2014 NISSAN TEANA tow

TM-254
< ECU DIAGNOSIS INFORMATION >[CVT: RE0F10E]
TCM
NONMMODEDriving with manual mode Off
Other than the above On
MMODE Driving with manual mode On
Other than the above Off
TOW MODE SW Always Off
SHIFT IND SIGNAL When the selector lever is positioned in be-
tween each position. OFF
Selector lever: P position P
Selector lever: R position R
Selector lever: N position N
Selector lever: D position D
Manual mode: 1st 1st
Manual mode: 2nd 2nd
Manual mode: 3rd 3rd
Manual mode: 4th 4th
Manual mode: 5th 5th
Manual mode: 6th 6th
Manual mode: 7th 7th
Manual mode: 8th 8th
CVT LAMP Approx. 2 seconds after ignition switch ON On
Other than the above Off
SPORT MODE IND Always Off
MANU MODE SIGNAL Driving with manual mode On
Other than the above Off
DS RANGE SIGNAL Selector lever in DS position On
Other than the above Off
ECO MODE SIGNAL Always Off
VDC ON Always Off
TCS ON Always Off
ABS FAIL SIGNAL When ABS malfunction signal is received On
Other than the above Off
ABS ON ABS is activated On
Other than the above Off
RANGE Selector lever: P and N positions N/P
Selector lever: R position R
Selector lever: D position D
Selector lever: DS position S
M GEAR POS Manual mode: 1st – 7th 1 to 7
G SEN SLOPE Flat road 0%
Uphill gradient The value changes to the positive side
along with uphill gradient. (Maximum
40.45%)
Downhill gradient The value changes to the negative side
along with downhill gradient. (Minimum
40.45%)
Monitor item Condition Value/Status (Approx.)
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM

WW-64
< REMOVAL AND INSTALLATION >
FRONT WIPER DRIVE ASSEMBLY
FRONT WIPER DRIVE ASSEMBLY
Exploded ViewINFOID:0000000009464642
Removal and InstallationINFOID:0000000009464643
REMOVAL
1. Remove the cowl top. Refer to EXT-24, "Removal and Installation".
2. Remove the strut tower bar. Refer to FSU-19, "Exploded View"
.
3. Disconnect the harness connector from the wiper drive assembly.
4. Remove the wiper drive assembly bolts.
5. Remove the wiper drive assembly.
INSTALLATION
1. Install the wiper drive assembly.
2. Install the wiper drive assembly bolts.
3. Connect the harness connector to the wiper drive assembly.
4. Install the strut tower bar. Refer to FSU-19, "Exploded View"
.
5. Install the cowl top. Refer to EXT-24, "Removal and Installation"
.
6. Check that the wiper blades stop at the specified position. Refer to WW-60, "WIPER BLADE : Adjust-
ment".
1. Wiper blade (LH) 2. Wiper blade (RH) 3. Wiper arm (RH)
4. Wiper drive assembly 5. Wiper arm (LH)
ALLIA1173ZZ
Revision: November 20132014 Altima NAMRevision: November 20132014 Altima NAM