2016 Citroen C4 CACTUS Owner's Manual

47
Secondary control
Driver's door (locking/unlocking)
Insert the key in the lock to lock or unlock the door.
For
  mechanically   locking   and   unlocking   the  
d

oors   in   the   event   of   a   fault   with   the   central  
l

ocking   system   or   a   battery   failure.
Front and rear passenger doors
Locking
In the event of a fault with the central
locking
 
system,
 
it
 
is
 
essential
 
to
 
d

isconnect
 
the
 
battery
 
to
 
lock
 
the
 
boot
 
a

nd
 
so
 
ensure
 
complete
 
locking
 
of
 
the
 
v

ehicle.
On  the   rear   doors,   check   that   the   child  
l

ock   is   not   on.
F
 
R
emove   the   black   cap   located   on   the   edge  
o

f   the   door,   using   the   key.
F
 
I
nsert   the   key   into   the   aperture   without  
f

orcing,   then   without   turning,   move   the  
l

atch   sideways   towards   the   inside   of   the  
d

o o r.
F
 
R
emove   the   key   and   refit   the   cap.
Unlocking
F
 
P
ull   the   interior   door   opening   control   lever.
2
Access

48
Boot
Opening
F After  unlocking   the   boot   (using   the   remote  c
ontrol),   press   the   opening   control   and  
r

aise   the   tailgate. F
 L ower   the   tailgate   using   the   interior   grab  han
dle.
ClosingBoot release
Unlocking
F Fold  the   rear   seat   backrest   to   gain   access  t
o   the   lock   from   inside   the   boot.
F
 
I
nsert   a   small   screwdriver   into   hole   A of the
lock
  to   unlock   the   tailgate.
For
  mechanically   unlocking   the   boot   in  
t

he   event   of   a   battery   or   central   locking  
m

alfunction.
If
 
the
 
tailgate
 
is
 
not
 
fully
 
closed:
-
 e
ngine running
,
 
a
 
message
 
appears
 
in
 t
he screen,
-
 
v

ehicle moving ,
 
a
 
message
 
appears
 
in
 
t

he
 
screen,
 
accompanied
 
by
 
an
 
audible
 
s

ignal.
For
 
more
 
information
 
on
 
the
 
remote
 
control,
 r
efer
 
to
 
the
 
corresponding
 
section.
Access

49
Front electric window controls
The electric window switches remain   operational   for   approximately  
4

5 seconds   after   the   ignition   is  
s

witched   off   or   until   a   front   door  
i

s   opened.   If,   during   this   period   of  
4

5 seconds,   you   open   a   door   while  
o

perating   a   window,   the   window   stops.  
T

he   window   switch   will   then   only   be  
o

perative   after   the   ignition   is   switched  
o

n   again.
1.
 F

ront
 
left
 
electric
 
window
 
switch.
2.
 F

ront
 
right
 
electric
 
window
 
switch.
F
 
P

ress
 
the
 
switch
 
to
 
open
 
the
 
window.
F
 
P

ull
 
the
 
switch
 
to
 
close
 
the
 
window.
The
 
window
 
stops
 
when
 
you
 
release
 
the
 
switch. Always
  remove   the   key   from   the   ignition  
w

hen   leaving   the   vehicle,   even   for   a  
s

hort   time.
In
  the   event   of   contact   during   operation  
o

f   the   windows,   reverse   the   movement  
o

f   the   window.   To   do   this,   press   the  
c

orresponding
 s
witch.
When
  the   driver   operates   the  
p

assenger   electric   window   switch,   they  
s

hould   ensure   that   no   one   is   preventing  
c

orrect   closing   of   the   window.
The
  driver   should   ensure   that   the  
p

assenger   uses   the   electric   window  
c

o r r e c t l y.
Be
  particularly   aware   of   children   when  
o

perating
 t
he
 w
indows.
Rear door windows
Opening
Closing
F Tilt   the   lever   outwards.
F  P ush   it   fully   to   secure   the   window   in   the  
ope

n
 p
osition.
F
 
P
ull   the   lever   to   release   the   window.
F
 
T
ilt   the   lever   fully   inwards   to   secure   the  
w

indow   in   the   closed   position.
Each
  window   can   be   hinged   open   to   provide  
v

entilation   at   the   rear   seats.
2
Access

50
Front seats
F Raise the control A  and   slide   the   seat  f
or wards   or   backwards. F
P ull the control C   upwards   to   raise   the   seat  o
r   push   it   downwards   to   lower   it,   as   many  
t

imes   as   required,   to   obtain   the   desired  
p

osition.
F
 T urn   the   knob   B   to   adjust   the   backrest.
Forwards-backwards
Height
Seat backrest angle
Adjustments
(driver only)
As a safety measure, adjustments to the driver's seat must only be done when stationary.
B efore   moving   the   seat   backwards,   ensure   that   there   is   nothing   that   might   prevent   the   full   travel   of   the   seat,   so   as   to   avoid   the   risk   of   of   jamming  
t

he   seat   caused   by   the   presence   of   objects   on   the   floor   behind   the   seat   or   rear   passengers.   If   the   seat   jams,   stop   the   movement   immediately.
Ease of use and comfort

