2013 JEEP GRAND CHEROKEE manual radio set

3. Remove and replace the battery. When re-
placing the battery, match the + sign on the
battery to the + sign on the inside of the battery
clip, located on the back cover. Avoid touching
the new battery with your fingers. Skin oils may
cause battery deterioration. If you touch a bat-
tery, clean it with rubbing alcohol.
4. To assemble the RKE transmitter case, snap
the two halves together.
General InformationThe RKE transmitter and receivers operate on a
carrier frequency of 433.92 MHz as required by
EEC regulations. These devices must be certifiedto conform to specific regulations in each indi-
vidual country. Two sets of regulations are in-
volved: ETS (European Telecommunication Stan-
dard) 300–220, which most countries use, and
German BZT federal regulation 225Z125, which is
based on ETC 300–220 but has additional unique
requirements. Other defined requirements are
noted in ANNEX VI of COMMISSION DIRECTIVE
95/56/EC. Operation is subject to the following
two conditions:
•This device may not cause harmful interference.
•
This device must accept any interference
received, including interference that may
cause undesired operation.
If your RKE transmitter fails to operate from a
normal distance, check for these two condi-
tions:
1. Weak battery in RKE transmitter. The ex-
pected life of the battery is a minimum of
three years.
2. Closeness to a radio transmitter such as a
radio station tower, airport transmitter, and
some mobile or CB radios.
DOOR LOCKS
The power door locks can be manually locked
from inside the vehicle by using the door lock
knob. To lock each door, push the door lock
knob on each door trim panel downward. To
unlock the front doors, pull the inside door
handle to the first detent. To unlock the rear
doors, pull the door lock knob on the door trim
panel upward. If the lock knob is down when the
door is closed, the door will lock. Therefore,
make sure the key is not inside the vehicle
before closing the door.
Separating RKE Transmitter
Manual Door Lock Knob
21

OperationVoice commands can be used to operate the
Uconnect® Phone and to navigate through the
Uconnect® Phone menu structure. Voice com-
mands are required after most Uconnect®
Phone prompts. You will be prompted for a
specific command and then guided through the
available options.
•Prior to giving a voice command, one must
wait for the beep, which follows the “Ready”
prompt or another prompt.
• For certain operations, compound com-
mands can be used. For example, instead of
saying “Setup” and then “Pair a Device”, the
following compound command can be said:
“Pair a Bluetooth® Device”.
•
For each feature explanation in this section,
only the compound form of the voice command
is given. You can also break the commands
into parts and say each part of the command
when you are asked for it. For example, you
can use the compound form voice command
“Phonebook New Entry”, or you can break the
compound form command into two voice com-
mands: “Phonebook” and “New Entry”. Please remember, the Uconnect® Phone works best
when you talk in a normal conversational tone,
as if speaking to someone sitting a few feet/
meters away from you.
Voice Command Tree
Refer to “Voice Tree” in this section.
Help Command
If you need assistance at any prompt, or if you
want to know your options at any prompt, say
“Help” following the beep. The Uconnect®
Phone will play all the options at any prompt if
you ask for help.
To activate the Uconnect® Phone from idle,
simply press the
button and follow the au-
dible prompts for directions. All Uconnect®
Phone sessions begin with a press of the
button on the radio control head.
Cancel Command
At any prompt, after the beep, you can say
“Cancel” and you will be returned to the main
menu. However, in a few instances the system
will take you back to the previous menu. Pair (Link) Uconnect® Phone To A Mobile
Phone
To begin using your Uconnect® Phone, you
must pair your compatible Bluetooth® enabled
mobile phone (refer to “Compatible Phones”
section to learn about the phone type).
To complete the pairing process, you will need to
reference your mobile phone owner’s manual.
The Uconnect® website may also provide de-
tailed instructions for pairing.
The following are general phone to Uconnect®
Phone pairing instructions:
•
Press the
button to begin.
• After the “Ready” prompt and the following
beep, say “Setup Phone Pairing”.
• When prompted, after the beep, say “Pair a
Phone” and follow the audible prompts.
• You will be asked to say a four-digit Personal
Identification Number (PIN), which you will
later need to enter into your mobile phone.
You can enter any four-digit PIN. You will not
need to remember this PIN after the initial
pairing process.
74

