2013 Citroen C3 PICASSO Owner's Manual

6
Fittings
95
Storage drawer
It is located under the front passenger seat.
12 V acc essory socket
)To use the 12 V socket (max power:
100 Watts), lift the cap and connect theaccessory.

Opening
)
Raise the front of the drawer and pull it.
Do not place heavy objects in thedrawer.

Fittings
96
Mats
Removable carpet protection.


Refi tting

To refit the mat on the driver's side: )position the mat correctly, )refit the fixings by pressing, )check that the mat is secured correctly.



Fitting

When fitting the mat for the first time, on the
driver's side use only the fixings provided in the
wallet attached.
The other mats are simply placed on thecarpet.

Removal

To remove the mat on the driver's side: )
move the seat as far back as possible, )
unclip the fixings,)
remove the mat.

Ticket holder


To a v o i d a ny risk of jamming of the pedals:


- only use mats which are suited tothe fixings already present in thevehicle; these fixings must be used,

- never fit one mat on top of another.
The use of mats not approved by CITROËN may inter fere with access tothe pedals and hinder the operation of the cruise control / speed limiter. It is located at the top of the dashboard central
panel.It can be used to hold toll or parking tickets.

6
Fittings
97























Rear interior fi ttings

Two boxes are available, located under the rear passenger footwells.
To open them, lift the lid using the cut-out. There is a cup holder located at the rear of thecentre console.


Storage boxes Seat pockets
Cup holder

Fittings
98
Lift the catch to release the table and unfold it.
Aircraft style tables
Reading lamps are built into the back of the
front seats, behind the tables. With the ignition
on, they illuminate the top of the table without inconveniencing other passengers.
They are only accessible if the table isunfolded. )
Press the button to switch the lamp on or off.


Individual reading lamps
Side blinds

Blinds are available for the side windows.
Pull the side blind longways by the tab to use it.
Always guide the blind slowly using the tab.
Do not place hard or heavy objects on the table. They could becomedangerous projectiles in the event of sharp braking or impact. As a safety precaution, if too much pressure is exer ted the table will fold downwards.

6
Fittings
99
Opening
) Lower the storage shelf. )
Press the flap opening control. )
Lower the flap.)
Check that the adjustable boot floor is in
the high position.) Load the objects from inside the boot.


Ski flap
Device for storing and transporting longobjects.
When unfolded, this provides a stora
ge area split into 2 sections, completing the storagespaces available at the rear of the vehicle.


Storage tray

Fittings
100


























Boot fi ttings

Storage net on right-hand boot trim. 2.
Open storage compar tments.3.
Torch. 4.
Adjustable boot floor.5.
Carrier bag hook.
6.Securing rings.7. Storage area under boot carpet. 8.Rear parcel shelf.

6
Fittings
101
2-position adjustable boot
The two-position adjustable boot floor allowsyou to:


- maximise the volume of the boot,

- par tition the boot
(stowing the rear shelf...),

- obtain a flat floor from the boot opening to
the front seats, when the rear bench seat is
in the folded and fully back position.
Placing the adjustable boot fl oor in the low position
)
Lift the adjustable boot floor by pulling on
the strap. ) Move the adjustable boot floor rear wards
and then down, following the guides on the sides.

Placing the adjustable boot fl oor in the high position
)
Lift the adjustable boot floor by pulling the strap. )
Move the adjustable boot floor rearwards
then up to its high position.
In the high position, the adjustable boot floor
allows stowing of the rear parcel shelf andfragile objects.
The ad
justable boot floor is fitted with four stowing rings to secure your loads using the net
available as an accessory.
Ensure that your boot is empty before handling the adjustable boot floor.

Fittings
102
Hooks
The hooks can be used to hold shopping bags.
2-panel rear parcel shelf

The rear section is attached to the tailgate bytwo cords.


Removing the shelf

From the boot:)
unhook the two cords,)
pull the shelf towards you to unclip it,)
lift the shelf to remove it.


Refi tting the shelf
From the boot: )position the shelf so that the two notchesare directly above the fixing pins,)push the shelf towards the inside of the
vehicle to clip it in place,
)attach the two cords.
It can be stored under the ad
justable boot floor,
if this is in its high position.