2013 JEEP GRAND CHEROKEE remote control

bluetooth fuel tank capacity alarm brake pads open gas tank fuel consumption

Page 174 of 408

JEEP GRAND CHEROKEE 2013 Owner handbook (in English) •Unstored Messages Until RUN
These messages deal primarily with the Re-
mote Start feature. This message type is dis-
played until the ignition is in the RUN state.
Examples of this message type are

•Unstored Messages Until RUN
These messages deal primarily with the Re-
mote Start feature. This message type is dis-
played until the ignition is in the RUN state.
Examples of this message type are "Remote
Start Aborted - Door Ajar" and"Press Brake
Pedal and Push Button to Start".
• Five Second Unstored Messages
When the appropriate conditions occur, this
type of message takes control of the main
display area for five seconds and then returns to
the previous screen. Examples of this message
type are "Memory System Unavailable - Not in
Park" and"Automatic High Beams On".
The Reconfigurable Telltales section is divided
into the white telltales area on the right, amber
telltales in the middle, and red telltales on the left.
When the appropriate conditions exist, the
EVIC displays the following messages:
•Vehicle Not In Park
• Key Left Vehicle
• Key Not Detected •
Service Keyless System
• Service Tire Pressure System
• Service Park Assist System
• Park Assist System Blinded
• Park Assist Disabled
• Front Sensor Blinded
• Rear Sensor Blinded
• Keyfob Battery Low
• Liftglass Open
• Left Front Turn Signal Lamp Out
• Right Front Turn Signal Lamp Out
• Left Rear Turn Signal Lamp Out
• Right Rear Turn Signal Lamp Out
• Check Tire Pressure
• ESC System Off
• Service Blind Spot System
• Blind Spot Detection Unavailable
• Blind Spot System Off •
Blind Spot System Unavailable Sensor
Blocked
• Blind Spot System Unavailable Astronomy
Zone — When the Blind Spot Module senses
a tower on the same frequency that it is
interfering with, it will automatically turn the
Blind Spot System off.
• Normal Cruise Ready — When Adaptive
Cruise Control (ACC) system is turned off
and Normal (Fixed Speed) Cruise Control
mode is available. Refer to “Adaptive Cruise
Control (ACC)” in “Understanding The Fea-
tures Of Your Vehicle” (if equipped).
• Adaptive Cruise Off — When the Adaptive
Cruise Control (ACC) system is turned off.
Refer to “Adaptive Cruise Control (ACC)” in
“Understanding The Features Of Your Ve-
hicle” (if equipped).
• ACC Ready — When the ACC system is
activated. Refer to “Adaptive Cruise Control
(ACC)” in “Understanding The Features Of
Your Vehicle” (if equipped).
170

Page 197 of 408

JEEP GRAND CHEROKEE 2013 Owner handbook (in English) Uconnect® MULTIMEDIA
VIDEO ENTERTAINMENT
SYSTEM (VES™) — IF
EQUIPPED
Your rear seat Video Entertainment System
(VES™) is designed to give your family years of
enjoyment. You can play your favor

Uconnect® MULTIMEDIA
VIDEO ENTERTAINMENT
SYSTEM (VES™) — IF
EQUIPPED
Your rear seat Video Entertainment System
(VES™) is designed to give your family years of
enjoyment. You can play your favorite CDs or
DVDs, listen to audio over the wireless head-
phones, or plug and play a variety of standard
video games or audio devices. Please review
this Owner’s Manual to become familiar with its
features and operation.
System OverviewThe rear seat Video Entertainment System
(VES™) consists of:
•Your vehicle may be equipped with a single
LCD overhead console screen system.
• One infrared remote control to allow rear seat
audio and video control function capability of
the VES™. •
Two infrared wireless dual channel head-
phones for rear passenger listening.
• Auxiliary RCA audio/video inputs (AUX jacks)
for listening and viewing of other consumer
electronic device media such as MP3 players
or video games.
• Radio capable of playing DVDs.
Video Entertainment System (VES™)This manual is intended to aid with the opera-
tion of the rear seat Video Entertainment Sys-
tem (VES™).
The Video Entertainment System (VES™) ex-
pands the vehicle’s audio and video capabilities
so that rear passengers can enjoy movies,
music and external audio/video devices such as
video games or MP3 players. The VES™ inte-
grates seamlessly with the vehicle’s radio so the
audio may be heard through the cabin speakers
and/or headphones. The system may be con-
trolled by the radio for front seat occupants or
controlled by the remote control for rear seat
occupants. The VES™ is a dual channel system. The video
screen displays information in a split screen
format. The left side of the screen is referred to
as Channel 1 and the right side of the screen is
referred to as Channel 2. All modes except
video modes (DVD video, Aux video) are dis-
played in a split screen format. When a video
mode is displayed it is displayed on the full
screen. The remote control is designed to con-
trol either channel by the use of the selector
switch located on the right side of the remote
control. The headphones are designed to listen
to either channel by use of the selector switch
located on the right ear cup.
Using the included dual channel wireless head-
phones, the VES™ allows rear passengers to
listen to two different audio sources simultane-
ously. The wireless remote control allows rear
passengers to change stations, tracks, discs
and audio/video modes.
193

Page 198 of 408

JEEP GRAND CHEROKEE 2013 Owner handbook (in English) Remote Control OperationQuick Reference Chart
This chart provides a quick reference of the
remote control button functions for the different
radio modes and menu screens.NOTE:
•
Ensure the remote co