51
F To  raise   the   head   restraint,   pull   it   upwards.
F  T o   remove   the   head   restraint,   press   the  
lug
  A   and   pull   the   head   restraint   upwards.
F
 
T
o   put   the   head   restraint   back   in   place,  
e

ngage   the   head   restraint   stems   in   the  
o

penings   keeping   them   in   line   with   the   seat  
b

ack.
F
 
T
o   lower   the   head   restraint,   press   the   lug   A
and
  the   head   restraint   at   the   same   time.The
  head   restraint   has   a   frame   with  
n

otches
 
which
 
prevents
 
it
 
from
 
lowering;
 t

his   is   a   safety   device   in   case   of   impact.
The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.
Never
  drive   with   the   head   restraints  
r

emoved;   they   must   be   in   place   and  
adj

usted
 c
orrectly.
Head restraint height
3
Ease of use and comfort

52
Folding the backrest
F Move  the   front   seats   for ward   if   necessary.
F  P osition   the   seat   belts   on   the   backrest   and  
b

uckle   them.
F
 
P
lace   the   head   restraints   in   the   low  
p

osition. With
  a   one-piece   folding   backrest:
F P ress both controls 1   simultaneously   to  
r

elease   the   seat   backrest   2.
F
 
F
old   the   seat   backrest   2   onto   the   cushion.
Rear seatsBench seat with fixed one-piece cushion and folding one-piece backrest, or a bench seat with a one-piece cushion and 1/3 -2/3 split backrests to vary the   boot   load   space.
When
  folding   the   seat,   the   centre   seat  
b

elt   should   not   be   buckled   but   laid   out  
f

lat   on   the   seat.With
  a   1/3   -   2/3   split   folding   backrest:
F
 
P
ress   the   corresponding   control   1 to
release
  the   backrest   2.
F
 
F
old   the   seat   backrest   2   onto   the   cushion.
The
  rear   seat   cushion   remains   fixed.   To  
i

ncrease   the   boot   volume,   fold   the   seat  
b

ackrest   onto   the   cushion.
Ease of use and comfort

53
Repositioning the seat backrest
F Straighten  the   seat   backrest   2  and   secure   it.
F  U nfasten   and   return   the   seat   belts   to   the  
s

ides   of   the   backrest.
When
  repositioning   the   backrest,  
e

nsure that the seat belts are not
trapped
  and   the   red   indicator,   located  
n

ext   to   the   controls   1,
  is   no   longer  
vis

ible.
Rear head restraints
They can be removed and are interchangeable side   to   side.
To
  remove   a   head   restraint:
F
 
P
ull   the   head   restraint   upwards   to   the   stop.
F
 
T
hen,   press   the   lug   A. Never
  drive   with   the   head   restraints  
r

emoved;   they   must   be   in   place   and  
a

djusted   to   the   normal   position   (up).
These
  have   one   position   for   use   (up)   and   a  
s

towed   position   (down).
To   refit   a   head   restraint:
F
 
E
ngage   the   head   restraint   rods   in   the  
a

pertures,  
k
eeping  
t
he  
h
ead  
r
estraint  
i
n  
l
ine  
w

ith   the   seat   backrest.
To
  lower   a   head   restraint:
F
 
P
ress   down   on   the   head   restraint   and   on  
l

ug   A   at   the   same   time.
3
Ease of use and comfort

54
Mirrors
Each fitted with an adjustable mirror glass providing   the   lateral   rear ward   vision   necessary  
f

or   overtaking   or   parking.   They   can   also   be  
f

olded   for   parking   in   confined   spaces.
Door mirrors
Demisting - Defrosting
F Move control A  to   the   right   or   to   the   left   to  s
elect   the   corresponding   mirror.
F
 
M
ove   control   in   all   four   directions   to   adjust.
F
 
R
eturn   control   to   the   central   position. Demisting-defrosting
  of   the   door  
m

irrors   operates   with   the   engine  
r

unning,   by   switching   on   the   heated  
re

ar
 sc
reen.
Electric adjustment
The objects observed are, in reality, c
loser   than   they   appear.
Take
  this   into   account   in   order   to  
c

orrectly   judge   the   distance   of   vehicles  
a

pproaching   from   behind.
Manual folding
You can fold the mirrors manually (tight parking space, nar row g arage...).
F
 
T
urn   the   mirror   towards   the   vehicle.
As
  a   safety   measure,   the   mirrors   should  
b

e   adjusted   to   reduce   the   "blind   spots".For
  more   information   on   demisting   and  
d

efrosting   the   rear   screen,   refer   to   the  
c

orresponding
 s
ection.
Ease of use and comfort