2012 RENAULT KOLEOS Owners Manual

opening the doors ................................. (up to the end of the DU)
closing the doors .................................. (up to the end of the DU)
unlocking the doors .............................. (up to the end of the DU)
central door locking .............................. (up to the end of the DU)
1.11
ENG_UD23661_6
Verrouillage et déverouillage des portes (X45 - H45 - Renault)
ENG_NU_977-2_H45_Ph2_Renault_1
LOcKINg, UNLOcKINg ThE dOORs (1/2)
Locking/unlocking the doors
from the outside
This is done using the RENAULT
Card; refer to the information on the
RENAULT Card" in Section 1.
In certain cases, the RENAULT card
may not work:
– when the RENAULT card battery is
drained, flat battery, etc.
– use of appliances operating on the
same frequency as the card (mobile
phone, etc.);
– vehicle located in a high electromag-
netic radiation zone.
It is then possible:
– to use the key integrated into the
card to unlock the front left-hand
door;
– to lock each of the doors manually
(see the following page);
– to use the interior door locking/un -
locking control (refer to the following
pages).
Locking the doors manually
Turn screw 3 with the door open (using
the end of the key) and close the door.
This means that the doors are then
locked from the outside.
The doors may then only be opened
from the inside or by using the key in
the front left-hand door.
Using the key integrated in
the RENAULT card
– Take out the integrated key (refer
to the section on “RENAULT cards:
general information" in section 1) ;
– remove cover A from the left-hand
door (using the end of key 2 ) in
notch 1;
– move it upwards to remove cover A;
– insert the key 2 into the lock in the
front left-hand door and lock or
unlock.
A
1
2
3

1.12
ENG_UD23661_6
Verrouillage et déverouillage des portes (X45 - H45 - Renault)
ENG_NU_977-2_H45_Ph2_Renault_1
LOcKINg, UNLOcKINg ThE dOORs (2/2)
Locking the opening
elements without the
RENAULT card
(if the RENAULT card is not working, for
example)
With the engine switched off and a
front door open, press switch 4 for
more than five seconds.
When the door is closed, all the doors
and the tailgate will be locked.
Unlocking the vehicle from the outside
will only be possible with the RENAULT
card.
doors and tailgate status
indicator light
When the ignition is on, the indicator
light integrated in switch 4 informs you
of the status of the doors and tailgate:
– indicator light on, the doors and tail-
gate are locked;
– indicator light off, the doors and tail-
gate are unlocked.
When you lock the vehicle from the out-
side, the indicator light remains lit for
approximately one minute, then goes
out.
Interior locking/unlocking
door control
The switch 4 simultaneously controls
the doors and the tailgate.
If a door or the tailgate is open or not
closed properly, the doors and tailgate
lock/unlock quickly.
If transporting an object with a door
or tailgate open: with the engine
stopped , press the switch 4 for more
than five seconds to lock the other
opening elements.
4
driver’s responsibility
Never leave your vehicle
with the RENAULT card
inside.
driver’s responsibility
If you decide to keep the
doors locked when you are
driving, remember that it
may be more difficult for those as -
sisting you to gain access to the
passenger compartment in the
event of an emergency.

