2015 AUDI S7 flat tire

M N <( (.J
'SI: ,...., \!) 1.1'1 ,...., 1.1'1 ,....,
If you wish to improve comfort
when operating the vehicle at normal load (up to 2/3* occu­
pants), you can adjust tire
pressures to those specified
for normal vehicle load. Before
operating the vehicle at maxi­ mum load, you must increase
the tire pressures to those
specified for maximum vehicle load
c> .&. .
Bear in mind that the tire pres­
sure monitoring system can on­
ly monitor the tire pressures
you have stored. The system does not recognize the load
condition of your vehicle.
The effectiveness of the tire pressure monitoring system
will be impaired if you store normal load pressures but then
operate the vehicle at its maxi­
mum load
c> .&. .
Tires and wheels 249
See the illustration c> fig. 200
for the location of the label on
driver's side B-pillar (color of
the actual label and exact loca­
tion on the vehicle will vary slightly).
Note that the following table is
accurate at the time of going to
press and is subject to change.
In the event of discrepancies,
the tire pressure label is locat­ ed on the driver's side B-pillar
always takes precedence.
The table below lists the rec­ ommended cold tire inflation pressures for the Audi model
covered by your Owner's Litera­
ture at the vehicle's capacity
weight and the tire sizes instal­
led on the respective models as
original equipment , or as a fac-
tory option. ..,.
•
•
'

technically referred to as the
vehicle's Gross Vehicle Weight Rating ("GVWR"). The Gross
Axle Weight Rating ("GAWR") is
the maximum load that can be applied at each of the vehicle's
two axles. The Gross Vehicle
Weight Rating and the Gross
Axle Weight Rating are listed on the safety compliance stick­
er label located on the driver's
side B-pillar. The tire pressure
label on your Audi lists the
maximum combined weight of
all of the occupants and lug­
gage or other cargo that the ve­
hicle can carry. For the location
of the tire pressure label
c> fig . 200.
A WARNING
-
Overloading a vehicle can
cause loss of vehicle control,
a crash or other accident, se­ rious personal injury, and
even death.
-Carrying more weight than your vehicle was designed to carry will prevent the ve­hicle from handling properly
and increase the risk of a
~ loss of vehicle control. <(
~ -The brakes on a vehicle that has been overloaded may
Tires and wheels 251
not be able to stop the vehi­
cle within a safe distance.
- Tires on a vehicle that has
been overloaded can fail
suddenly causing loss of control and a crash.
-Always make sure that the total load being transported
- including the weight of a
trailer hitch and the tongue
weight of a loaded trailer -
does not make the vehicle
heavier than the vehicle's
Gross Vehicle Weight Rat­
ing.
A WARNING
-Incorrect tire pressures
and/or underinflation can
lead to a serious or fatal ac­
cident.
-Incorrect tire pressures and/or underinflation cause
increased tire wear and can
affect the handling of the
vehicle.
-Incorrect tire pressures and/or underinflation can
also lead to sudden tire fail­
ure, including a blowout
and sudden deflation, caus­
ing loss of vehicle control.
•
•
'

252 Tires and wheels
Checking tire pressure
The correct tire pressure for the
tires originally installed on
your vehicle is listed on the tire pressure label located on driv­
er's side 8-pillar.
The recommended tire pres­
sures are on the tire pressure
label and in the table
c::> page 247, Cold tire inflation
pressure. This means that the
pressure must be checked and
adjusted when the tire has not
been driven for more than a
couple of miles (kilometers) at
low speeds during the previous
three hours. Air in the tires ex­
pands when the tire heats up as
a result of internal friction as it
flexes in use . The tire pressure
is higher when the tire has
warmed up than when it is "cold."
It is the inflation pressure in a
"cold" tire that counts. There­
fore, you should never let air
out of a warm tire to match
"Cold tire inflation pressure"
recommendations
c:::> page 247 .
The tires would then be under­
inflated and could fail sudden ­
ly. The tire
pressure label on your
Audi lists the recommended
cold tire inflation pressures at maximum capacity for the new,
original equipment tires that
were on your vehicle at the time
it was manufactured. For the
location of the label
c::> page 247, fig. 200.
Most tires lose air naturally
over time. They can also lose
some air if you drive over a pot­ hole or hit a curb while parking.
It is usually not possible to see
whether the radial tires used
today are underinflated just by
looking at them.
Therefore, be sure to check tire
pressures at least once a month
and always before going on a long trip . Make sure to take the
number of people and the
amount of luggage into ac­ count when adjusting tire pres­
sure for a trip -even one that
you would not consider to be
"long." See
c:::> page 255, Tires
and vehicle load limits for more
important information .
Always use an accurate tire pressure gauge when checking
and adjusting inflation .,.

