assistance
pack included, there are additional
ser vices available to you in your personal
space, via the website for your country.
Operation of the system
When the ignition is switched on,
the green indicator lamp comes
on for 3
seconds indicating that
the system is operating correctly.
If the orange indicator lamp
flashes then goes off: the system
has a fault.
If the orange indicator lamp is permanently on:
the back-up battery should be replaced.
In both cases, the emergency and assistance
calls ser vice may not work.
Contact a qualified repairer as soon as
possible.
The fault with the system does not prevent
the vehicle being driven.
Peugeot Connect
Assistance
Press this button for more than
2 seconds to request assistance
if the vehicle breaks down.
A voice message confirms that the call has
been made**. Pressing this button again
immediately cancels the request.
5
Safety

113
Seats, heated ............................................ 24-25
Seats, rear ................................................. 25 -26
Selector, drive


........................................... 69 -70
Serial number, vehicle


..................................109
Service indicator


........................................ 16 -17
Sidelamps
........................................... 13,

97, 99
Side repeater


.................................................. 98
Snow chains


.................................................... 82
Socket, 12
V accessory .............................27-2 8
Speedometer


.................................................... 7
Starting/switching off the vehicle
.............. 6

8 -70
Station, radio
...............................

......................2
Sun visor
...............................

..........................28
TTables of fuses ....................................... 10 2-104
Technical data ........................................ 10
6,107
Third brake lamp


........................................... 10 0
Total distance recorder


...................................15
Towing another vehicle


.................................105
Traction control (ASR)


....................................49
Traffic information (TA)


.....................................3
Trajectory control systems

..............................49
T

y r e s

.................................................. 70 -72, 109
Tyre under-inflation detection


...12 , 17-18 , 70 -72
UUnlocking from the inside ............................... 21
US B ................................................................... 3
VVentilation ................................................. 29-32
WWarning and indicator lamps .......................7- 13
Weights ............... .......................................... 107
Wheel, spare
...............................

............93, 109
Window controls


............................................. 22
Wiper, rear ....................................................... 43
Wiper blades (changing)


.................................87
Wipers


............................................................. 42
.
Alphabetical index