Page 217 of 420
215
5
Visibility
Rear wiper
park,
If a significant accumulation of snow or ice is present, deactivate the automaticrear wiper via the " Driving assistance"menu, then "Vehicle settings".
intermittent wipe,
wash-wipe
(set duration).
Rear wiper selection ring:
Reverse gear
When reverse gear is engaged, the rear wiper will come into operation if the windscreen wipers are operating.
Thi
s function can be deactivated in the "Driving assistance " menu, then " Vehicle
settings".
Page 218 of 420
216
Visibility
Screenwash and washer jets
Windscreen wash and
headlamp wash
Adjusting the jets
The front washers include an adjustment for the
height of delivery from the jets.
If you want to modify the factory setting, turn
the screw on each jet anti-clockwise, towards
the "+" to raise the jet or clockwise, towards the "-" to lower it.
Headlamp wash
)Pull the windscreen wiper stalk towards
you. The windscreen wash then the
windscreen wi
pers operate for a fixed period.
A few moments after releasing the wiper stalk,
there is a last wipe to clear any runs from thescreen. The headlam
ps operate when the vehicle is moving and when the dipped beam headlamps
are on. However, to reduce the consumption
of screenwash fluid, the headlamp wash onl
yoperates with every 7th use of the screenwash
or once every 25 miles (40 km), during a given journey.
Page 219 of 420
217
5
Visibility
The windscreen wipers operate automatically,
without any action on the par t of the driver, if
rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.
Switching on
Switching off
The automatic rain sensitive windscreenwipers must be reactivated by pushing the control stalk downwards, if theignition has been off for more than oneminute. Brie
fly push the control stalk downwards.
A wiping cycle confirms that the instruction has been accepted.
This warning lamp comes on in theinstrument panel and a message is displayed. Brie
fly push the control stalk
downwards again, or place the control stalk in another position (Int, 1 or 2).
Automatic rain sensitive
w
indscreen wipers
This warning lamp goes off in the instrumentpanel and a message is displayed.
Page 220 of 420

218
Visibility
Special position of the
w
indscreen wipers
To maintain the effectiveness of the "flat-blade" type of wiper blades, it is advisable to:
- handle them with care,
- clean them regularly using soapywater,
- avoid using them to retain cardboard on the windscreen,
- replace them at the first signs of wear.
This position permits release o
f the windscreen
wiper blades.
It is used for cleaning or replacement of the blades. It can also be useful, in winter, todetach the blades from the windscreen.
Do not cover the rain sensor, linked with the sunshine sensor and located in the centre of the windscreen behind the rear view mirror.
Switch off the automatic rain sensitivewipers when using an automatic car wash.
In winter, it is advisable to wait until thewindscreen is completely clear of ice before activating the automatic rain sensitive wipers.
Operating fault
If a fault occurs with the automatic rain sensitive wipers, the wipers will operate in
intermittent mode.
Have it checked by CITROËN dealer or a
qualified workshop.
On switching off the ignition: )
any action on the wiper stalk in the minute
after switching off the ignition places the
blades vertically on the screen.
When the system is no longer powered - at least
one minute after switching off the ignition - it is
possible to move the arms manually. ) To park the blades again, switch on the
ignition and operate the wiper stalk.
Replacement of the arms must only be done by a CITRO
Page 221 of 420