Tires and wheels 253
pressures. Check all of the tires It is important to check the tire •
and be sure not to forget the pressure when the tires are • '
spare tire. If the pressure in any cold.
tire is too high when the tire is -Read the required tire pres-
"cold," let air out of the tire sure from the tire pressure la-
slowly with the edge of the tire bel. The tire pressure label is
gauge and keep checking the located on the driver's side B-
pressure until you reach the pillar.
pressure that is correct for the -Turn the valve stem cap coun-
load (passengers and luggage) ter-clockwise to remove it
and kind of driving you plan to from the tire valve.
do. -Place the air pressure gauge
If the pressure in any tire is too on the valve.
low, note the difference be- -The tire pressures should only
tween the pressure in the cold be checked and adjusted when
tire and the pressure you need the tires are cold. The slightly
and add the air that you need to
raised pressures of warm tires
reach the correct pressure for must not be reduced.
the vehicle load (passengers -Adjust the tire pressure to the
and luggage) for the tires on load you are carrying.
your vehicle as listed on the on -Reinstall the valve stem cap
your vehicle and in this manual on the valve.
and the kind of driving you plan
When should I check the tire
to do.
pressure?
Never exceed the maximum in-
The correct tire pressure is es-
flation pressure listed on the
pecially important at high
tire sidewall for any reason.
speeds. The pressure should
Remember that the vehicle therefore be checked at least
manufacturer, not the tire man- once a month and always be-
ufacturer, determines the cor- fore starting a journey. Do not
....
M N
rect tire pressure for the tires <( (.J
'SI:
on your vehicle . .... \!) 1.1'1
.... 1.1'1 ....

254 Tires and wheels
forget to check the tire pres-
ure, including a blowout
sure for the spare wheel
and sudden deflation, caus-
¢page 274. ing loss of vehicle control.
When should I adjust the -The driver is responsible for
tire pressures? the correct tire pressures for
Adjust the tire pressure to the all tires on the vehicle. The
applicable pressure values
load you are carrying. After
are located on a sticker on
changing a wheel
or replacing
the driver's side B-pillar.
wheels you have to adjust the
-Only when all tires on the
tire pressures on all wheels. In
vehicle are filled to the car-
addition, you must then store
rect pressure, the tire pres-
the new tire pressures in the
sure monitoring system can
tire pressure monitoring sys-
work correctly.
tern
¢ page 270.
-The use of incorrect tire
A WARNING
-pressure values can lead to
Incorrect tire pressures and/
accidents or other damage.
or underinflation can lead Therefore it is essential that
sudden tire failure, loss of the driver observe the speci-
control, collision, serious per- fied tire pressure values for
sonal injury or even death. the tires and the correct
-When the warning symbol pressures for the function of
[IJ appears in the instru-
the tire pressure monitoring
ment cluster, stop and in-
system.
spect the tires. -Always inflate tires to the
-Incorrect tire pressure and/ recommended and correct
or underinflation can cause tire pressure before driving
increased tire wear and can off.
affect the handling of the -Driving with underinflated
vehicle and stopping ability. tires bend more, letting
-Incorrect tire pressures them get too hot resulting
and/or underinflation can in tread separation, sudden
..
also lead to sudden tire fail-

