2013 Citroen C3 warning

9
Driving
127





Hill start assist

System which holds your vehicle temporarily (approximately 2 seconds) when star ting on a slope, the time it takes to move your foot from
the brake pedal to the accelerator pedal.
This
function is only active when:


- the vehicle is completely stationary, with your foot on the brake pedal,

- cer tain conditions on a slope are met,

- with the driver’s door closed.
The hill start assist function cannot bedeactivated.
On an ascendin
g slope, with the vehicle
stationary, the vehicle is held momentarilywhen you release the brake pedal:- provided you are in automated mode(position A) or in manual mode (position AM )
on an electronic gearbox.

Operating fault

If a malfunction of the system occurs, these
warning lamps come on. Contact a CITROËN
dealer or a
qualified workshop to have the system checked. On a descendin
g slope, with the vehicle
stationary and reverse gear engaged, thevehicle is held momentarily when you
release the brake pedal.
Do not leave the vehicle while it is being held in the hill star t assist phase. If you need to leave the vehicle withthe engine running, manually applythe parking brake then ensure that the parking brake warning lamp is on (not
flashing) in the instrument panel.
Operation

10
Checks
141
Additive level (Diesel with
particle emissions filter
)
According to your version of instrument panel,
the additive reser voir low level is indicated by:
To p p i ng up
The reser voir must be topped up without delay
by a CITROËN dealer or a qualified workshop.









Used products



- fixed illumination of the particleemissions filter warning lamp,
accompanied by an audible signal, or
- fix
ed illumination of the servicewarning lamp, accompanied byan audible signal and a message
that the par ticle emissions filter additive level is too low.

Do not discard used oil or fluids into sewers or onto the ground.
Take used oil to a CITROËN dealer or a qualified workshop (France) or to anauthorised waste disposal site.

Avoid prolonged contact of used oil or fluids with the skin.

Most of these fluids are harmful tohealth or indeed very corrosive.
Coolant level

The coolant level should be close
to the "MA X" mark but should never exceed it.
When the en
gine is warm, the temperature of
the coolant is regulated by the fan.

Changing the coolant
The coolant does not have to be changed.


Fluid specifi cation

The coolant must conform to themanufacturer's recommendations.
Top up the level when necessary.
The cooling fan may star t after switching off the engine: take care with ar ticles and clothing that might become caught by the fan blades.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off theengine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop. When
the pressure has dropped, remove the cap and
top up t
he level.
Screenwash fluid level
Fluid specifi cation
For optimum cleaning and to avoid freezing,
this
fluid must not be topped up or replaced with plain water.

Checks
142
According to your version of instrument panel, the start of
saturation of the par ticle emissions filter is indicated by:

- fixed illumination of the par ticleemissions filter warning lamp,
accompanied by an audible signal, or

- temporary illumination of
the ser vice warning lamp,

As soon as the traffic conditions permit, regenerate
the filter by driving at a speed of at least 40 mph (60 km/h) until the warning lamp goes off.
If the warning lamp stays on, refer to the "Additivelevel" section.







Checks
12 V battery

The battery does not require anymaintenance.
However, check that the terminals
are clean and correctly tightened,
particularly in summer and winter.
The presence of this label, in particular with
the Stop & Star t s
ystem, indicates the use of a specific 12 V lead-acid battery with special
technology and specification. The involvement
of a CITROËN dealer or a qualified workshop isessential when replacing or disconnecting the battery. When carr
ying out work on the battery, refer
to the "12 V battery" section for details of theprecautions to be taken before disconnecting
the battery and following its reconnection. Unless other wise indicated, check these components in accordance with the MAINTENANCE AND WARR ANT Y GUIDE and accordin
g to your engine.
Other wise, have them checked by a CITROËN dealer or a qualified workshop.
On a new vehicle, the first operations of regeneration of the par ticle emissions filter may be accompanied by the smellof "burning", which is per fectly normal. Following prolonged operation of the vehicle at very low speed or at idle, you may, in exceptional circumstances,notice the emission of water vapour at the exhaust on acceleration. This does not affect the behaviour of the vehicle or the environment.
Particle emission filter (Diesel)
accompanied by an audible signal and amessage that there is a risk of blockage of
the particle emissions filter.
Air filter and passenger compartment filter
Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of
the replacement intervals for thesecomponents.
Depending on the environment (e.g. dusty
atmosphere) and the use of the vehicle (e.g. city
driving), replace them twice as often if necessar y.y A clogged passenger compar tment filter may have
an adverse effect on the performance of the air conditioning system and generate undesirableodours.

Replace the oil filter each time the
engine oil is changed.
Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of
the replacement interval for thiscomponent.
Oil filter

Practical information
158
Changing direction indicator bulbs
)Turn the bulb holder a quar ter of a turn and extract it. )Pull out the bulb and change it.
To r e f i t , c a r ry out these operations in reverse order.
Changing dipped beam headlamp bulbs
)Remove the protective cover by pulling the
tab. )Disconnect the bulb connector. )Spread the springs to release the bulb.)Pull the bulb out and change it.
To r e f i t , c a r ry out these operations in reverse order.

Rapid flashing of the direction indicator warning lamp (right or left) indicates thefailure of a bulb on that side.
When refitting, close the protective cover carefully to preser ve the sealing
of the headlamp.

