2018 Peugeot 208 Owner's Manual

47
Map reading lamps
Interior ambient lighting
Switching on
At night, panoramic sunroof light-emitting
diodes (LEDs) come on automatically when the
sidelamps are switched on.
It switches off gradually:
-

w

hen the vehicle is locked,
-

w

hen the ignition is switched on,
-

3

0

seconds after the last door is closed.
Permanently off.
Permanent lighting.
In "permanent lighting" mode, the lighting
time varies according to the circumstances:
-
w
hen the ignition is off, approximately
ten minutes,
-

i
n energy economy mode,
approximately 30


seconds,
-
w

ith the engine running, unlimited.
F With the ignition on, press the corresponding switch.
Take care not to put anything in contact
with the courtesy lamp.
Switching off
The interior ambient lighting switches off
automatically when the sidelamps are switched
of f. The interior ambient lighting can be
configured in the Driving/Vehicle
menu.
Sunroof blind
Opening
F Take the blind by its handle and push it rearward to the desired position.
3
Ease of use and comfort

48
Closing
F Take the blind by its handle and pull it for ward to the desired position.
Interior fittings
Mats
Fitting
When fitting the mat for the first time, on the
driver's side, use only the fixings provided in
the wallet provided.
The other mats are simply placed on the
carpet.
Removing
To remove the mat on the driver's side:
F m ove the seat as far back as possible,
F

un
clip the fixings,
F

r
emove the mat.
Refitting
To refit the mat on the driver's side:
F p osition the mat correctly,
F

r
eattach the fixings by pressing,
F

c
heck that the mat is secured correctly.
To avoid any risk of jamming of the pedals:
-

o
nly use mats which are suited to the
fixings already present in the vehicle;
these fixings must be used,
-

n
ever fit one mat on top of another.
The use of mats not approved by
PEUGEOT may inter fere with access to
the pedals and hinder the operation of the
cruise control/speed limiter.
The mats approved by PEUGEOT have
two fixings located below the seat.
Ease of use and comfort

49
12 V accessory socket
F To connect a 12 V accessory (maximum
power: 120 watts), lift the cover and plug in
the correct adapter.
Do not exceed the maximum power rating
of the socket (risk of damage to your
accessory).
USB socket
The USB socket allows the connection of
a portable device, such as an iPod®-type digital
audio player, or a

USB memory stick.
The USB reader reads your audio files, which
are then transmitted to your audio system and
played via the vehicle's speakers.
These files are managed via the steering wheel
controls or from the audio system.
When connected to the USB socket,
the portable device can be charged
automatically.
While charging, a message is displayed
if the power consumption of the portable
device exceeds the amperage supplied by
the vehicle.
Boot fittings
1.Rear shelf
2. Hooks
3. Boot lamp
4. Stowing rings (depending on version)
The connection of an electrical device
not approved by PEUGEOT, such as
a

USB charger, may adversely affect the
operation of vehicle electrical systems,
causing faults such as poor radio
reception or inter ference with displays in
the screens.
For more detail on the Audio equipment and
telematics, and particularly the USB socket,
refer to the corresponding part of the audio
equipment section. The USB socket also allows a
smartphone to
be connected by MirrorLink
TM, Android Auto®
or CarPlay®, so that certain applications on the
smartphone can be used on the touch screen.
3
Ease of use and comfort

50
Rear shelf
To remove the shelf:
F u nhook the two cords,
F

g
ently lift the shelf, then remove it.
Stow it:
-
v

ertically behind the rear seats,
-
v

ertically behind the front seats. To refit the shelf:
F

e
ngage it on the supports on each side and
slide it until it reaches the notches,
F
r
aise it to refit the two cords.
When sharp deceleration occurs,
objects placed on the shelf can turn into
projectiles.
Ease of use and comfort

51
Lighting control stalk
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a few minutes.
Travelling abroad
If planning to use your vehicle in a
country
that drives on the other side of the road,
the dipped beam headlamps must be
adjusted to avoid dazzling oncoming
drivers. Contact a
PEUGEOT dealer or
a


qualified workshop.
Selection of main lighting
mode
Lighting off (ignition off)/Front daytime
running lamps (engine running).
Sidelamps only.
Dipped or main beam headlamps.
Automatic illumination of headlamps.
Headlamp dipping
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining
a pull on the stalk.
Display
Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
lighting selected is on.
Foglamps
The foglamps operate with dipped or main
beam headlamps on.
Turn the ring to align the desired symbol with
the marking. Pull the stalk to switch between dipped and
main beam headlamps.
Rear foglamp only
F To switch it on, turn the ring for wards.
When the lighting is switched off automatically
(version with AUTO lighting), the foglamp and
the dipped beam headlamps will remain on.
F

