2016 Citroen C4 CACTUS low beam

13
Operation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.
I t   may   be   accompanied   by   an   audible   signal   and   a   message   in   the   screen.
Left-hand
direction indicatorflashing with buzzer.The   lighting   stalk   is   pushed   down.
Right-hand
direction indicatorflashing with buzzer.The   lighting   stalk   is   pushed   up.
Sidelamps fixed. The
  lighting   stalk   is   in   the  
"

Sidelamps"
 p
osition.
Dipped beam
headlamps fixed.
The
  lighting   stalk   is   in   the   "Dipped  
b

eam   headlamps"   position.
Main beam
headlamps fixed.
The
  lighting   stalk   is   pulled   towards  
yo

u. Pull
  the   stalk   to   return   to   dipped   beam   headlamps.
Front foglamps fixed. The
  front   foglamps   are   switched   on  
u

sing   the   ring   on   the   lighting   control  
st

alk. Turn
  the   ring   on   the   lighting   control   stalk   rear ward  
t

wice   to   switch   off   the   front   foglamps.
For
 
more
 
information
 
on
  the   lighting   controls,   refer   to   the   corresponding   section.
Warning / indicator lamp
StateCause Action / Observations
1
Instruments

79
Lighting control
Main lighting
The various front and rear lamps of the vehicle are   designed   to   adapt   the   driver's   visibility  
p

rogressively   according   to   the   climatic  
c

onditions:
-
 
s
idelamps,   to   be   seen,
-
 
d
ipped   beam   headlamps   to   see   without  
d

azzling
 o
ther
 d
rivers,
-
 
m
ain   beam   headlamps   to   see   clearly   when  
t

he   road   is   clear.
Additional lighting
Other lamps are provided to meet the requirements   of   particular   driving   conditions:
-
 
a
  rear   foglamp,
-
 
f
ront   foglamps   with   cornering   lighting,
-
 
d
aytime   running   lamps   to   be   more   visible  
d

uring   the   day,
-
 
g
uide-me-home   lighting   to   facilitate   your  
e

xit   from   the   vehicle,
-
 
p
arking   lamps   as   vehicle   position   markers.
In
  the   event   of   the   failure   of   one   or   more  
b

ulbs,   a   message   advises   you   to   check  
t

he   lamp(s)   in   question.Travelling abroad
The design of the dipped beam headlamps   allows,   without   modification,  
d

riving   in   a   country   that   drives   on   the  
o

ther   side   of   the   road   to   the   country   in  
w

hich   your   vehicle   was   sold.
4
Lighting and visibility

82
In good or rainy weather, both day and   night,   the   front   foglamps   and   the  
r

ear   foglamp   are   prohibited.   In   these  
s

ituations,   the   power   of   their   beams  
m

ay   dazzle   other   drivers.   They   should  
o

nly   be   used   in   fog   or   snow.
In
  these   weather   conditions,   it   is   your  
r

esponsibility   to   switch   on   the   foglamps  
a

nd   dipped   beam   headlamps   manually  
a

s   the   sunshine   sensor   may   detect  
s

ufficient   light.
Do
  not   forget   to   switch   off   the   front  
f

oglamps   and   the   rear   foglamp   when  
t

hey   are   no   longer   necessary.Switching off the lamps when
the ignition is switched off
On switching off the ignition, all of the lamps   turn   off   immediately,   except   for  
d

ipped   beam   if   guide-me-home   lighting  
i

s   activated.
Switching on the lamps
after the ignition is
switched off
To reactivate the lighting control, rotate the   ring   to   the   "0"  position   -   lamps   off,  
t

hen   to   the   desired   position.
On
  opening   the   driver's   door   a  
t

emporary   audible   signal   warns   the  
d

river   that   the   lighting   is   on.
The
  lamps,   with   the   exception   of   the  
s

idelamps,   switch   off   automatically   after  
a

  maximum   duration   of   thirty   minutes   to  
p

revent   discharging   of   the   battery.
Direction indicators
F Left:  lower   the   lighting   stalk   passing   the  p
oint   of   resistance.
F
 