RENAULT ANTI-INTRUDER DEVICE (RAID) (up to the end of the DU)
central door locking .............................. (up to the end of the DU)
doors ..................................................... (up to the end of the DU)
locking the doors .................................. (up to the end of the DU)
1.13
ENG_UD27286_6
Condamnation automatique des ouvrants en roulage (X45 - H45 - Renault)
ENG_NU_977-2_H45_Ph2_Renault_1
Automatic locking of opening elements when driving
RAId (RENAULT ANTI-INTRUdER dEvIcE)
Operating principle
When the vehicle is started, the system
automatically locks the doors when the
vehicle reaches approximately 6 mph
(10 km/h).
The door can be unlocked:
– by pressing door unlocking button 1.
– by opening a front door (vehicle sta-
tionary).
Note: if a door is opened or closed,
it will automatically lock again when
the vehicle reaches a speed of 6 mph
(10 km/h). To activate this function:
After switching on the ignition and
when the vehicle is stationary
, you
have approximately 20 seconds to
press and hold door locking switch 1
(for approximately 5 seconds).
The message “Auto door lock on” is dis-
played on the instrument panel and a
beep sounds.
To deactivate this function:
After switching on the ignition and
when the vehicle is stationary, press
and hold door locking switch 1 for ap -
proximately 5 seconds.
The message “Auto door lock off” is dis-
played on the instrument panel and a
beep sounds.
Operating faults
If you experience an operating fault (no
automatic locking, the indicator light in-
corporated in button 1 does not light up
when trying to lock the doors and tail -
gate, etc.), firstly check that the doors
and tailgate are properly closed. If they
are closed correctly, contact an ap -
proved dealer.1
driver’s responsibility
If you decide to keep the
doors locked when you are
driving, remember that it
may be more difficult for those as -
sisting you to gain access to the
passenger compartment in the
event of an emergency.

headrest................................................ (up to the end of the DU)
front seats adjustment ...................................... (up to the end of the DU)
1.14
ENG_UD23932_3
Appuis-tête avant (X45 - H45 - Renault)
ENG_NU_977-2_H45_Ph2_Renault_1
Front headrests/Seats
fRONT hEAdREsTs
To remove the headrest
Raise the headrest as far as possible,
then while pressing button 1, raise the
headrest to release it.
To refit the headrest
Insert the headrest rods into the holes,
with the notches facing forwards.
Hold down button 1 and move the
headrest to the required height.
To raise the headrest
Pull the headrest upwards to the de -
sired height.
To lower the headrest
Press button 1 and guide the headrest
down to the desired height.
Adjusting the angle of the headrest
(depending on vehicle)
Tilt the headrest A forwards or back -
wards to the required position.
1
The headrest is important
for safety. Ensure that it is in
place and in the correct po-
sition: the top of the head -
rest should be as close as possible
to the top of the head and there must
be a minimal distance between the
head and the A headrest.
A

front seat adjustmentelectric controls ................................................ (current page)
front seat adjustment manual controls .............................. (up to the end of the DU)
front seats adjustment ...................................... (up to the end of the DU)
1.15
ENG_UD27217_3
Si ges avant (X45 - H45 - Renault)
ENG_NU_977-2_H45_Ph2_Renault_1
fRONT sEATs (1/2)
To raise or lower the seat base
(depending on vehicle)
Move lever 4 as required:
– move it upwards to raise the seat;
– move it downwards to lower the seat.
To tilt the seatback
Move lever 5 to control the angle of the
seatback.
front seat with electric
controls
To move the seat forwards or back
Move switch 1 forwards or backwards.
To raise or lower the seat base
Move the rear of switch 1 upwards or
downwards.
To tilt the seatback
Move the rear of switch 2 forwards or
backwards.
front seat with manual
controls
To move the seat forwards or back
Lift handle 3 to release. Release the
handle at the desired position and
make sure that it is locked.For safety reasons, make
these adjustments only
when the vehicle is station-
ary.
We would advise you not to recline
the seatbacks too far to ensure that
the effectiveness of the seat belts is
not reduced.
Nothing should be placed on the
floor (area in front of driver) as such
objects may slide under the pedal
during braking manoeuvres, thus
obstructing its use.
2
13
45

1.16
ENG_UD27217_3
Si ges avant (X45 - H45 - Renault)
ENG_NU_977-2_H45_Ph2_Renault_1
fRONT sEATs (2/2)
To fold down the passenger seat
Depending on the vehicle, the passen-
ger seatback may be folded down onto
the seat base to create a table.
Lift handle 6 and lower the seatback.
6
heated seats(depending on vehicle)
W i t h t h e e n g i n e r u n n i n g , p r e s s
switch 8 , pressing on the top of the
switch (to select the warmest setting) or
the bottom of the switch (to select the
average setting).
The indicator light on the button lights
up.
The system, which has a thermostat,
decides whether or not the heating is
needed, according to the position se -
lected.
If the heated front passenger seat is ac-
tivated, the indicator light
ð lights
up on the instrument panel.
78
Since front passenger airbag operation and the position of a front pas-
senger seatback table are incompatible, ensure that the airbag is deac-
tivated. (Refer to the information on “Front passenger air bag activation/
deactivation” in Section 1).
There is a risk of very serious injury if the air bags deploy.
When driving, rear passengers must not place their feet on the seatback of the
front seats under any circumstances. Risk of injury.
To adjust the lumbar support on the
driver’s seat:
Move lever 7.

