Handling of Discs8-16 For pleasant driving
8
zFingerprints or other marks on the readsurface of the disc may result in its con-tent being more difficult to read. Whenholding the disc, grip both edges, or oneedge and the centre hole, in order that theread surface is not touched. zDo not affix paper or stickers, or other-wise damage the disc. zDo not forcefully insert a disc if another isalready within the device. This can resultin damage to discs, or malfunction. zPeriodically clean the read surface of thedisc. When cleaning, do not wipe in a cir-cular motion. Instead, wipe gently out-wards from the centre of the disc to theouter edge. zNew discs may have burring around theouter edge or in the hole in the centre.Ensure you check for these. If there areburrs, these may lead to faulty operation,therefore ensure these are removed. zWhen not using discs, ensure these arekept in cases, and stored out of direct sun-light.
zIf discs are not going to be used for a longperiod of time, remove these from theproduct.
In cold environments such as in mid-winterwhen the interior of the vehicle is cold, turn-ing the heater on and immediately trying touse the product may cause condensation(water droplets) to form on the disc and inter-nal optical components, and this may preventthe product from operating correctly.In these conditions, remove the disc, and waita short time before use.Actions such as unauthorised reproduction,broadcast, public performance, or rental ofdiscs that comprise other than personal useare prohibited by law.
E00736001035
The following marks are printed on the disclabel, package, or jacket.
zPlayback of discs other than thosedescribed in “Types of Disc That Can BePlayed Back” is not guaranteed. z8 cm discs may not be used. zDo not insert irregularly-shaped discs (forexample, heart-shaped), as these mayresult in malfunction. Additionally, discsthat have transparent portions may not beplayed back.
Important Points on HandlingCleaningImportant Points on Storage
Disc Playback EnvironmentCopyrightTy p e s o f D i s c T h a t C a n B e Played Back
Ty p e
Size
Maxi-mum playback time
Com-ments
CD-DA 12 cm 74 minutes —CD-TEXT 12 cm 74 minutes —CD-R/RW 12 cm — •Disc
contain-ing MP3 files
Discs That May Not Be Played Back
BK0203201EN.book 16 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分
How to change a tyre
For emergencies 9-15
9
6. Get the jack, jack bar and wheel nutwrench ready.Refer to “Tools and jack” on page 9-6.
E00803201894
1. On vehicles with wheel covers, firstremove the covers (refer to “Wheel cov-ers” on page 9-18).Then loosen the wheel nuts a quarter turnwith the wheel nut wrench. Do notremove the wheel nuts yet.
2. Place the jack under one of the jackingpoints (A) shown in the illustration. Usethe jacking point closest to the tyre youwish to change.
3. Rotate the jack by hand until the flangeportion (B) fits in the groove (C) at the topof the jack.4. Insert the jack bar (D) into the wheel nutwrench (E). Then put the end of the jackbar into the shaft’s jack end, as shown inthe illustration.Slowly rotate the wheel nut wrench untilthe tyre is raised slightly off the groundsurface.
To c h a n g e a t y r e
WA R N I N G zSet the jack only at the positions shownhere. If the jack is set at a wrong position,it could dent your vehicle or the jackmight fall over and cause personal injury. zDo not use the jack on a tilted or soft sur-face.Otherwise, the jack might slip and causepersonal injury. Always use the jack on aflat, hard surface. Before setting the jack,make sure there are no sand or pebblesunder the jack base.
BK0203201EN.book 15 ページ ２０１３年１１月１９日 火曜日 午前１１時５０分