M N <( (.J
'SI: ,...., \!) 1.1'1 ,...., 1.1'1 ,....,
tire failure and loss of
control.
-Excessive speed and/over­ loading can cause heat
build -up, sudden tire failure
and loss of control.
-If the tire pressure is too low or too high, the tires
will wear prematurely and
the vehicle will not handle
well.
-If the tire is not flat and you do not have to change a
wheel immediately, drive at
reduced speed to the near­
est service station to check
the tire pressure and add air as required.
(D Note
Driving without valve stem
caps can cause damage to
the tire valves. To prevent
this, always make sure that
factory installed valve stem caps on all wheels are secure­
ly mounted on the valve.
@ For the sake of the environment
Underinflated tires will also
increase the fuel consump­
tion.
Tires and wheels 255
Tires and vehicle load limits
'
There are limits to the amount of load or weight that any vehi­
cle and any tire can carry. Ave­
hicle that is overloaded will not
handle well and is more diffi­
cult to stop. Overloading can
not only lead to loss of vehicle
control, but can also damage important parts of the vehicle
and can lead to sudden tire fail­
ure, including a blowout and
sudden deflation that can cause
the vehicle to crash.
Your safety and that of your passengers also depends on
making sure that load limits are
not exceeded. Vehicle load in­
cludes everybody and every­
thing in and on the vehicle .
These load limits are technical­ ly referred to as the vehicle's
Gross Vehicle Weight Rating
("GVWR").
The "GVWR" includes the
weight of the basic vehicle, all
factory installed accessories, a
full tank of fuel, oil, coolant and other fluids plus maximum ""
•
•
'

and increase the risk of the loss of vehicle control.
-The brakes on a vehicle that
has been overloaded may
not be able to stop the vehi­
cle within a safe distance.
-Tires on a vehicle that has
been overloaded can fail
suddenly, including a blow­
out and sudden deflation,
causing loss of control and a
crash.
-Always make sure that the total load being transported - including the weight of a
trailer hitch and the tongue
weight of a loaded trailer - does not make the vehicle heavier than the vehicle's
Gross Vehicle Weight Rat­
ing .
Determining correct load
limit
Use the example below to cal­
culate the total weight of the
passengers and luggage or oth­
er things that you plan to trans­
port so that you can make sure
that your vehicle will not be
~ overloaded.
Tires and wheels 257
Steps for Determining
Correct Load Limit
1. Locate the statement "THE
COMBINED WEIGHT OF OC­
CUPANTS AND CARGO
SHOULD NEVER EXCEED XXX KG OR XXX LBS" on your ve­
hicle's placard (tire inflation
pressure label)
¢ page 247,
fig. 200.
2. Determine the combined
weight of the driver and pas­sengers that will be riding in
your vehicle.
3. Subtract the combined
weight of the driver and pas­
sengers from
"XXX" kilo­
grams or
"XXX" pounds
shown on the sticker
¢ page 247, fig. 200.
4. The resulting figure equals the available amount of car­go and luggage load capaci­
ty. For example, if the
"XXX"
amount equals 1400 lbs.
and there will be five 150 lbs. passengers in your vehi­
cle, the amount of available
cargo and luggage load ca­
pacity is 650 lbs. (1400-7 50
(5
X 150) = 650 lbs.)
5. Determine the combined
weight of luggage and cargo ""
•
•
'

M N <( (.J
'SI: ,...., \!) 1.1'1 ,...., 1.1'1 ,....,
No. Description
® Load index and speed rat-
1ng
0 U.S. DOT tire identifica-
tion number
® Audi Original tire
® Sever snow conditions
@ Tire ply composition and materials used
@ Maximum load rating
@ Treadwear, traction and
temperature grades
@ Maximum permissible in-
flation pressure
The tires and rims are essential parts of the vehicle's design.
The tires and rims approved by
Audi are specially matched to
the characteristics of the vehi­ cle and can make a major con­
tribution to good road holding and safe handling when in good
condition and properly inflated
¢ &.
We recommend that all work
on tires and wheels be per­
formed by an authorized Audi dealer. They are familiar with
recommended procedures and
have the necessary special tools
and spare parts as well as the
Tires and wheels
proper facilities for disposing of
the old tires.
Authorized Audi dealers have
the necessary information about technical requirements
for installing or changing tires and rims.
Replacing tires and wheels
Tires should be replaced at least in pairs and not individu­
ally (for example both front
tires or both rear tires togeth­ er).
Be sure to read and heed the in­
formation to the tire pressure
monitoring system
¢ page 270 .
Always buy replacement radial
tires that have the same specifi­
cations as the tires approved
for your vehicle by Audi. Re­ placement tires must always
have the same load rating spec­
ification as the original equip­
ment or approved optional tires
listed in the table
¢ page 247.
Audi-approved specification
tires are specially matched to
your vehicle and its load limits, and can contribute to the im­portant roadholding , driving
261
•
•
'