2013 Citroen C3 bonnet

.
.
Contents
Direction indicators 105
Hazard warning lamps 105
Horn 106
Emergency or assistance call 106
Braking assistance systems 107
Tr ajectory control systems 108
Front seat belts 109
Airbags 111
Safety
Parking brake 115
6-speed manual gearbox 115
Gear effi ciency indicator 116
Electronic gearbox 117
Automatic gearbox 121
Stop & Start 124
Hill start assist 127
Speed limiter 128
Cruise control 130
Rear parking sensors 132
Reversing camera 134
Driving
Emergency or assistance 195
eMyWay 197
Audio system 251
Audio and telematics
Alphabetical index
Bonnet 136
Running out of fuel (Diesel) 137
Petrol engines 138
Diesel engines 139
Checking levels 140
Checks 142
Checks
Te m p o r a ry puncture repair kit 144
Changing a wheel 149
Snow chains 156
Changing a bulb 157
Changing a fuse 164
Battery 171
Energy economy mode 174
Changing a wiper blade 175
To w i ng the vehicle 176
To w i ng a trailer 178
Audio pre-equipment 180
Accessories 182
Practical informationTechnical data
Petrol engines 184
Petrol wei
ghts 185
LPG engines 187
LPG weights 188
Diesel engines 189
Diesel weights 191
Dimensions 193
Identifi cation markings 194
Visual search

.Familiarisation
5

Remote control key Fuel t ank
1.Opening the fuel filler flap. 2.
Removing and hooking the fuel filler cap. A. Unfolding / Folding the key. B.Unlocking the vehicle.
A.Interior release lever.
B. Exterior safety catch.
C. Bonnet stay.


Bonnet
Ta n k c a p a c i ty:
- approximately 50 litres (petrol),
- approximately 46 litres (Diesel),
- approximately 37 litres (LPG). (depending on version: approximately 30 litres
environ (petrol or Diesel)).
Access
66
Other functions...C.
Locking the vehicle .
Vehicle location.
7
6

1
36

Familiarisation
8
1. Cruise control / speed limiter controls. 2.
Headlamp height adjustment. 3.
Steering wheel adjustment control.4.
Lighting and direction indicator control stalk.5.
Instrument panel.
6.Driver's airbag.
Horn.
7
. Gear lever.8.12 V accessory socket
USB por t / auxiliary socket. 9. Heated seat control. 10.Bonnet release lever.11.
Door mirror controls.Electric window controls.Rear doors and electric windows deactivation switch.12.Fusebox.13.Stop & Start switch
Electronic stability programme switch (ESP/ASR).14 .Front door window demisting/defrosting
vent. 15. Speaker (tweeter). 16.
Windscreen demisting/defrosting vent.

Instruments and controls

.Familiarisation
19

Stop & Start


Going into engine STOP mode
The "ECO"warning lamp comes
on in the instrument panel and the
engine goes into standby:
-with a manual gearbox:
at speeds below
12 mph (20 km/h), when you put the gear
lever into neutral and you release the clutch pedal,

-
with a 5 or 6-speed electronic gearbox:at speeds below 5 mph (8 km/h), when you press the brake pedal or you move the gear lever to position N.

In some circumstances, STOP mode may notbe available; the "ECO"warning lamp flashes for a few seconds, then goes off.
Going into engine START mode

The "ECO"
warning lamp goes off
and the engine restarts:
-with a manual gearbox:when youdepress the clutch pedal,
-with a 5 or 6-speed electronic gearbox:

●
with the gear lever in position A
or M ,
when you release the brake pedal,

●
or with the gear lever in position N
andthe brake pedal released, when you put
the gear lever in position Aor M ,

●
or when you engage reverse.

In certain circumstances,
START mode may beinvoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off.

Deactivation / Reactivation
You can deactivate the system at any time bypressing the "ECO OFF"
switch; the warninglamp in the button comes on.

Driving safely
124

125

12
5
The system is reactivated automatically every time the vehicle is star ted using the key.
Before refueling or doing anything under the bonnet, you must switch off the ignition with the key.