R
ight:   raise   the   lighting   stalk   passing   the  
p

oint   of   resistance.
Three flashes of the direction
indicators
F Press  briefly   upwards   or   downwards,  w
ithout   going   beyond   the   point   of  
r

esistance;   the   direction   indicators   will  
f

lash   3   times.
Lighting and visibility

84
Parking lamps
Side markers for the vehicle by illumination of the   sidelamps   on   the   traffic   side   only.
F
 
D
epending   on   version,   within   one   minute  
o

f   switching   off   the   ignition,   operate   the  
l

ighting   control   stalk   up   or   down   depending  
o

n   the   traffic   side   (for   example:   when  
p

arking   on   the   left;   lighting   control   stalk  
u

pwards;   the   right   hand   sidelamps   are   on).
This
  is   confirmed   by   an   audible   signal   and  
i

llumination   of   the   corresponding   direction  
i

ndicator   warning   lamp   in   the   instrument   panel.
To
  switch   off   the   parking   lamps,   return   the  
l

ighting   control   stalk   to   the   central   position.
Daytime running lamps / Sidelamps
(LEDs)
The light-emitting diodes (LEDs) come on automatically   when   the   engine   is   started.
In
  some   weather   conditions   (e.g.   low  
t

emperature   or   humidity),   the   presence  
o

f   misting   on   the   internal   sur face   of   the  
g

lass   of   the   headlamps   and   rear   lamps  
i

s   normal;   it   disappears   after   the   lamps  
h

ave   been   on   for   a   few   minutes.They
  provide   the   following   functions:
-  D aytime   running   lamps   (lighting   control  
s

talk   in   position   "0 " or " AUTO " with
adequate
  light   level).
-
 
S
idelamps   (lighting   control   stalk   in  
p

osition "AUTO"
  with   low   light   level   or  
"

Sidelamps   only"   or   "Main   or   dipped   beam  
h

eadlamps").The
  LEDs   are   brighter   when   operating  
a

s   daytime   running   lamps.
Lighting and visibility

86
Cornering lighting
With dipped or main beams, this system makes   use   of   the   beam   from   a   front  
f

oglamp   to   illuminate   the   inside   of   a   bend,  
w

hen   the   vehicle   speed   is   below   25   mph  
(

approximately 40   km/h)   (urban   driving,   winding  
r

oad,   intersections,   parking   manoeuvres...).With cornering l
ighting
Without cornering
 l
ighting
Switching on
This system starts:
-  w hen   the   corresponding   direction   indicator  
i

s   switched   on,


or
-
 
f
rom   a   certain   angle   of   rotation   of   the  
s

teering
 w
heel.
Switching off
The system does not operate:
-  b elow   a   certain   angle   of   rotation   of   the  
s

teering
 w
heel,
-
 
a
bove   25   mph   (40   km/h),
-
 
w
hen   reverse   gear   is   engaged.
Lighting and visibility

121
When towing
Distribution of loads
F Distribute  the   load   in   the   trailer   so   that   the  h
eaviest   items   are   as   close   as   possible   to  
t

he   axle   and   the   nose   weight   approaches  
t

he   maximum   permitted   without  
e

xceeding it.
Air
  density   decreases   with   altitude,   thus  
r

educing   engine   per formance.   Above  
1 0

00 metres,   the   maximum   towed   load   must  
b

e   reduced   by   10 %   for   every   1 000   metres   of  
al

titude.
For
  more   information   on   weights   (and   the  
t

owed   loads   which   apply   to   your   vehicle)   refer  
t

o   the   corresponding   section.
Side wind
F Take  into   account   the   increased   sensitivity  t
o   side   wind.
Cooling
Towing a trailer on a slope increases the temperature   of   the   coolant.
As
  the   fan   is   electrically   controlled,   its   cooling  
c

