Page 38 of 292

36
RCZ_en_Chap01_controle-de-marche_ed01-2015
You can adjust the angle of the screen to one of four defined positions, by repeated presses on the front or back of the control B
. The position
of the screen is memorised on closing.
Adjusting the angle of the screen
The screen opens automatically when the ignition is switched on. It
closes automatically three seconds after switching off the ignition if the
audio and telematics system is switched off.
ACCESS TO THE RETRACTABLE SCREEN
You can open or close the screen at any time, with the ignition on, using\
control A.
-
Press button
A: the screen folds.
-
Press button
A again: the screen opens again.
If you have closed the screen, it will open again automatically:
-
on switching on the audio and navigation system (unless it
had been closed manually while the system was in operation),
-
when an outgoing telephone call is made,
-
when a voice command is given,
-
when a warning message linked with the ST
OP warning lamp
is displayed (P
EUGEOT
Connect Navigation (R
T6)).
Page 41 of 292

39
RCZ_en_Chap02_ouvertures_ed01-2015
Folding the key
F First press this button to fold the key.
LOCATING YOUR VEHICLE
R
EMOTE
CONTROL
PROBLEM
Following disconnection of the vehicle battery, replacement of the
remote control battery or in the event of a remote control malfunction, \
you can no longer unlock, lock or locate your vehicle.
F
First of all, use the key in the lock to unlock or lock your vehicle.
F
Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as
possible.
Reinitialisation
F Switch of f the ignition.
F
T
urn the key to position 2 (Ignition on) .
F
Press the closed padlock immediately for a few seconds.
F
Switch of
f the ignition and remove the key from the ignition switch.
The remote control is fully operational again.
Changing the battery
Battery ref.: CR1620 / 3 volts.
If the battery is flat, you are informed by illumination of this
warning lamp, accompanied by an audible signal and an alert
message in the screen.
F
Unclip the casing using a coin at the notch.
F
Slide the flat battery out of its location.
F
Slide the new battery into its location observing the original
direction.
F
Clip the casing.
F
Reinitialise the remote control.
This function allows you to identify your vehicle from a
distance, particularly in poor light.
Your vehicle must be
locked.
F
Press the closed padlock on the remote control.
This will switch on the courtesy lamps and the direction indicators will\
flash
for
around
ten
seconds.
If you do not press the button when folding the key, there is a risk
of damage to the mechanism.
2/
ACCESS
Page 49 of 292

47
RCZ_en_Chap02_ouvertures_ed01-2015
CLOSING
The window rises automatically after a few seconds and adjusts to
provide perfect sealing when closed.-
when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
CENTRAL LOCKING CONTROL
This control permits simultaneous locking or unlocking of the doors,
boot
lid and fuel filler flap from inside the vehicle.
Locking
F Press this button to lock the vehicle.
The red indicator lamp on the button comes on.
If one of the doors or the boot lid is open, the central locking from
the inside does not take place.
Unlocking
F Press this button again to unlock the vehicle.
The red indicator lamp on the button goes of f.
Locking / deadlocking from the outside
When the vehicle is locked or deadlocked from the outside, the
red indicator lamp flashes and the button is inactive.
F
With normal locking, pull on the interior door control lever to
unlock the vehicle.
F
With deadlocking, you have to use the remote control or the
key to unlock the vehicle.
When washing your vehicle:
-
first
lock
the
vehicle
using
the
remote
control
or
the
key,
-
avoid spraying the upper part of the windows,
-
keep the end of the high pressure nozzle at least 1 metre from
the windows and door seals.
When a door is not closed correctly:
Be aware of the risk of pinching when the window rises
automatically on closing the door
.
-
when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on, accompanied by an audible signal and
a message in the screen for a few seconds.
2/
ACCESS
Page 51 of 292

