2012 SSANGYONG RODIUS engine

02-14
▶ Speed Sensitive INT (Intermittent) Wiper
For STICS without rain sensor, perform the following operation:
1. Controls the wiper intermittent operation by the values from vehicle speed and volume.
Calculates and converts the Intermittent interval automatically by using the vehicle speed and
<00700075007b0047007d00760073007c0074006c0047009e008f008c00950047009b008f008c00470090008e00950090009b0090009600950047009a009e0090009b008a008f00470090009a004700900095004702c80076007502c9004700970096009a00
90009b009000960095004700880095008b0047009b008f008c> INT switch is in “ON”
position (the engine is running).
The wipers are operated in vehicle speed sensitive mode when turning the INT switch to
<02c80076007502c9004700970096009a0090009b0090009600950047009e0090009b008f0047009b008f008c0047008c0095008e00900095008c00470099009c0095009500900095008e0047009600990047009a009b00880099009b00900095008e004700
9b008f008c0047008c0095008e00900095008c0047009e0090>th the INT switch positioned
“ON”.
<00700095009b008c009900940090009b009b008c0095009b004700900095009b008c0099009d008800930047004f0088009b004700570047009200940056008f005000610047005a004700b7004700570055005c004700a5004700580060004700b7004700
590047009a008c008a00960095008b009a> -
-
-
2. Vehicle speed calculation
[Input the vehicle speed]
It is calculated by the numbers of input pulses for one second.
1 [pulses/sec] = 60 [km/h] x 60 [sec] / 637 pulses = 1.41 [km/h]
3. VOLUME calculation
Calculates the INT VOLUME with 5 grades as shown in the table in next page. -
4. Pause time calculation
Pause time: the duration that wipers are stopped at parking position
Elapsed time: the duration after the wiper motor started to operate from parking position
The pause time is calculated by the vehicle speed and VOLUME value as shown in the table
in next page. -
-
-
If the pause time is below 1.0 second, the wipers operate without pause.
If the pause time is over 1.5 seconds, the wipers operate intermittently. ·
·

02-28
10) Defogger Timer
<007b008f008c0047009a00a0009a009b008c009400470096009c009b0097009c009b009a0047009b008f008c0047009b008800900093008e0088009b008c00530047009e00900095008b009a008f0090008c0093008b004700880095008b00470096009c00
9b009a0090008b008c00470099008c00880099009d0090008c>w mirror heated glass “ON”
signal when turning on the defogger switch (while the engine is running).
The output stops when turning on the defogger switch again during its operation.
The out
put is “ON” only for 6 minutes (T3) when turning “ON” the rear defogger switch within 10
minutes (T2) after completion of output.
When turning on the defogger switch again within 10 minutes (T2) after completion of initial 12
minutes (T1) of output, the output comes on for 6 minutes (T3) again once only.
The output stops when the IGN 2 switch is turned to “OFF” position or the ALT is “OFF”. 1.
2.
3.
4.

02-298710-01
This vehicle has the windshield heated glass and the tailgate and outside rearview mirror heated
glass. The heater relay in the ICM box controls the tailgate and outside rearview mirror heated
glass and its fuse (15A) is located in the engine compartment fuse box.
Windshield, rear rear glass and outside
rearview mirror heated glass switch

02-38
▶Armed mode cancellation requirements
Unlocking by remote control key or engine starting. 1.
▶Warning operation requirements
When opening the door in armed mode
When unlocking the door lock switch in armed mode
When closing and then opening the door after completion of warning (27 seconds) 1.
2.
3.
▶Warning operation
<007b008f008c0047009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047008f009600990095004700880095008b0047008f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c00
9900470096009c009b0097009c009b00470090009a004702c8>ON” for T3 (27 seconds) with
the interval of T2 (1second). 1.
▶Warning cancellation requirements
Cancels warning by using any signal from the remote control key (LOCK, UNLOCK, START,
STOP, PANIC, CHECK) during warning operation.
<006a00880095008a008c0093009a0047009e00880099009500900095008e00470088008d009b008c009900470059005e0047009a008c008a00960095008b009a0047004f0099008c009400880090009500900095008e00470097008c009900900096008b00
500047009e008f00900093008c0047009b008f008c00470090>gnition key is turned to “ON”
position. 1.
2.
▶Operation when warning is cancelled
<007b008f008c0047009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047008f009600990095004700880095008b0047008f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c00
9900470096009c009b0097009c009b009a004700880099008c> “OFF”. 1.