Page 199 of 408

JEEP GRAND CHEROKEE 2013 Owner handbook (in English) Remote ControlButton Standard Screens
Menu Screens
AM/FM/
MW/LW HDD–Hard
Disc Drive DISC/DVD
AUX/AUX1/AUX2 Mode
Select Menu Screen
Setup
Left Arrow RW Tune Down*Previous
Channel Fast
Rewind Audio:
F

Page 200 of 408

Page 201 of 408

Page 202 of 408

JEEP GRAND CHEROKEE 2013 Owner handbook (in English) 1. Power – Turns the screen and wireless
headphone transmitter for the selected Channel
on or off. To hear audio while the screen is
closed, press the Power button to turn the
headphone transmitter

1. Power – Turns the screen and wireless
headphone transmitter for the selected Channel
on or off. To hear audio while the screen is
closed, press the Power button to turn the
headphone transmitter on.
2. Channel Selector Indicators – When a but-
ton is pressed, the currently affected channel or
channel button is illuminated momentarily.
3. Light – Turns the remote control backlighting
on or off. The remote backlighting turns off
automatically after five seconds.4. Channel/Screen Selector Switch - Indicates
which channel is being controlled by the remote
control. When the selector switch is in the
Channel 1 position, the remote controls the
functionality of headphone Channel 1 (right side
of the screen). When the selector switch is in
the Channel 2, position the remote controls the
functionality of headphone Channel 2 (left side
of the screen).
5.
– In radio modes, press to seek the next
tunable station. In disc modes, press and hold
to fast forward through the current audio track
or video chapter. In menu modes use to navi-
gate in the menu.
6. / Prev – In radio modes, press to select to
the previous station. In disc modes, press to
advance to the start of the current or previous
audio track or video chapter. In menu modes,
use to navigate in the menu.
7. MENU – Press to return to the main menu of
a DVD disc, to select a satellite audio channel
from the Station list, or select playback modes
(RANDOM for a CD).
8. / (Play/Pause) – Begin/resume or pause
disc play. 9.
■(Stop) – Stops disc play
10. PROG Up/Down – When listening to a
radio mode, pressing PROG Up selects the
next preset and pressing PROG Down selects
the previous preset stored in the radio. When
listening to compressed audio on a data disc,
PROG Up selects the next directory and PROG
Down selects the previous directory. When lis-
tening to a disc in a radio with a multiple-disc
changer, PROG Up selects the next disc and
PROG Down selects the previous disc.
11. MUTE – Press to mute the headphone
audio output for the selected channel.
12. SLOW – Press to slow playback of a DVD
disc. Press play () to resume normal play.
13. STATUS – Press to display the current
status.
14. MODE – Press to change the mode of the
selected channel. See the Mode Selection sec-
tion of this manual for details on changing
modes.
Remote Control
198

Page 203 of 408

JEEP GRAND CHEROKEE 2013 Owner handbook (in English) 15. SETUP – When in a video mode, press the
SETUP button to access the display settings
(see the display settings section) to access the
DVD setup menu, select the menu button on the
radio. When a d

15. SETUP – When in a video mode, press the
SETUP button to access the display settings
(see the display settings section) to access the
DVD setup menu, select the menu button on the
radio. When a disc is loaded in the DVD player
(if equipped) and the VES™ mode is selected
and the disc is stopped, press the SETUP
button to access the DVD Setup menu. (see the
DVD Setup Menu of this manual.)
16. BACK – When navigating in menu mode,
press to return to the previous screen. When
navigating a DVDs disc menu, the operation
depends on the disc’s contents.
17. – In radio modes, press to seek to the
previous tunable station. In disc modes, press
and hold to fast rewind through the current
audio track or video chapter. In menu modes
use to navigate in the menu.
18. ENTER – Press to select the highlighted
option in a menu.
19. / NEXT – In radio modes, press to select
to the next station. In disc modes, press to
advance to the next audio track or video chap-
ter. In menu modes, use to navigate in the
menu.Remote Control StorageThe video screen(s) come with a built in storage
compartment for the remote control which is
accessible when the screen is opened. To re-
move the remote, use your index finger to pull
and rotate the remote towards you. Do not try to
pull the remote straight down as it will be very
difficult to remove. To return the remote back
into its storage area, insert one long edge of the
remote into the two retaining clips first, and then
rotate the remote back up into the other two
retaining clips until it snaps back into position.Locking The Remote ControlAll remote control functionality can be disabled
as a parental control feature.
•
To disable the Remote Control from making any
changes, press the Video Lock button and follow
the radio’s instructions (select menu, rear ves,
lock). If the vehicle is not equipped with a DVD
player, follow the radio’s instructions to turn
Video Lock on. The radio and the video
screen(s) indicate when Video Lock is active.
•Pressing the Video Lock again or turning the
ignition OFF turns Video Lock OFF and allows
remote control operation of the VES™.
Replacing The Remote Control
Batteries
The remote control requires two AAA batteries
for operation. To replace the batteries:
• Locate the battery compartment on the back
of the remote, then slide the battery cover
downward.
•
Replace the batteries, making sure to orient
them according to the polarity diagram shown.
• Replace the battery compartment cover.
The Remote Control Storage
199

Load next 8 pages

Page: < prev 1-8 9-16 17-24 25-32 next >

lug pattern handbrake clock reset dimensions high beam roof