2013 Citroen C3 PICASSO cooling

1
Monitoring
29
Low fuel level fixed. When it first comes on there remainsapproximately 5 litres offfuel
in the
tank. Yo u m u s t r e
fuel as soon as possible to avoid running out of fuel.This warning lamp will come on every time the ignition
is switched on, until a sufficient addition of fuel is made.
Fuel tank capacity: approximately 50 litres (petrol) or
48 litres (Diesel); depending on version: approximately
30 litres (petrol or Diesel).
Never continue to drive until you run out of fuel as
this could damage the emission control and injection systems.
Warning lampis onCauseAction / Observations
Maximum coolant temperature
fixed red. The temperature of the cooling system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before topping
up the level, if necessary.
If the problem persists, contact a CITROËN dealer or qualified workshop.
Engine oilpressure
fixed. There is a fault with the engine
lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a CITROËN
dealer or a quali
fied workshop.
Battery charge
fixed. The battery charging circuit has a fault (dirty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop.

Comfort
50








Vent ilat ion
The incoming air follows various routesdepending on the controls selected by thedriver:
- direct arrival in the passenger compartment (air intake),
- passage through a heating circuit (heating),
- passage through a cooling circuit(air conditioning).
The temperature control enables you to obtain
the level of comfor t required by mixing the air of
the various circuits.
The air distribution control enables you to
di
ffuse the air in the passenger compar tment combining several air vents.
The air flow control enables you to increase or reduce the speed of the ventilation fan.
Air intake
The air circulating in the passenger compartment
is filtered and originates either from the outside
via the grille located at the base of the windscreen or from the inside in air recirculation mode.


Control panel

The controls of this system are grouped
together on control panel Aon the centre console. Depending on the model, the functionsoffered are:


- the level of comfor t required,

- air flow
,

- air distribution
,

- demisting and defrosting,

- manual or digital air conditioning controls.



Air distribution
1.
Windscreen demisting or defrosting vents. 2.Front side window demisting or defrostingvents.3.Side adjustable air vents. 4.
Central adjustable air vents.
5. Air outlets to the front footwells.
6.Air outlets to the rear footwells.
S
ystem which creates and maintainscomfortable conditions in the vehicle'spassenger compartment.

Comfort
56
programme
The automatic comfor t programme
may not be sufficient to quicklydemist or defrost the windscreen
and side windows
(humidity, several
passengers, ice, etc.).
)To switch the system off, press this buttonagain or on "AUTO"
. The indicator lamp in
the button goes off and the indicator lamp in the "AUTO"
button comes on.
With Stop & Start, when demisting hasbeen activated, the STOP mode is notavailable.
)Press this button to activate the automatic
visibility programme. The indicator lamp in
the button comes on. The system automatically controls the air conditioning, the air flow and the air intake andprovides optimum distribution of the ventilation
to the windscreen and side windows. I
f you wish, you can make a different choice
from that offered by the system by changing
a setting. The other functions will still be controlled automatically.) Pressing the "AUTO"
button returns thesystem to completely automatic operation.
For maximum cooling or heating of the passenger compar tment, it is possible to exceed the minimum value 14 or the maximum value 28.)Turn control 2
or 3
to the left until "LO"
is displayed or to the right until "HI"is displayed.


Manual operation
)
Press this button to switch off
the air conditioning.

5. Air conditioning On / Off

Switching the system off could result in
discomfort (humidity, condensation).)Press this button again to return to automatic operation of the air conditioning.The indicator lamp in the "A/C"
buttoncomes on.

Checks
148






Checking levels
Brake fluid level Oil level


The check is carried out either when
the ignition is switched on using theoil level indicator on the instrument
panel, or using the dipstick. Th
e brake fluid level should be close
to the "MA X" mark. If it is not, check
the brake pad wear.

Changing the fl uid

Refer to the ser vicing booklet for details of the
interval for this operation.

Engine oil change

Refer to the servicing booklet for details of the
interval for this operation.
In order to maintain the reliabilit
y of the engine
and emission control system, the use of
additives in the engine oil is prohibited.

Oil specifi cation

The oil must be the correct grade for your engine and conform to the manufacturer'srecommendations.