02-398710-01
The PANIC warning outp<009c009b00470090009a004702c80076007502c90047004f009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047008f00960099009500500047009e008f008c009500470099008c008a008c0090009d00900095008e0047009b00
8f008c00470077006800750070006a0047009a0090008e0095>al from
the remote control key (pressing PANIC button for less than 0.5 ~ 1.0 second).
<007b008f008c00470077006800750070006a0047009e00880099009500900095008e00470096009c009b0097009c009b00470090009a004702c80076006d006d02c90047009e008f008c009500470099008c008a008c0090009d00900095008e0047008800
9500a00047009a0090008e0095008800930047008d00990096>m the remote control key
during PANIC warning.
Followings are theft deterrent warnings:
This function operates only in armed mode.
The system sends the current vehicle conditions (LOCK, engine running) when the PANIC
warning is turned off by the remote control key. 1.
2.
3.
4.
5.The theft deterrent warning is canceled when receiving PANIC signal from the remote control
key during theft deterrent.
<007b008f008c0047009b008f008c008d009b0047008b008c009b008c00990099008c0095009b0047009e00880099009500900095008e00470096009c009b0097009c009b00470090009a004702c80076007502c90047009e008f008c00950047009b008f00
8c0047009b008f008c008d009b0047008b008c009b008c0099>rent conditions are
<008c009a009b0088008900930090009a008f008c008b0047008b009c009900900095008e00470077006800750070006a0047009e00880099009500900095008e0047004f0077006800750070006a00470096009c009b0097009c009b00470090009a004702
c80076006d006d02c900500055>
<007b008f008c00470077006800750070006a0047009e00880099009500900095008e00470096009c009b0097009c009b00470090009a004702c80076007502c90047009e008f008c009500470099008c008a008c0090009d00900095008e0047009b008f00
8c00470077006800750070006a0047009a0090008e00950088>l from the remote control
key in Armed Ready / Armed / Warning Completion / Relock Ready mode (maintaining the
theft deterrent mode). 1)
2)
3)
(2) PANIC Warning

03-57010-06
2. OVERVIEW
The Immobilizer System provides an additional theft deterrent to the vehicle in which it is installed
and prevents it from being started by unauthorized persons. The transponder integrated in the key
and the engine control unit have the same code. When the ignition key with the integrated
transponder is turned to the ON position, the ECU (Engine Control Unit) checks the crypto code
of the key and, if correct, allows the vehicle to start the engine. If the verification has been failed,
the engine cannot be started and the immobilizer warning lamp blinks.
Immobilizer unit

03-6
Transponder
3. VERIFICATION OF KEY
1) Verification
The immobilizer system prevents the vehicle theft by allowing only the authorized key to start the
engine. The transponder inside the key communicates with the immobilizer installed in the key
box, and the system permits the engine to start after confirming the encrypted coding from the
engine ECU.
In the following cases, a driver may be unable to start the vehicle with the immobilizer.The immobilizer unit transmits
the encrypted code to the
transponder. (2)
The transponder sends an encrypted signal to the unit as a response.
The transmitted code is changed to an encrypted signal in the unit.
The system compares the signal from transponder and the encrypted signal in immobilizer unit. (3)
(4)
(5)
When two or more immobilizer keys come into contact with (each) other(s).
When the key is close to any device sending or receiving electromagnetic fields or waves.
When the key is close to any electronic or electric devices such as lightening equipment,
security keys or security cards.
When the key is close to a magnetic or metal object or a battery. -
-
-
-
Immobilizer Unit

03-77010-06
ECU
Immobilizer Indicator and Warning Lamp ▶
This indicator comes on when the ignition
key is communicating with the engine
control unit (during engine starting) and
goes out after starting the engine.
When turning the ignition key to ON
position, the ECU transmits the challenge
message to the immobilizer unit to verify
whether the key is valid. (1)
Only when the two signals are identical, it
recognizes the key as the authorized one and
transmits the positive message to the ECU.
The ECU allows the engine to be started. (6)
(7)
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, let the owner attend on the site.
In any case, the immobilizer system cannot be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove,
damage or modify it.
The remote engine starter cannot be installed on the vehicle equipped with the immobilizer
system. -
-
-
-
-Lamp ON: in communication
Blinking twice for one second: immobilize
r
system failure
Blinking once for two seconds: immobiliz
e
unit is not coded
The immobilizer indicator does not
come on if the communication time
between immobilizer key and ECU is
too short.
Immobilizer Indicator and Warning Lamp