Amber coloured bulbs, such as thedirection indicators, must be replacedwith bulbs of identical specificationsand colour.

11
Practical information
177

To w i ng your vehicle
)On the front bumper, unclip the cover bypressing at the bottom. )Screw the towing eye in fully. )Install the towing bar. )Place the gear lever in neutral (position N
for an electronic or automatic gearbox).
) On the rear bumper, unclip the cover bypressing at the bottom. )
Screw the towing eye in fully. )
Install the towing bar. )
Switch on the hazard warning lamps on both vehicles.)
Move off gently and drive for a shor t distance only.



To w i ng another vehicle
Failure to obser ve this special condition could result in damage to cer tain components (braking, transmission...) and the absence of braking assistance the next time the engine is star ted.
)
Unlock the steering by turning the key one
notch in the ignition switch and release the
parkin
g brake. ) Switch on the hazard warning lamps onboth vehicles. )
Move off gently and drive for a shor t
distance only.

11
Practical information
179
Braking
To w i ng a trailer increases the braking distance.
To avoid overheating of the brakes on a long
mountain type of descent, the use of engine braking is recommended.
Tyres
)
Check the tyre pressures of the towing
vehicle and of the trailer, obser ving therecommended pressures.
Lighting
) Check the electrical lighting and signallingon the trailer.
The rear parking sensors will bedeactivated automatically if a genuine CITROËN towbar is used.


Cooling

To w i ng a trailer on a slope increases the
temperature of the coolant.

As the fan is electrically controlled, its coolingcapacity is not dependent on the engine speed. )To lower the engine speed, reduce your speed.
The maximum towed load on a long incline
depends on the
gradient and the ambient
temperature.
In all cases, keep a check on the coolant
temperature.
)
If the warning lamp and the STOP
warning lamp come on,stop the vehicle and switch off
the engine as soon as possible.

Practical information
182
"Comfort"sun blinds, door deflectors, insulated module, smoking kit, fragrance car tridges, front centre armrest, moveable mirror, reading lamp, front and rear parking sensors, cup holder, coat hanger for head restraint, solar film for
windows, security film for windows...
"Security and safety":
anti-theft alarm, wheel security bolts, stolen
vehicle tracking system, breathalyser, first aid
kit, warning triangle, high visibility vest, dog
guard, snow chains, non-slip covers, foglamps
kit, child seats and booster cushions, pet
transpor t protectors...
Conversion kits
You can obtain an "Enterprise" kit to conver t a
trade vehicle to a private car and vice-versa.

"St
yle":leather steering wheel, gear lever knobs, front spoiler, rear diffuser, bumper trims, front foglamp trims, parking brake lever trims,
aluminium footrest, alloy wheels, wheel trims,chrome tailgate finisher, chrome tailpipe finisher, chrome mirror shells, chrome door
h
andles...
"Transport solutions":boot tray, boot carpet, boot net, boot containers, transverse roof bars, bicycle carrier,
ski carrier, roof boxes, towbars, towbar wiring
h
arnesses...





Accessories A wide range of accessories and genuine par ts is available from the CITROËN dealer network.
These accessories and par ts have been tested and approved for reliability and safety.
They are all adapted to your vehicle and benefit from CITROËN's recommendation and warranty.

*
To avoid any risk of jamming of the pedals:
- ensure that the mat is positioned and
secured correctl
y,
- never fit one mat on top of another.
"Protection":mats *
, mudflaps, seat covers, door sillprotectors, bumper protection strips, vehicleprotective cover, side protectors, boot mat, boot
liner...
If a towbar and wiring are fitted outsidethe CITROËN dealer network, this must be done making use of the vehicle's electrical pre-equipment and followingthe manufacturer's recommendations.

11
Practical information
183
"Multimedia":Bluetooth®hands-free kit, suppor t for Bluetooth®hands-free kit, audio systems withsteering controls interface, por table satellite
navigation system, semi-integral por table navigation system carrier, mapping updates
for integral navigation system, DVD player,
auxiliary cable for connecting a por table MP3player, USB Box, Hi-Fi module, speakers, Wi-Fi
on board, rear multimedia support, telephone/smartphone support, 230 V socket, telephonecharge compatible with iPhone...
Installation of radiocommunicationtransmitters
Before installing any after-market radiocommunication transmitter, you cancontact a CITROËN dealer for thespecification of transmitters which can be fitted (frequency, maximum power,aerial position, specific installation requirements), in line with the Vehicle Electromagnetic Compatibility Directive (2004/104/EC).

Depending on the legislation in forcein the country, it may be compulsory to have a high visibility safety vest,warning triangle and spare bulbs andfuses available in the vehicle.
By going to a CITROËN dealer, you can also
obtain cleanin
g and maintenance products (interior and exterior) - including ecological products in the "TECHNATURE" range - products for topping up (screenwash fluid...),
touch up pens and paint aerosols for the exact
colour of your vehicle, recharges (cartridge for
the temporary puncture repair kit...), ...
The fitting of electrical equipment or accessories which are not recommended by CITROËN may resultin a failure of your vehicle's electronicsystem and excessive electrical consumption. Please note this precaution. Youare advised to contact a CITROËNrepresentative to be shown the range of recommended equipment and accessories.