T
o switch it off, turn the ring rear wards.
Front foglamps and rear foglamp
Rotate and release the ring:
F o nce for wards to switch on the front
foglamps,
F

f
or wards a second time to switch on the rear
foglamp,
F

o
nce rear wards to switch off the rear
foglamp,
F

r
ear wards a second time to switch off the
front foglamps.
4
Lighting and visibility

52
If the lighting is switched off automatically
(version with AUTO lighting) or the dipped
beams are switched off manually, the foglamps
and sidelamps remain on.
F
T
urn the ring rear wards to switch the
foglamps off; the sidelamps will then switch
of f.
In good or rainy weather, by day and
night, using the front and rear foglamps is
prohibited. In these situations, the power
of their beams may dazzle other drivers.
They should only be used in fog or falling
snow.
In these weather conditions, it is your
responsibility to switch on the foglamps
and dipped beam headlamps manually as
the sunshine sensor may detect sufficient
light.
Do not forget to turn off the front and rear
foglamps as soon as they are no longer
necessary.
Switching off of the lighting when the
ignition is switched off
On switching off the ignition, all of the
lighting turns off immediately, except for
dipped beam if automatic guide-me-home
lighting is activated. Switching on the lighting after the
ignition is switched off
To reactivate the lighting control stalk, set
the ring to position "
0" - lighting off, then to
the desired position.
On opening the driver's door, a
temporary
audible signal warns the driver that the
lighting is on.
The lamps, with the exception of the
sidelamps, switch off automatically after
a
maximum duration of 30 minutes to
prevent discharging of the battery.
Direction indicators
F Lower the lighting control stalk fully when turning left.
F

R
aise the lighting control stalk fully when
turning right. If you forget to cancel the direction
indicators for more than 20
seconds, the
volume of the audible signal will increase if
the speed is above 37 mph (60 km/h).
Three flashes
Move the stalk briefly upwards or downwards,
without going beyond the point of resistance;
the corresponding direction indicators will flash
three times.
This function can be used at any speed,
but it is particularly useful for changing
lane on fast roads.
Automatic illumination of
headlamps
When a low level of ambient light is detected by
t he sunshine sensor, the number plate lamps,
sidelamps and dipped beam headlamps are
switched on automatically, without any action
on the part of the driver. They may also come
on if rain is detected, at the same time as
automatic operation of the windscreen wipers.
As soon as the brightness returns to
a
sufficient level or after the windscreen wipers
are switched off, the lamps are switched off
automatically.
Lighting and visibility

53
Switching on
F Turn the ring to the "AUTO" position.
Activation of the function is accompanied by
a
message on the screen.
Switching off
F Turn the ring to another position. Deactivation of the function is accompanied
by a
message in the screen.
In fog or snow, the sunshine sensor may
detect sufficient light. In this case, the
lighting will not come on automatically.
Do not cover the sunshine sensor, linked
with the rain sensor and located in the
centre of the windscreen behind the rear
view mirror; the associated functions
would no longer be controlled.
Automatic guide-me-home
lighting
When associated with automatic illumination of
headlamps, the guide-me-home lighting offers
the following additional options:
-

s
election of the lighting duration of 15, 30 or
60


seconds,
-

a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation.
The guide-me-home lighting can be
configured in the Driving/Vehicle
menu.
In the event of a
fault with the
sunshine sensor, the lighting comes
on, this warning lamp is displayed
in the instrument panel and/or
a
message appears on the screen,
accompanied by an audible signal.
Contact a
PEUGEOT dealer or
a


qualified workshop.
Manual guide-me-home
lighting
Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has
been switched off makes the driver's exit easier
when the light is poor.
Switching on
F With the ignition off, "flash" the headlamps using the lighting control stalk.
F

A f
urther "headlamp flash" switches the
function off.
Manual guide-me-home lighting is
also available from the remote control
lighting button.
Switching off
Manual guide-me-home lighting goes off
automatically at the end of a given period of
time.
4
Lighting and visibility

54
Headlamp beam height
adjustment
To avoid causing a nuisance to other road
u sers, the height of the headlamp beams
should be adjusted according to the load in the
vehicle.
0. 1
or 2 people in the front seats.
-. Intermediate setting.
1. 5


people.
-. 5
people + maximum authorised load.
2. Driver + maximum authorised load.
The initial setting is position " 0".
Vehicle side marking by illumination of the
sidelamps on the traffic side only.
F

W

ithin one minute after switching off the
ignition, operate the lighting control stalk up
or down, depending on the traffic side (for
example, when parked on the left, move the
lighting control stalk upwards; the right-hand
sidelamps come on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.
Parking lamps Daytime running lamps/
Sidelamps
The front and rear lamps light up automatically
when the engine starts.
They provide the following functions:
-

D
aytime running lamps (lighting control
stalk at position " 0" or " AUTO " with
adequate light level).
-

S
idelamps (lighting control stalk at " AUTO"
position with low light levels or "Sidelamps
only" or "Dipped/main beam headlamps").
The LEDs are brighter when operating as
daytime running lamps.
Lighting and visibility