Page 770 of 886
7705-2. Steps to take in an emergency
Sounds
once
(Flashes) •When the doors
were unlocked
with the
mechanical key
and then the
“ENGINE
START STOP”
switch was
pressed, the
electronic key
could not be
detected in the
vehicle.
• The electronic
key could not be
detected in the
vehicle even
after the
“ENGINE
START STOP”
switch was
pressed two
consecutive
times. Touch the elec-
tronic key to the
“ENGINE START
STOP” switch
while depressing
the brake pedal.
Sounds
once
(Flashes) An attempt was
made to start the
engine with the
shift lever in an
incorrect position. Shift the shift lever
to P and start the
engine.Interior
buzzer Exterior
buzzer Wa r n i n g m e s s a g e Details Correction
procedure
Page 773 of 886
5
When trouble arises
7735-2. Steps to take in an emergency
Sounds
once
(Flashes) The steering lock
could not be
released within 3
seconds of the
“ENGINE START
STOP” switch
being pressed. Press the
“ENGINE START
STOP” switch
while depressing
the brake pedal
and moving the
steering wheel left
and right.■
Warning message in radar cruise mode (if equipped)
In the following cases, the warning message may not be displayed even if vehicle-
to-vehicle distance decreases: ●
When your vehicle and the vehicle ahead are traveling at the same speed or the
vehicle ahead is traveling more quickly than your vehicle●
When the vehicle ahead is traveling at a very low speed●
Immediately after cruise control speed is set●
At the instant the accelerator pedal is depressedInterior
buzzer Exterior
buzzer Wa r n i n g m e s s a g e Details Correction
procedure
Page 790 of 886

7905-2. Steps to take in an emergency
Emergency start function
When the engine does no t start, the following s teps can be used as an
interim measure to start the engine if the “ENGINE START STOP” switch
is functioning normally:
Set the parking brake.
Shift the shift lever to P.
Turn the “ENGINE START STOP” switch to ACCESSORY
mode.
Press and hold the “ENGINE START STOP” switch for about 15
seconds while depressing the brake pedal firmly.
Even if the engine can be started using the above step s, the system may
be malfunctioning. Have the vehicl e inspected by your Lexus dealer.■ The starter motor does not turn over, the interior lights and head-
lights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem:
● One or both of the battery terminals may be disconnected.
● The battery may be discharged. ( P. 7 9 6 )
● There may be a malfunction in the steering lock system.Contact your Lexus dealer if the problem cannot be repaired, or if
repair procedures are unknown.
STEP 1
STEP 2
STEP 3
STEP 4
Page 791 of 886
5
When trouble arises
7915-2. Steps to take in an emergency
If the shift lever cannot be shifted from P If the shift lever cannot be shifted with your foot on the brake pedal, there
may be a problem with the shift lock system (a system to prevent accidental
operation of the shift lever). Have the vehicle inspected by your Lexus
dealer immediately.
The following steps may be used as an emergency measure to ensure that
the shift lever can be shifted:
Set the parking brake.
Turn the “ENGINE START STOP” switch to ACCESSORY
mode.
Depress the brake pedal.
Pry the cover up with a flathead
screwdriver or equivalent.
Press the shift lock override but-
ton. The shift lever can be shifted
while the button is pressed.STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Page 793 of 886
5
When trouble arises
7935-2. Steps to take in an emergency
If the electronic key do es not operate properly
Locking and unlocking the side doors and key linked functions
Use the mechanical key ( P. 31)
in order to perform the following
operations (driver’s door only):
Locks all the doors
Closes the windows and moon
roof (turn and hold)
Unlocks the door Turning the key rearward unlocks
the driver's door. Turning the key
once again unlocks the other
doors.
Opens the windows and moon
roof (turn and hold)If communication between the electron ic key and vehicle is interrupted
( P. 42) or the electronic key cannot be used because the battery is
depleted, the smart access system with push-button start and wireless
remote control cannot be used. In such cases, the doors can be opened and
the engine can be started by following the procedure below.
Page 797 of 886

5
When trouble arises
7975-2. Steps to take in an emergency
■
Starting the engine when the battery is discharged
The engine cannot be started by push-starting.■
To prevent battery discharge ●
Turn off the headlights and the audio system while the engine is off.●
Turn off any unnecessary electrical compon ents when the vehicle is running at a
low speed for an extended period, such as in heavy traffic.■
When the battery is removed or discharged ●
The power back door must be initialized.
( P. 8 4 7 )●
Make sure that the key is not inside th e vehicle when recharging or replacing
the battery. The key may be locked in the vehicle if the alarm is activated.
( P. 114)■
Charging the battery
The electricity stored in the battery will discharge gradually even when the vehi-
cle is not in use, due to natural discharge and the draining effects of certain
electrical appliances. If the vehicle is left for a long time, the battery may dis-
charge, and the engine may be unable to start. (The battery recharges automat-
ically during driving.) Start the engine of the second vehicle. Increase the engine
speed slightly and maintain that level for approximately 5 min-
utes to recharge the battery of your vehicle.
Open and close any of the do ors with the “ENGINE START
STOP” switch off.
Maintain the engine sp eed of the second ve hicle and start the
engine of your vehicle by tu rning the “ENGINE START STOP”
switch to IGNITION ON mode.
Once the vehicle’s engine ha s started, remove the jumper
cables in the exact reverse ord er from which they were con-
nected.
Once the engine starts, have th e vehicle inspected at your Lexus
dealer as soon as possible. STEP 3
STEP 4
STEP 5
STEP 6
Page 802 of 886
8025-2. Steps to take in an emergency
If the vehicle becomes stuck Carry out the following procedures if the tires spin or the vehicle becomes
stuck in mud, dirt or snow:
Stop the engine. Set the parking brake and shift the shift lever
to P.
Remove the mud, snow or sand from around the front wheels.
Place wood, stones or some ot her material under the front
wheels to help provide traction.
Restart the engine.
AWD models: Activate all-wheel drive lock mode. (
P. 275)
Shift the shift lever to the D or R position and release the park-
ing brake. Then, while exercising caution, depress the acceler-
ator pedal.STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Page 809 of 886
8076-1. Specifications
6
Vehicle specifications Vehicle identification
■ Vehicle identification number
The vehicle identification number (V IN) is the legal id entifier for your
vehicle. This is the primary identification number for your Lexus. It is used
in registering the ownership of your vehicle.
This number is stamped on the top left of the instrument panel. On some mod-
els, this number is also stampe d under the front passenger seat.
This number is also on the Certifi-
cation Label.
■ Engine number
The engine number is stamped on
the engine block as shown.