seat belts .............................................. (up to the end of the DU)
adjusting your driving position .............. (up to the end of the DU)
driving position settings ........................................... (up to the end of the DU)
1.17
ENG_UD27269_7
Ceintures de s curit (X45 - H45 - Renault)
ENG_NU_977-2_H45_Ph2_Renault_1
Seat belts
sEAT BELTs (1/2)
1
2
Always wear your seat belt when trav-
elling in your vehicle. You must also
comply with the legislation of the par -
ticular country you are in.
Adjusting the seat belts
Sit with your back firmly against the
seatback.
The shoulder strap 1 should be as close
as possible to the base of the neck but
not on it.
The lap strap 2 should be worn flat over
the thighs and against the pelvis.
The belt should be worn so that it is
as close as possible to your body, i.e.:
avoid wearing heavy clothing or keep -
ing bulky objects under the belts, etc.Seat belts which are incor -
rectly adjusted or twisted
may cause injuries in the
event of an accident.
Use one seat belt per person,
whether child or adult.
Even pregnant women should wear
a seat belt. In this case, ensure that
the lap belt is not exerting too much
pressure on the abdomen, but do
not allow any slack.
Make sure that the rear bench seat
is securely locked in position so that
the rear seat belts will operate effi -
ciently. Refer to “Rear bench seat”
in Section 3.
Before starting, first adjust your driv-
ing position, then ask all occupants
to adjust their seat belts to ensure
optimum protection.
Adjusting your driving
position
– s it well back in your seat (having
first removed your coat or jacket).
This is essential to ensure your back
is positioned correctly;
– adjust the distance between the
seat and the pedals. Your seat
should be as far back as possible
while still allowing you to depress
the clutch pedal fully. The seatback
should be adjusted so that your arms
are slightly bent when you hold the
steering wheel;
– adjust the position of your head -
rest. For maximum safety, your head
must be as close as possible to the
headrest;
– adjust the height of the seat. This
adjustment allows you to select the
seat position which offers you the
best possible view;
– adjust the position of the steering
wheel.

1.18
ENG_UD27269_7
Ceintures de s curit (X45 - H45 - Renault)
ENG_NU_977-2_H45_Ph2_Renault_1
sEAT BELTs (2/2)
Adjusting the height of the
front seat belts
Press button 8 to adjust the seat belt
height so that the shoulder strap 1 is
worn as shown previously:
– to lower the seat belt, press button 8
and lower the seat belt at the same
time;
– to raise the seat belt, press button 8
and raise the seat belt at the same
time.
Make sure that the seat belt is locked
in position correctly after you have ad-
justed it.
fastening
Unwind the belt slowly and smoothly
and ensure that buckle 3 locks into
catch 5 (check that it is locked by pull -
ing on buckle 3). If the belt jams, allow
it to return slightly before attempting to
unwind it again. If your seat belt is com-
pletely jammed, pull slowly, but firmly
so that just over 3 cm unwinds. Allow
it to return slightly before attempting to
unwind it again. If there is still a prob -
lem, contact an approved dealer.
UnfasteningPress button 4 and the seat belt will be
rewound by the inertia reel. Guide the
belt.
8
61
534
5
™front passenger seat belt re-
minder warning light
(depending on the vehicle)
This comes on the central display 6
or on the instrument panel 7 when the
engine is started then, if the driver ’s
or front passenger ’s seat belt (if this
seat is occupied) is not fastened and
the vehicle has reached approximately
12 mph (20 km/ h), it flashes and a
bleep sounds for around 120 seconds.
Note: an object placed on the passen-
ger seat base may activate the warning
light in some cases.
7