Page 65 of 92
EAU23095
Checking and lubricating the
cables
The operation of all control cables
and the condition of the cables
should be checked before each ride,
and the cables and cable ends should
be lubricated if necessary. If a cable is
damaged or does not move smoothly,
have a Yamaha dealer check or repla-
ce it. WARNING! Damage to the
outer housing of cables may result
in internal rusting and cause inter-
ference with cable movement.
Replace damaged cables as soon
as possible to prevent unsafe con-
ditions.
[EWA10711]EAU23114
Checking and lubricating the
throttle grip and cable
The operation of the throttle grip
should be checked before each ride.
In addition, the cable should be lubri-
cated by a Yamaha dealer at the inter-
vals specified in the periodic mainte-
nance chart.
The throttle cable is equipped with a
rubber cover. Make sure that the
cover is securely installed. Even
though the cover is installed correctly,
it does not completely protect the
cable from water entry. Therefore, use
care not to pour water directly onto
the cover or cable when washing the
vehicle. If the cable or cover becomes
dirty, wipe clean with a moist cloth.
EAU23120
Adjusting the Autolube pump
The Autolube pump is a vital and sop-
histicated component of the engine,
which must be adjusted by a Yamaha
dealer at the intervals specified in the
periodic maintenance and lubrication
chart.
Recommended lubricant:
Yamaha Chain and Cable Lube or
engine oil
PERIODIC MAINTENANCE AND ADJUSTMENT
6-28
6
1HD-F819D-E0 7/3/11 20:27 Página 65
2AS-F819D-E0.indd 6531/07/12 10:09
Page 66 of 92
EAU44272
Checking and lubricating the
brake and shift pedals
Brake pedal
Shift pedalThe operation of the brake and shift
pedals should be checked before
each ride, and the pedal pivots
should be lubricated if necessary.
EAU23142
Checking and lubricating the
brake and clutch levers
Brake lever
Clutch lever
Recommended lubricant:
Lithium-soap-based grease
PERIODIC MAINTENANCE AND ADJUSTMENT
6-29
6
1HD-F819D-E0 7/3/11 20:27 Página 66
2AS-F819D-E0.indd 6631/07/12 10:09
Page 67 of 92
The operation of the brake and clutch
levers should be checked before each
ride, and the lever pivots should be
lubricated if necessary.EAU23202
Checking and lubricating the
sidestand
The operation of the sidestand should
be checked before each ride, and the
sidestand pivot and metal-to-metal
contact surfaces should be lubricated
if necessary.
EWA10731
If the sidestand does not move up
and down smoothly, have a Yama-
ha dealer check or repair it. Other-
wise, the sidestand could contact
the ground and distract the opera-
tor, resulting in a possible loss of
control.
Recommended lubricant:Lithium-soap-based grease
WARNING
Recommended lubricants:Brake lever: Silicone grease
Clutch lever: Lithium-soap-based grease
PERIODIC MAINTENANCE AND ADJUSTMENT
6-30
6
1HD-F819D-E0 7/3/11 20:27 Página 67
2AS-F819D-E0.indd 6731/07/12 10:09
Page 68 of 92
EAU23272
Checking the front fork
The condition and operation of the
front fork must be checked as follows
at the intervals specified in the perio-
dic maintenance and lubrication
chart.
To check the condition1. Check the inner tubes for scrat- ches, damage and excessive oil
leakage.
To check the operation 1. Place the vehicle on a level surfa- ce and hold it in an upright posi-
tion. WARNING! To avoid injury,
securely support the vehicle so
there is no danger of it falling
over.
[EWA10751]
2. While applying the front brake, push down hard on the handle-
bars several times to check if the
front fork compresses and
rebounds smoothly.
ECA10590
If any damage is found or the front
fork does not operate smoothly,
have a Yamaha dealer check or
repair it.
EAU23283
Checking the steering
Worn or loose steering bearings may
cause danger. Therefore, the opera-
tion of the steering must be checked
as follows at the intervals specified in
the periodic maintenance and lubrica-
tion chart.1. Place a stand under the engine to raise the front wheel off the
ground. WARNING! To avoid
injury, securely support the
vehicle so there is no danger of
it falling over.
[EWA10751]
2. Hold the lower ends of the front fork legs and try to move them for-
ward and backward. If any free
play can be felt, have a Yamaha
dealer check or repair the steering.
NOTICE
PERIODIC MAINTENANCE AND ADJUSTMENT
6-31
6
1HD-F819D-E0 7/3/11 20:27 Página 68
2AS-F819D-E0.indd 6831/07/12 10:09
Page 69 of 92
EAU23291
Checking the wheel bearings
The front and rear wheel bearings
must be checked at the intervals spe-
cified in the periodic maintenance and
lubrication chart. If there is play in the
wheel hub or if the wheel does not
turn smoothly, have a Yamaha dealer
check the wheel bearings.
EAU23445
Battery
1. Battery
This model is equipped with a VRLA
(Valve Regulated Lead Acid) battery.
There is no need to check the elec-
trolyte or to add distilled water. Howe-
ver, the battery lead connections
need to be checked and, if necessary,
tightened.
EWA10760
Electrolyte is poisonous and
dangerous since it contains
sulfuric acid, which causes
severe burns. Avoid any con-
tact with skin, eyes or clothing
and always shield your eyeswhen working near batteries.