Fluid specifi cation

The brake fluid must conform to themanufacturer's recommendations and meet the
DOT3 or DOT4 standard.
If a level drops si
gnificantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.
Check all of these levels regularly, in line with the ser vicing booklet and the requirements of the warranty. Top them up if necessary, unless other wise indicated.

Ta k e c a r e w h e n w o r k i ng under the bonnet, as certain areas of the engine may be extremely
hot (risk of burns) and the cooling fan could star t at any time (even with the ignition off).
It is normal to top up the oil levelbetween two ser vices (or oil changes). CITROËN recommends that you check the level, and top up if necessary, every3 000 miles (5 000 kms). After topping up the oil, the check when switching on the ignition with the oil level indicator in the instrument panel is not valid during the 30 minutes after topping up. It will onl
y be correct if the vehicle is on level ground and the engine has been off for more
than 30 minutes.

10
Checks
149
Coolant level
The coolant level should be close
to the "MAX" mark but should never exceed it.
Fluid specifi cation
For optimum cleaning and to avoid freezing,
this fluid must not be topped up or replaced with plain water.



Fluid specifi cation

The coolant must conform to themanufacturer's recommendations.


Changing the coolant

The coolant does not have to be changed.
Screenwash fluid level

When the engine is warm, the temperature of
the coolant is regulated by the fan.
Top up the level when necessary.
The cooling fan may star t after switching
off the engine: take care with ar ticles andclothing that might become caught by thefan blades.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off theengine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop.
When the pressure has dropped, remove the
cap and top up the level.
Diesel additive level
(Diesel engine with particle
emission filter)






Used
products
To p p i ng up
This additive must be topped up by a CITROËN
dealer or a qualified workshop without delay.
Avoid prolonged contact of used oil or fluids with the skin.
Most of these fluids are harmful tohealth or indeed very corrosive.

Do not discard used oil or fluids into sewers or onto the ground.
Take used oil to a CITROËN dealer or a qualified workshop (France) or to anauthorised waste disposal site.
Th
e additive reservoir low level is indicated by fixed
illumination of this warning lamp,
accompanied by an audible
warning and a message in the
multifunction screen.

11
Practical information
177
Fuse table
Fuse N°RatingFunctions
F
120 AEngine control unit supply, cooling fan unit control,multifunction engine control main relay.
F
215 AHorn.
F
310 AFront / rear wash-wipe.
F4 20
ADaytime running lamps.
F
515 ADiesel heater (Diesel engine), fuel pump(petrol engine)
F
610 A ABS/ESP control unit, ABS/ESP cut-off relay,secondary stop switch.
F7
10 AElectric power steering.
F
825 AStarter motor control.
F9
10 ASwitching and protection unit (Diesel).
F10
30 ADiesel engine injection pump valve, injectors and ignition coils (petrol engine) .
F1140 A Air conditioning fan.

Practical information
178
Fuse N°RatingFunctions
F1230 A Windscreen wipers slow / fast speed.
F13
40 A Built-in systems inter face supply (ignition positive).
F14
30 A Valvetronic supply (petrol).
F1
510 A Right-hand main beam headlamp.
F1
610 A
Left-hand main beam headlamp.
F17 15 A
Left-hand dipped beam headlamp.
F18 15 A
Ri
ght-hand dipped beam headlamp.
F1
915 A Multifunction engine management supply (petrol engine),
air cooling electrovalves (Diesel).
F20 10 A Multi
function engine management supply (petrol engine),
Turbo pressure regulation electrovalve (Diesel), engine coolantlevel sensor (Diesel).
F2
15 A Fan assembly control supply, APC, ABS ESP relays.

11
Practical information
179

Table of maxi-fuses
Fuse N°RatingFunctions
MF1*60 ACooling fan assembly.
MF2*30 A ABS / ESP control unit.
MF3 * 30 A ABS / ESP control unit.
MF4 * 60 ABuilt-in Systems Interface (BSI) supply.
MF5 * 60 ABuilt-in Systems Interface (BSI) supply.
MF6 *-Not used.
MF7 *-Passenger compartment fusebox.
MF8 *
-Not used.

*

The maxi-fuses provide additional protection for the electrical systems. All work on the maxi-fusesmust be carried out by a CITROËN dealer or a qualified workshop.