Page 52 of 284
Multifunction screens
50
16/9 colour screen (eMyWay)
It displays the following information automatically and directly:
- time,
- date,
- altitude,
- ambient temperature
(the value displayed
flashes if there is a risk of ice),
- check of the doors,
- warning and vehicle function status messages, displayed temporarily,
- audio functions,
- trip computer information (see the "Monitoring" section),
- satellite navigation system information.
Controls
To select one of the applications, from theeMyWay control panel: )
press the dedicated "RADIO"
, "MUSIC","NAV"
, "TRAFFIC", "SETUP"
or "PHONE"
button for access to thecorresponding menu, )
turn the knob to change the selection, )
press the knob to confirm the selection,
or ) press the "Back"button to abandon thecurrent operation and return to the previous
display.
For more in
formation on these applications, refer to the "Audio and Telematics" section or
to the specific user guide given to you with the other owner's documents.
"SETUP" menu
)Press the "SETUP"button to gain access
to the "SETUP"
menu. This allows you to select from the following functions:
- "System language",
- "Date and time",
- "Displa
y",
- "Vehicle",
- "Units",
- "S
ystem".
Displays in the screen
Page 58 of 284
Comfort
56
With the heating /
ventilation s
ystem
)Put the temperature and air flow controls to
t
he dedicated marked position. )Put the air intake control to the "Exterior air intake" position (manual control to the right or electric control with indicator lamp off). )Put the air distribution control to the"Windscreen" position.
Front demist - defrost
These markings on the control panel indicate the control positions for rapid demisting or
defrosting of the windscreen and side windows.
With the manual air
conditioning system
)
Put the temperature and air flow controls to
t
he dedicated marked position. ) Put the air intake control to the "Exterior air
intake" position
(manual control to the right or electriccontrol with indicator lamp off). ) Put the air distribution control to the "Windscreen" position. )
Switch on the air conditioning by pressingthe "A/C"
button; the associated green
warning lamp comes on.
With Stop & Star t, when the demisting, air conditioning and air flow functionsare activated, STOP mode is not available.
Page 69 of 284
4
Access
67
Folding the key
)First press this button to fold the key.
If you do not press the button when foldingthe key, there is a risk of damage to themechanism.
Anti-theft protection
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched
on, this code must be recognised in order for
startin
g to be possible.
This electronic engine immobiliser locks the
engine management system a few minutes after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
In the event o
f a fault, you are
informed by illumination of this
warning lamp, an audible signal anda message in the screen.
Ignition switch
- Position 1: Stop
- Position 2: Ignition
- Position 3: Starting
Starting the vehicle
)
Inser t the key in the ignition switch.
The system recognises the star ting code. ) Turn the key fully towards the dashboard toposition 3 (Starting). )
When the engine star ts, release the key.
Locating your vehicle
)
Press the closed padlock to locate your locked vehicle in acar park.
This is indicated b
y lighting of the cour tesylamps and flashing of the direction indicators for a few seconds. In this case,
your vehicle will not start; contact a CITROËN dealer as soon as possible.
Keep safely the label attached to the keys given
to you on acquisition of the vehicle.
Page 70 of 284
Access
68
Remote control problem
Reinitialisation
)
Switch off the ignition. )
Turn the key to position 2 (Ignition on)
. )
Press the closed padlock immediately for a few seconds. )
Switch off the ignition and remove the key from the ignition switch.
The remote control is full
y operational again.
Changing the battery
Battery ref.: CR1620 / 3 volts.
If the batter
y is flat, you are informed by illumination of this warning lamp,
an audible signal and a message in
the multifunction screen.
)Unclip the casing using a coin at the notch. )Slide the flat battery out of its location. )Slide the new battery into its location
observing the original direction. )Clip the casing. )Reinitialise the remote control.
Switching the vehicle off
Key reminder
If the key is left in the ignition switch, an audible signal sounds when the driver's door is opened.