In case of contact, administer
the following FIRST AID.
• EXTERNAL: Flush with plenty of water.
• INTERNAL: Drink large quan- tities of water or milk and
immediately call a physician.
• EYES: Flush with water for 15 minutes and seek prompt
medical attention.
Batteries produce explosive
hydrogen gas. Therefore, keep
sparks, flames, cigarettes, etc.,
away from the battery and provi-
de sufficient ventilation when
charging it in an enclosed space.
KEEP THIS AND ALL BATTE-
RIES OUT OF THE REACH OF
CHILDREN.
To charge the battery
Have a Yamaha dealer charge the
battery as soon as possible if it seems
to have discharged. Keep in mind that
the battery tends to discharge more
quickly if the vehicle is equipped with
optional electrical accessories.WARNING
PERIODIC MAINTENANCE AND ADJUSTMENT
6-32
6
1HD-F819D-E0 7/3/11 20:27 Página 69
2AS-F819D-E0.indd 6931/07/12 10:09
Page 70 of 92
ECA16521
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (cons-
tant-voltage) battery charger is
required. Using a conventional bat-
tery charger will damage the bat-
tery.
To store the battery1. If the vehicle will not be used for more than one month, remove
the battery, fully charge it, and
then place it in a cool, dry place.
NOTICE: When removing the
battery, be sure the key is tur-
ned to “ ” then disconnect
the negative lead before dis-
connecting the positive lead.
[ECA16302]
2. If the battery will be stored for more than two months, check it
at least once a month and fully
charge it if necessary.
3. Fully charge the battery before installation. NOTICE: When ins-
talling the battery, be sure the
key is turned to “ ”, then connect the positive lead befo-
re connecting the negative
lead.
[ECA16840]
4. After installation, make sure that
the battery leads are properly
connected to the battery termi-
nals.
1. Negative battery lead (black)
2. Positive battery lead (red)
ECA16530
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
EAU23482
Replacing the fuse
1. Main fuse
2. Spare main fuse
The fuse holder is located under the
seat. (See page 3-12).
If the fuse is blown, replace it as
follows.1. Turn the key to “ ” and turn off all electrical circuits.
2. Remove the blown fuse, and then install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher ampera-
ge rating than recommended
to avoid causing extensive
damage to the electrical sys-
tem and possibly a fire.
[EWA15131]
NOTICE
NOTICE
PERIODIC MAINTENANCE AND ADJUSTMENT
6-33
6
1HD-F819D-E0 7/3/11 20:27 Página 70
2AS-F819D-E0.indd 7031/07/12 10:09
Page 71 of 92
3. Turn the key to “ ” and turn onthe electrical circuits to check if
the devices operate.
4. If the fuse immediately blows again, have a Yamaha dealer
check the electrical system.
EAU23804
Replacing the headlight bulb
This model is equipped with a halo-
gen bulb headlight. If the headlight
bulb burns out, replace it as follows.
ECA10650
Take care not to damage the follo-
wing parts:
Headlight bulb
Do not touch the glass part of
the headlight bulb to keep it
free from oil, otherwise the
transparency of the glass, the
luminosity of the bulb, and the
bulb life will be adversely affec-
ted. Thoroughly clean off any
dirt and fingerprints on the
headlight bulb using a cloth
moistened with alcohol or thin-
ner.
Headlight lens
Do not affix any type of tinted
film or stickers to the headlight
lens.
Do not use a headlight bulb of
a wattage higher than speci-
fied.
1. Do not touch the glass part of the bulb.
1. Remove the headlight bulb cover,and then disconnect the head-
light lead connectors.
1. Headlight bulb cover
2. Unhook the headlight bulb hol-der, and then remove the burnt-
out bulb.
NOTICE
Specified fuse:10.0 A
PERIODIC MAINTENANCE AND ADJUSTMENT
6-34
6
1HD-F819D-E0 7/3/11 20:27 Página 71
2AS-F819D-E0.indd 7131/07/12 10:09
Page 72 of 92
1. Unhook the headlight bulb holder
2. Take the headlight bulb holder off
3. Headlight bulb holder
3. Place a new headlight bulb intoposition, and then secure it with
the bulb holder.
4. Connect the headlight lead con- nectors, and then install the bulb
cover.
5. Have a Yamaha dealer adjust the headlight beam if necessary.
EAU24133
Replacing the tail/brake light
bulb
1. Remove the tail/brake light lensby removing the screws.
1. Screw
2. Tail/Brake light lens
3. Tail/brake light bulb
2. Remove the burnt-out bulb bypushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket, push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
[ECA10681] EAUS1352
Replacing a front turn signal
light bulb
ECA10670
It is advisable to have a Yamaha
dealer perform this job.
1. Remove the socket (together
with the bulb) by turning it coun-
terclockwise for the right turn sig-
nal and turning it clockwise for
the left turn signal.
1. Turn signal light bulb socket
2. Remove the burnt out bulb bypulling it out.
NOTICE
PERIODIC MAINTENANCE AND ADJUSTMENT
6-35
6
1HD-F819D-E0 7/3/11 20:27 Página 72
2AS-F819D-E0.indd 7231/07/12 10:09