1. Power – Turns the screen and wireless
headphone transmitter for the selected Channel
on or off. To hear audio while the screen is
closed, press the Power button to turn the
headphone transmitter on.
2. Channel Selector Indicators – When a but-
ton is pressed, the currently affected channel or
channel button is illuminated momentarily.
3. Light – Turns the remote control backlighting
on or off. The remote backlighting turns off
automatically after five seconds.4. Channel/Screen Selector Switch - Indicates
which channel is being controlled by the remote
control. When the selector switch is in the
Channel 1 position, the remote controls the
functionality of headphone Channel 1 (right side
of the screen). When the selector switch is in
the Channel 2, position the remote controls the
functionality of headphone Channel 2 (left side
of the screen).
5.
 – In radio modes, press to seek the next
tunable station. In disc modes, press and hold
to fast forward through the current audio track
or video chapter. In menu modes use to navi-
gate in the menu.
6. / Prev – In radio modes, press to select to
the previous station. In disc modes, press to
advance to the start of the current or previous
audio track or video chapter. In menu modes,
use to navigate in the menu.
7. MENU – Press to return to the main menu of
a DVD disc, to select a satellite audio channel
from the Station list, or select playback modes
(RANDOM for a CD).
8. / (Play/Pause) – Begin/resume or pause
disc play. 9.
■(Stop) – Stops disc play
10. PROG Up/Down – When listening to a
radio mode, pressing PROG Up selects the
next preset and pressing PROG Down selects
the previous preset stored in the radio. When
listening to compressed audio on a data disc,
PROG Up selects the next directory and PROG
Down selects the previous directory. When lis-
tening to a disc in a radio with a multiple-disc
changer, PROG Up selects the next disc and
PROG Down selects the previous disc.
11. MUTE – Press to mute the headphone
audio output for the selected channel.
12. SLOW – Press to slow playback of a DVD
disc. Press play () to resume normal play.
13. STATUS – Press to display the current
status.
14. MODE – Press to change the mode of the
selected channel. See the Mode Selection sec-
tion of this manual for details on changing
modes.
Remote Control
198

15. SETUP – When in a video mode, press the
SETUP button to access the display settings
(see the display settings section) to access the
DVD setup menu, select the menu button on the
radio. When a disc is loaded in the DVD player
(if equipped) and the VES™ mode is selected
and the disc is stopped, press the SETUP
button to access the DVD Setup menu. (see the
DVD Setup Menu of this manual.)
16. BACK – When navigating in menu mode,
press to return to the previous screen. When
navigating a DVDs disc menu, the operation
depends on the disc’s contents.
17. – In radio modes, press to seek to the
previous tunable station. In disc modes, press
and hold to fast rewind through the current
audio track or video chapter. In menu modes
use to navigate in the menu.
18. ENTER – Press to select the highlighted
option in a menu.
19. / NEXT – In radio modes, press to select
to the next station. In disc modes, press to
advance to the next audio track or video chap-
ter. In menu modes, use to navigate in the
menu.Remote Control StorageThe video screen(s) come with a built in storage
compartment for the remote control which is
accessible when the screen is opened. To re-
move the remote, use your index finger to pull
and rotate the remote towards you. Do not try to
pull the remote straight down as it will be very
difficult to remove. To return the remote back
into its storage area, insert one long edge of the
remote into the two retaining clips first, and then
rotate the remote back up into the other two
retaining clips until it snaps back into position.Locking The Remote ControlAll remote control functionality can be disabled
as a parental control feature.
•
To disable the Remote Control from making any
changes, press the Video Lock button and follow
the radio’s instructions (select menu, rear ves,
lock). If the vehicle is not equipped with a DVD
player, follow the radio’s instructions to turn
Video Lock on. The radio and the video
screen(s) indicate when Video Lock is active.
•Pressing the Video Lock again or turning the
ignition OFF turns Video Lock OFF and allows
remote control operation of the VES™.
Replacing The Remote Control
Batteries
The remote control requires two AAA batteries
for operation. To replace the batteries:
• Locate the battery compartment on the back
of the remote, then slide the battery cover
downward.
•
Replace the batteries, making sure to orient
them according to the polarity diagram shown.
• Replace the battery compartment cover.
The Remote Control Storage
199

