2018 Peugeot 208 tailgate

12
Warning/indicator lampStateCause Actions/Observations
Door(s) open Fixed, associated with
a


message identifying
the door. One of the doors or the tailgate is
not fully closed (speed below 6


mph
[10


km/h]).
Fixed, associated with
a


message identifying
the door, together with
an audible signal. One of the doors or the tailgate is
not fully closed (speed above 6
mph
[10


km/h]).
Seat belt not
fastened/
unfastened Fixed or flashing
accompanied by an
audible signal. A seat belt has not been fastened or
has been unfastened.
Parking brake Fixed. The parking brake is applied or not
properly released.
Brakes Fixed. The brake fluid level has dropped
significantly. Carry out (1), then top up with brake fluid that complies
with the manufacturer's recommendations. If the
problem persists, carry out (2).
+ Fixed.
The electronic brake force
distribution (EBFD) system is faulty. Carry out (1) and then (2).
Instruments

32
Reinitialising the remote
control
Following replacement of the battery or in
the event of a remote control fault, it may be
necessary to reinitialise the remote control.
F

S
witch off the ignition.
F

T
urn the key to position 2

(Ignition on).
F

P
ress the closed padlock button for a few
seconds.
F

S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Boot
Opening
F After unlocking the boot or the vehicle using the remote control or the key, press
the opening control, then raise the tailgate.
Closing
F Lower the tailgate using the interior grab handle.
F

I
f necessary, press down on the tailgate to
fully close it.
If the tailgate is not fully closed:
-

w
ith the engine running ,
this warning lamp comes on,
accompanied by the display of an
alert message for a
few seconds,
-

w
hen driving (speed above 6
mph
(10
km/h)), this warning lamp comes on,
associated with an audible signal and
the display of an alert message for a
few
seconds. In the event of a
fault or difficulties felt in
manoeuvring the tailgate when opening
or closing it, have it quickly checked
by a PEUGEOT dealer or a qualified
workshop to stop this issue getting worse
and so as to not cause the tailgate to drop,
and serious injuries.
Backup control
System for mechanical unlocking of the boot in
the event of a central locking malfunction.
Unlocking
F Fold the rear seats to gain access to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the boot.
F

M
ove the latch to the left.
Access

100
Reversing camera
The reversing camera is activated automatically
when reverse gear is engaged.
The image is displayed on the touch screen.
The reversing camera function may be
supplemented with parking sensors.
The superimposed representation of guide
lines helps with the manoeuvre.
They are represented as lines marked "on the
ground" and do not indicate the position of the
vehicle in relation to tall obstacles (e.g. other
vehicles).
Some distortion of the image is normal.
The blue lines 1 represent the general direction of
t he vehicle (the distance between them represents
the width of your vehicle without the door mirrors).
The red line 2
represents a distance of about
30
cm beyond the edge of your vehicle's rear
b u m p e r.
The green lines 3
represent distances of about
1
and 2 metres beyond the edge of your vehicle's
rear bumper.
The reversing camera cannot, in any circumstances,
replace the need for vigilance on the part of the driver.
High-pressure jet wash
When washing your vehicle, do not direct
the lance from less than 30
cm from the
lens of the camera.
Opening the tailgate causes the display to
disappear.
Clean the reversing camera regularly
using a
soft, dry cloth.
Park Assist
The system detects a parking space and then
p rovides assistance with the parallel parking
manoeuvres.
The Park Assist system cannot in any
circumstances replace the need for vigilance on
the part of the driver.
The driver must remain in control of their vehicle
ensuring that the space remains clear during the
manoeuvre.
In some circumstances, the sensors may not
detect small obstacles located in their blind spots.
During manoeuvring phases, the steering
wheel per forms rapid turns: do not hold
the steering wheel, do not put your hands
between the spokes of the steering wheel.
Watch out for any object that could block
the manoeuvre (loose clothing, scar ves,
ties, etc.) – Risk of injury!
It controls the steering and provides visual and
audible information to the driver.
If you have a
manual gearbox, the driver
manages the acceleration, braking, gears and
clutch.
With an automatic gearbox, the driver manages
the acceleration, braking and gears.
The driver can take control at any time by
gripping the steering wheel.
Driving

120
Through the fuel filler flap
(1.5 litre BlueHDi Euro 6.2)
F Refit the blue cap to the tank filler and turn it
1/6 of a turn clockwise, to its stop.
F

C
lose the fuel filler flap.
Do not dispose of AdBlue
® bottles or
containers in the household waste.
Place them in a

suitable container or
take them to your dealer.
F

D

epending on equipment, return the spare
wheel and/or the storage box to the bottom
of the boot.
F

R

efit the boot carpet and close the tailgate.
Important:
-

T

o avoid over flowing the AdBlue
® tank,
it is recommended:
•

T

o top up between 10

and 13

litres
using AdBlue
® containers.
Or
•

I

f filling in a

ser vice station, stop
after the first automatic shut-off of
the nozzle.
-
I

f your vehicle's AdBlue
® tank is
completely empty – which is confirmed
by the alert messages and the
impossibility of starting the engine –
you must add at least 5

litres.
After refilling
Through the boot (1.6 BlueHDi
E u r o 6 .1)
F Refit the blue cap to the tank filler and turn it
1/6 of a turn clockwise, to its stop.
F

R
efit the black cap and turn it a quarter of
a
turn clockwise without pressing. Ensure
that the indicator on the cap lines up with
the indicator on the support.
Practical information

133
Third brake lamp
F Unscrew the fixing pins on each side of the lamp unit, without removing them
completely.
F

P
ush on the screws to unclip the lamp unit.
F

D
isconnect the lamp unit connector.
F

R
emove the lamp unit from the outside.
F

T
urn the bulb holder corresponding to the
faulty bulb a
quarter turn and pull it out.
F

P
ull the bulb out and change it.
To refit, carry out these operations in reverse
o r d e r.
Number plate lamps
To facilitate removal, per form this procedure
with the tailgate half open.
F

I
nsert a thin screwdriver into the cut-out
outside the lens.
F

P
ush it outwards.
F

R
emove the lens.
F

R
eplace the faulty bulb.
To refit, press the lens to clip it in.
Foglamp
Make sure to engage the lamp unit in its guides
while keeping it in line with the vehicle.
Tighten sufficiently to ensure sealing, but
without damaging the lamp.
For access, pass your hand under the bumper.
F

T
urn the bulb holder a quarter turn and pull
it out. F
D isconnect the bulb connector.
F

P
ull the bulb out and change it.
To refit, carry out these operations in reverse
o r d e r.
For the replacement of these bulbs, you can
also contact a
PEUGEOT dealer or a qualified
workshop.
Changing a fuse
Access to the tools
The extraction tweezers are fitted to the back
of the dashboard fusebox cover or glove box
fusebox cover.
Dashboard
8
In the event of a breakdown