2015 Peugeot Partner Tepee Owner's Manual

87
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
Overhead storage unit
this is located above the sun visors
and can accommodate various objects
(a jumper
, file, gloves...).
t

he openings concealed by the sun
visors allow you to see and access the
objects stored in the overhead storage
unit.
t

he maximum weight permitted in the
overhead storage unit is 5 Kg.
Do not place objects in this storage
unit which could present a risk to the
occupants.
Central storage console
this console offers an appreciable
additional storage area: it can be
removed and clips onto a base which
also incorporates two cup holders at
the rear
.
e

nsure that the object (bottle, can...)
placed in the cup holder is retained
securely and does not risk being
dislodged while driving.
Any liquid which could spill presents
a risk of damage on contact with the
instrument panel and centre console
controls.
take care.
Sun visor
to prevent dazzle from ahead, fold the
sun visor down.
A
pocket is provided in the driver's sun
visor for storing toll cards, tickets, ...
Practical information
eASe OF uSe and COMFORt
4

88
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
Drawers under seats
Your vehicle may be fitted with a
drawer, under each front seat.
Storage compartment under
seats
Storage compartments are available,
with or without lid, in the floor under the
front seats.
to gain access to them, move the seat
forward. t

he lid must be lifted from the
rear of the seat.
Practical information

89
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
SEATING AREA FITTINGS
Floor boxes
two boxes are available, located under
the rear passenger footwells.
T
o open them, slide your fingers into
the recess and lift the lid.
Aircraft style tables
to put the table in place, pull it
upwards and fold it down.
As a safety precaution, above a high
pressure, the table is designed to
unhook.
to put it back in place, with the table
vertical, engage one side then the
other

, forcing slightly.
Do not place hard or heavy objects
on the table.
t

hey could become
dangerous projectiles in the event of
sharp braking or impact.
A bag hook is provided on the side of
each table.
Side blinds
Side blinds may be available on the
sliding side doors.
Pull the side blind by the tab to
install
it.
to avoid damaging the blind when
opening the door

, check that the tab is
hooked securely.
Always guide the blind slowly
using the tab, both when raising
and when lowering.
Practical information
eASe OF uSe and COMFORt
4

90
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
ZENITH ROOF
the multifunction roof extends the
overhead storage unit. It consists of
the following components:
Storage compartments
Storage compartments are provided
on each side of the roof. t he maximum
authorised load is 6 kg.
t

he translucent base assists with
finding objects stored inside.
Do not store objects which could
present a risk to the occupants.
Courtesy lamp
the operation of the courtesy lamp is
identical to that of the front courtesy lamp.
Refer to chapter 4 "Comfort and
Safety", "Courtesy lamps" section.
Practical information

91
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
From insideFrom outside
Rear box
this roof box can be accessed from
the rear seats and the boot.
From the rear seats, slide the flaps
to
open.
Vents
A 3-position control allows you to
adjust the air flow through the vents.
The vents are also fitted with a scented
air freshener.From the boot, place your thumb on the
recess then pull the handle to open.
Open carefully to prevent objects
stored in this interior roof box from
falling out.
t

he maximum authorised load is 10 kg.
Practical information
eASe OF uSe and COMFORt
4

92
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
SCENTED AIR FRESHENER
the scented air freshener diffuses
a fragrance in the passenger
compartment from the roof console
vents.
Adjusting the flow
turn the chromed button to adjust the
dif fusion:
-

to the left to decrease,
-


to the right to increase.
to stop the dif

fusion, turn the chromed
button fully to the left.
Removing the scented air
freshener
- Press the button down while turning
it a quarter of a turn to the left to
the stop.
-

Remove the scented air freshener
from the roof console.
-


Replace the cartridge.
Practical information

93
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
Replacing a cartridge
The scented air freshener refill consists
of a cartridge B and its sealing case C.
-
Remove the protective film
D.
-

Place the head of the cartridge
B
on the button A of the scented air
freshener.
-
t
urn it a quarter of a turn to lock it
on the button and remove the case.
-


Insert the scented air freshener in
its location.
Y

ou can change the cartridges at any
time and store cartridges which have
already been started in their original
case.
t

he scented air freshener button A is
independent of the cartridge.
t

he cartridges are supplied without the
button A.
Inserting the scented air
freshener
After fitting or changing the cartridge:
-

Put the scented air freshener back
in place in its location.
-

t
urn it a quarter of a turn to the
right.
Good practice
As a safety precaution, only use the
cartridges provided for this purpose.
Do not dismantle the cartridges.
Keep the cartridge sealing cases
which are used as packaging when the
cartridges are not in use.
Never try to refill the cartridges
with fragrances other than those
recommended by the P
euge O t

network.
Keep out of reach of children and
animals.

Avoid contact with the skin
and eyes. If swallowed, consult a
doctor and show him the packaging or
product label.t
he scented air freshener button A can
only be fixed on the multifunction roof
console with a cartridge.
t

herefore, always retain button A and
a cartridge.
t

he cartridges are available from
P
euge
O
t
dealers.
Practical information
eASe OF uSe and COMFORt
4

94
Partner_2_VP_en_Chap04_ergonomie_ed02-2014
ZENITH ROOF BARS
the maximum authorised weight on
each roof bar is 35 kg. In all cases, the load must rest on
the non-slip bands provided for this
purpose and must not touch the roof or
the glazing of the roof.
Recommendations for loading the
roof
t
his procedure requires the use of
a spanner supplied with the tools for
changing a wheel.
t
hese two longitudinal Zenith roof bars
can be removed.
Chapter 9, "Changing a wheel"
section.
-

Open the protective covers.
-


Slacken the four screws using the
spanner and remove them.
-

t
urn the bars 90° placing the
hollow parts towards the front.
-


Refit the the 4 screws and tighten
them using the spanner

.
-

Close the protective covers.
-

u se the strap passages A only to
secure the load firmly.
Practical information