RADIO OPERATION AND
MOBILE PHONES
Under certain conditions, the mobile phone
being on in your vehicle can cause erratic or
noisy performance from your radio. This condi-
tion may be lessened or eliminated by relocat-
ing the mobile phone antenna. This condition is
not harmful to the radio. If your radio perfor-
mance does not satisfactorily “clear” by the
repositioning of the antenna, it is recommended
that the radio volume be turned down or off
during mobile phone operation when not using
Uconnect® (if equipped).
CLIMATE CONTROLS
The air conditioning and heating system is
designed to make you comfortable in all types
of weather.
Dual-Zone Automatic Temperature
Control (ATC) — If Equipped
•The Automatic Temperature Control (ATC) al-
lows both driver and front passenger seat
occupants to select individual comfort settings.
•When occupants in the vehicle select the
AUTO mode operation, a comfort tempera-
ture can be set by using the temperature up
and down buttons, and the auto blower op-
eration will be set automatically.
• The system provides set-and-forget opera-
tion for optimum comfort and convenience.
• The system can be controlled manually, if
desired.
The ATC system automatically maintains the
interior comfort level desired by the driver and
passenger. 1. A/C Button
Press and release to change the current Air
Conditioning (A/C) setting, the indicator illumi-
nates when A/C is ON. Performing this function
will cause the ATC to switch into manual mode.
2. Recirculation Control Button
Press and release to change the current setting,
the indicator illuminates when ON.
209

Odometer...................164
Trip ................... .164
Off-Pavement Driving (Off-Road) ......245
Off-Road Driving (Off-Pavement) ......245
Oil Change Indicator .............177
Oil Change Indicator, Reset .........177
Oil, Engine ................. .313
Capacity .................340
Change Interval ..........177, 313
Diesel ...................314
Dipstick ................. .313
Disposal .................315
Filter ...................315
Filter Disposal ..............315
Identification Logo ............313
Materials Added to ...........315
Recommendation .........314, 340
Synthetic .................315
Viscosity ..............314, 340
Oil Filter, Selection ..............315
Onboard Diagnostic System .........312
Operating Precautions ............312
Operator Manual (Owner’s Manual) ......6
Outside Rearview Mirrors ...........71
Overdrive ................231, 236
Overdrive OFF Switch .........231, 236
Overhead Console ..............140 Overheating, Engine
..........167, 294
Owner’s Manual (Operator Manual) ......6
Paint Care ................. .328
Paint Damage ................328
Parking Brake ................ .250
Park Sense System, Rear ..........134
Passing Light .................112
Personal Settings ...............184
Pets .......................58
Phone, Cellular ................. 7

2
Phone, Hands-Free (Uconnect®) .......72
Power Door Locks ................22
Lift Gate ..................29
Mirrors ...................71
Outlet (Auxiliary Electrical Outlet) . . .146
Seats ................ .94, 95
Steering ..............248, 250
Sunroof ...............142, 144
Tilt/Telescoping Steering Column ....116
Windows ..................26
Pregnant Women and Seat Belts .......41
Preparation for Jacking ...........295
Pretensioners Seat Belts .................37 Programmable Electronic Features
.....184
Programming Transmitters (Remote Keyless Entry) ...............19
Quadra-Lift ................. .241
Quadra-Trac .................237
Radial Ply Tires ................261
Radiator Cap (Coolant Pressure Cap) . . .323
Radio Operation ...............209
Radio (Sound Systems) ...........188
Rain Sensitive Wiper System ........114
Rear Axle (Differential) ............325
Rear Camera .................139
Rear Cupholder ................149
Rear Fog Lights ...............168
Rear Park Sense System ..........134
Rear Seat, Folding ..............100
Rear Window Features ...........154
Rear Wiper/Washer .............154
Recorder, Event Data .............49
Recreational Towing .............287
Shifting into Transfer Case
Neutral (N) ................288
Shifting out of Transfer Case
Neutral (N) ................290
399