apacity   is   not   dependent   on   the   engine   speed.
F
 
T
o   lower   the   engine   speed,   reduce   your  
s

peed.
The
  maximum   towed   load   on   a   long   incline  
d

epends   on   the   gradient   and   the   ambient  
t

emperature.
In
  all   cases,   keep   a   check   on   the   coolant  
t

emperature. F
 
I
f   the   warning   lamp   and   the  
S

TOP
 
warning   lamp   come   on,  
s

top   the   vehicle   and   switch   off  
t

he   engine   as   soon   as   possible.
Braking
Towing a trailer increases the braking distance.
T o   avoid   overheating   of   the   brakes,   the   use   of  
e

ngine   braking   is   recommended.
Ty r e s
F Check  the   tyre   pressures   of   the   towing  v
ehicle   and   of   the   trailer,   observing   the  
re

commended
 p
ressures.
Lighting
F Check  the   electrical   lighting   and   signalling  o
n   the   trailer   and   the   hadlamp   beam   height  
o

f   your   vehicle.
For
  more   information   on   adjusting   the  
h

eadlamp   beam   height,   refer   to   the  
c

orresponding
 s
ection.
The
  rear   parking   sensors   will   be  
d

eactivated   automatically   if   a   genuine  
C

ITROËN   towbar   is   used.
6
Driving

198
Changing a bulb
Front lamps
1. Daytime  running   lamps   /   Sidelamps  (LE
Ds).
2.
 D

ipped   beam   headlamps   (H7).
3.
 M

ain   beam   headlamps   (H1).
4.
 D

irection   indicators   (PY21W).
5.
 F

ront   foglamps   (PS24W). In
  some   weather   conditions   (e.g.   low  
t

emperature   or   humidity),   the   presence  
o

f   misting   on   the   internal   sur face   of   the  
g

lass   of   the   headlamps   and   rear   lamps  
i

s   normal;   it   disappears   after   the   lamps  
h

ave   been   on   for   a   few   minutes.
The   headlamps   have   polycarbonate  
l

enses   with   a   protective   coating:
F
d
o not clean them using a dr y
or abrasive cloth, nor with a
detergent or solvent product,
F  
u
se   a   sponge   and   soapy   water   or   a  
p

H   neutral   product,
F  
w
hen   using   a   high   pressure   washer  
o

n   persistent   marks,   do   not   keep  
t

he   lance   directed   towards   the  
l

amps   or   their   edges   for   too   long,  
s

o   as   not   to   damage   their   protective  c
oating a nd sea ls.
Changing   a   bulb   should   only   be   done  
a

fter   the   headlamp   has   been   switched  
o

ff   for   several   minutes   (risk   of   serious  
b

urns).
F
 
D
o   not   touch   the   bulb   directly   with  
y

our   fingers,   use   a   lint-free   cloth.
It
  is   imperative   to   use   only   anti-
ultraviolet
  (UV)   type   bulbs   to   avoid  
d

amaging
 t
he
 h
eadlamp.
Always
  replace   a   failed   bulb   with   a  
n

ew   bulb   with   the   same   type   and  
s

pecification.
In the event of a breakdown

208
Dashboard fuses
The two fuseboxes are placed in the lower dashboard,   at   the   glove   box. Fuse
N° Rating
(A) Functions
F01 10Brake   pedal   (switch   2),   Stop   &   Start.
F02 5Headlamp   beam   height   adjuster,   additional   heater   (Diesel),  
p

arking   sensors,   diagnostic   socket,   door   mirrors   (electric  
a

djustment),   Grip   Control.
F03 10Diesel   additive   pump,   electric   power   steering,   clutch   pedal  (
sw i tc h).
F04 5Rain
  and   sunshine   sensor.
F06 10Brake
  pedal   (switch   1),   diagnostic   socket.
F08 5Top
  of   steering   column   contacts   with   steering   mounted   controls.
F10 15Emergency
  call   /   Assistance   call.
F12 5Stop
  &   Start,   ABS,   ESC.
F13 5Parking
  sensors,   reversing   camera
F14 10Electronic
  gearbox,   switch   panel   (below   the   touch   screen  
t

ablet),   air   conditioning,   touch   screen   tablet.
F16 1512
  Volt   socket.
F18 20Radio.
Access to the fuses
F Unclip  the   cover   by   pulling   at   top   left,   then  r
ight.
Left hand fusebox
In the event of a breakdown