Visibility
86
Automatic rain sensitive
w
indscreen wipers
The windscreen wipers operate automatically,
without any action on the par t of the driver, if rain is detected (sensor behind the rear view mirror), adapting their speed to the intensity of
the rainfall.
Activation
Switchin
g off
Operatin
g fault

If an automatic wiping fault occurs, the wipers
will operate in intermittent mode.
Have it checked by a CITROËN dealer or aqualified workshop.
Vertical windscreen wiper
position

This position allows the wiper blades to be lifted
for winter parking, cleaning or replacement
without damaging the bonnet.
In the minute following switching off of the ignition, any action on the wiper stalk positions
the wipers vertically.
To park the wipers after this has been done,switch on the ignition and operate the wiper stalk. This is controlled manuall
y by the driver bypushing stalk Ato the "AU TO "position.
This is controlled manually by the driver
by moving stalk Aupwards, returning it toposition "0"
. It is accompanied b
y the indicator lamp
in the instrument panel going off and a message in the multifunction screen.
It is accompanied by the illumination of this indicator lamp in the instrument panel anda message in the multifunction screen.
The automatic wiping must bereactivated if the ignition has been off for more than one minute, by pushing stalk A
downwards.
Do not cover the rain sensor, linked withthe sunshine sensor and located in thecentre of the windscreen behind therear view mirror. Switch off the automatic wiping whenusing an automatic car wash.
In winter, it is advisable to wait until thewindscreen is completely clear of icebefore activating the automatic wiping.

To retain the effectiveness of the "flat-blade" wiper blades, it is advisable to:


- handle them with care,

- clean them regularly using soapywater,

- not use them to hold a sheet of cardboard against the windscreen,

- replace them at the first signs of wear.

Driving
120

In exceptional circumstances, the gearbox may need an automaticreinitialisation: starting and gear changing are no longer possible.
Reverse
To e ngage reverse, the vehicle must be
immobilised with your foot on the brake. )Select position R.

Operating fault

With the ignition on, if this warninglamp comes on and AUTOflashes,
accompanied by an audible signal
and a message in the multifunction
screen, this indicates a gearbox
fault.Have it checked by a CITROËN
dealer or a qualified workshop.
At low speed, if reverse gear is requested,
the N warning lamp flashes and the gearbox
goes into neutral automatically.
To e n
gage reverse, put the gear lever intoposition N
, then to position R
.
Stopping the vehicle
Before switching off the engine:
- change to position N
to be in neutral,or
- leave the vehicle in gear; in this case the
vehicle cannot be moved.

Reinitialisation
(5-speed electronic
gearbox)

Following disconnection of the battery, it is
necessary to reinitialise the gearbox.) Switch on the ignition.
AUTO
and - -
appear in the
instrument panel.
) Select position N
. )
Press the brake pedal.)
Wait for around 30 seconds until N
or agear appears in the instrument panel.)
Move the gear lever to position A , then to
position N.) With your foot still on the brake pedal, start
the engine.
The gearbox is operational again.
AUTOand --appear in the
instrument panel.

Follow the procedure described above.

Before doing anything under thebonnet, ensure that the gear lever is in neutral (position N) and that the parking brake is applied.
There is an audible signal on engagement of reverse.

For all parking situations, you mustapply the parking braketo immobilise the vehicle.
When immobilising the vehicle with the engine running, you must put the gear lever into neutral (position N)
.

Driving
126

Operating fault
Maintenance

In the event of a fault with the system, the
"ECO OFF"
switch warning lamp flashes thencomes on continuously.
Have it checked by a CITROËN dealer or aqualified workshop.
In the event of a fault in STOP mode, the
vehicle ma
y stall. All of the instrument panel
warning lamps come on. It is then necessary
to switch o
ff the ignition and star t the engine
again using the key. This s
ystem requires a battery with a specialspecification and technology (reference numbers available from a CITROËN dealer or a qualified workshop).
Fitting a battery not listed by CITROËN
introduces the risk of malfunction of the system.
Press the "ECO OFF"switch again.
The system is active again; this is con
firmed
by the switch warning lamp going off,accompanied by a message in the screen.

Before doing anything under the bonnet,deactivate the Stop & Start system toavoid any risk of injury resulting from automatic operation of STA R T m o d e .


The system is reactivated automaticallyat every new star t using the key.


The Stop & Star t system makes use of advanced technology. All workon this type of battery must be doneby a CITROËN dealer or a qualifiedworkshop.
Reactivation

Checks
136








Bonnet Protects the components of the engine and provides access for checking levels.
Opening
)Push the exterior safety catch B
to the left and raise the bonnet.
)Unclip the bonnet stay C
from its housing,
holdin
g it by its foam protection. )Fix the stay in the notch to hold the bonnet open.
)Take the stay out of the support notch.
)Clip the stay in its housing. )Lower the bonnet and release it at the end of its travel. )Pull on the bonnet to check that it is fully
latched.
)Open the front left door.)Pull the interior release lever A
, located at
the bottom of the door aperture.
The location of the interior release lever prevents opening of the bonnet while the front left door is closed.
When the engine is hot, handle the exterior safety catch and the stay with care.
Before doing anything under the bonnet,
switch off the Stop & Star t system toavoid any risk of injury resulting from anautomatic change to START mode.


Closing
To a v o i d d a m aging the electric units,the use of a high pressure jet wash under the bonnet is strictly prohibited.