Do not attach any heavy objects to the key as this could weigh down on it when in the ignition switch and cause a fault. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or
in the event of a remote control malfunction,you can no longer unlock, lock or locate your
v
ehicle. ) First of all, use the key in the lock to unlock or lock your vehicle. )
Then, reinitialise the remote control.
If the problem persists, contact a CITRO
Page 74 of 284
Access
72
Doors
Opening
From out side
)After unlocking the vehicle using theremote control or the key, pull the door handle.
From inside
)
Pull the front door control to open the door;
this unlocks the vehicle completely. ) Pull the rear door control to open the door;
this unlocks only the door opened.
Closing
- When the engine is running
, this
warning lamp comes on, accompanied
by a message in the multifunction screen for a few seconds,
When a door or the boot is not closed correctly:
- When the vehicle is movin
g
(speed higher than 6 mph (10 km/h)), this warning
lamp comes on, accompanied by anaudible signal and a message in the multifunction screen for a few seconds.
Page 77 of 284
4
Access
75
Boot
)After unlocking the vehicle using theremote control or the key, pull the handleand raise the tailgate.
)
Lower the tailgate using the interior grab
handle.
-when the engine is running, this
warning lamp comes on, accompanied
b
y a message on the multifunctionscreen for a few seconds,
Tailgate release
Unlocking
)
Fold back the rear benchseat to gainaccess to the lock from inside the boot. )
Insert a small screwdriver into hole Aof thelock to unlock the tailgate.
I
f the tailgate is not closed correctly:
Opening Closing
-when the vehicle is moving
(speed above6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
a messa
ge on the multifunction screen for a few seconds.
System for mechanical unlocking of the boot
in the event of a battery or central locking
malfunction.
Page 78 of 284
Access
76
Fuel tank
Low fuel level
When the fuel tank minimum level is
reached this warning lamp comes on on the instrument panel. When it first comes on there remains approximately5 litres
of fuel in the tank.
Filling
A label affixed to the inside of the flap remindsyou of the type of fuel to be used depending onyour engine.
Additions of fuel must be of at least 7 litres, in
order to be registered by the fuel gauge. To
fill the tank safely: )the engine must be switched off, )
open the fuel filler flap,
)
inser t the key in the cap, then turn it to the left,
)
remove the cap and hook it onto the clip located on the inside of the flap, )
fill the tank, but do not continue after the3rd cut- off of the pump; this could cause
malfunctions.
When
you have filled the tank: )
put the cap back in place, )
turn the key to the right, then remove itfrom the cap, )
close the flap.
You must refuel as soon as possible to avoid
running out of fuel.
If you run out of fuel (Diesel), refer also to the
"Checks" section. Fuel tank capacity: approximately
50 litres (petrol) or 46 litres (Diesel) or 37 litres (LPG); (Depending on version:
approximately 30 litres (petrol or Diesel)).
With Stop & Star t, never refuel with the system in STOP mode; you must switch off the ignition with the key.
The key cannot be removed from thelock until the cap is refitted. Opening the filler cap may create anoise caused by an inrush of air. This vacuum is entirely normal, resulting from the sealing of the fuel system.
Page 83 of 284
5
Visibility
81
Manual guide-me-home
lighting
The temporary illumination of the dipped beamheadlamps after the vehicle's ignition has been switched off makes the driver's exit easier when
the light is poor.
Switching on
) With the ignition off, "flash" the headlamps using the lighting stalk. )
A further "headlamp flash" switches thefunction off.
Switching off
The manual guide-me-home lighting switches
off automatically after a set time.
In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.
Lighting on audible warning
When the ignition is switched off, allof the lamps switch off automatically, unless guide-me-home lighting is activated.
If the lighting is switched on manuallyafter switching off the ignition, thereis an audible signal when a front door is opened to warn the driver that they have forgotten to switch off the vehicle'slighting, with the ignition off.