49
RCZ_en_Chap02_ouvertures_ed01-2015
BOOT
OPENING
F Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.
F
Lift the boot lid.
This
action
also unlocks the doors and the fuel filler flap.
Using the manual control; vehicle unlocked
F Press the opening control above the number plate.
F
Lift the boot lid.
CLOSING
F Lower the boot lid using one of the interior grab handles.
F
If necessary
, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly: -
when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When selective unlocking is activated, the boot can also be
opened by a second press on the open padlock on the remote
control.
Using the remote control
Emergency locking
If the central locking system fails (flat battery), you are advised to disconnect the battery.
-
when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.
Never grasp the boot lid by the active spoiler
.
2/
ACCESS
Page 76 of 292
74
RCZ_en_Chap03_confort_ed01-2015
The duration of lighting varies, depending on the context:
-
when the ignition is of
f, approximately ten minutes,
-
in energy economy mode, approximately thirty seconds,
-
when the engine is running, no limit.
STORAGE BOX
This has areas for storing a box of spare bulbs, a first aid kit, the temporary puncture repair kit, a warning triangle, the removable ball
of the towbar system...
BOOT LAMPS
Your vehicle is fitted with two boot lamps; one in the right-hand boot side trim and a second in the centre under the rear shelf.
They come on automatically when the boot is opened and switch of f
automatically when the boot is closed.
They cannot be deactivated manually.
A second warning triangle can be stored in the boot lid trim.
For access to it:
F raise
the
floor
using
the
strap,
F
secure it in the vertical position behind the stops, located on
the sides of the boot.
Page 82 of 292

80
RCZ_en_Chap04_visibilite_ed01-2015
AUTOMATIC GUId E - ME - HOME
LIGHTING
Operating fault
In the event of a malfunction of the sunshine sensor, the
lighting comes on, this warning lamp is displayed in the
instrument panel and/or a message appears in the screen,
accompanied by an audible signal.
Contact
a
PEUGEOT
dealer or a qualified workshop.
In
fog
or snow, the sunshine sensor may detect sufficient light. In
this case, the lighting will not come on automatically
.
Do not cover the sunshine sensor, coupled with the rain sensor
and located in the centre of the windscreen behind the rear view
mirror; the associated functions would no longer be controlled. When the automatic illumination of headlamps function is activated
(lighting control stalk in the "
AUTO" position), under low ambient light
the dipped beams headlamps come on automatically when the ignition
is switched off.
Programming
Activation or deactivation, as well as the duration of the guide-me-home\
lighting, is set in the vehicle configuration menu.
Page 83 of 292

81
RCZ_en_Chap04_visibilite_ed01-2015
MANUAL AD j USTMENT OF
HALOGEN
HEADLAMPSA UTOMATIC AD j USTMENT OF
xENON
HEADLAMPS
To avoid dazzling other road users, the height of the halogen bulb
headlamps must be adjusted according to the load in the vehicle.
0.
1 or 2 people in the front seats.
-.
3 people.
1.
4 people.
-.
Intermediate setting.
2.
4 people + maximum authorised loads.
-.
Intermediate setting.
3.
Driver + maximum authorised loads. In order to avoid causing a nuisance to other road users, this system
corrects the height of the xenon headlamp beams automatically and
when stationary
, in relation to the load in the vehicle.
If a malfunction occurs, this warning lamp is displayed on the
instrument panel, accompanied by an audible signal and a
message in the screen.
The system then places your headlamps in the lowest position.
Initial setting is position "0". Do not touch the xenon headlamp bulbs.
Contact
a PEUGEOT
dealer or a qualified workshop.
Travelling abroad
If using your vehicle in a country that drives on the other side of
the road, the headlamps must be adjusted to avoid dazzling on-
coming drivers.
Contact
a PEUGEOT
dealer or a qualified workshop.
4/
VISIBILITY
Page 84 of 292
82
RCZ_en_Chap04_visibilite_ed01-2015
DIRECTIONAL LIGHTING
When the dipped or main beam headlamps are on, this function enables
the light beams to provide improved lighting of the side of the road when
cornering.
The use of this function, from approximately 12 mph (20 km/h) and
associated with the xenon headlamps only, considerably improves the
quality
of your lighting when cornering.
with directional lighting
without directional lighting
PROGRAMMING
O
PERATING
F
AULT
When stationary or moving at very low speed or when reverse
gear is engaged, the function is inactive.
The status of the function remains in the memory when the
ignition is switched off.If
a fault occurs, this warning lamp flashes in the instrument
panel, accompanied by a message in the screen.
Contact
a PEUGEOT
dealer or a qualified workshop.
The function is activated or deactivated via the vehicle
configuration menu.