2011 Peugeot RCZ Owner's Manual

2/
ACCESS

LOCKING THE VEHICLE WITH EXTERIOR
PERIMETER MONITORING ONLY
Deactivation of the interior volumetric and anti-tilt monitoring



)
Switch off the ignition.

)
Within ten seconds, press the button until the indicator lamp is on
continuously.

)
Get out of the vehicle.

)
Press the locking button on the remote control immediately.
The exterior perimeter monitoring alone is activated: the indicator lamp
in the button fl ashes once per second.


Reactivation of the interior volumetric and anti-tilt monitoring



)
Press the unlocking button on the remote control to deactivate the
exterior perimeter monitoring.

)
Press the locking button on the remote control to activate all the
monitoring functions.
The indicator lamp in the button again fl ashes once per second.
Deactivate the interior volumetric and anti-tilt monitoring to avoid
unwanted triggering of the alarm in certain cases such as:


- leaving a pet in the vehicle,

- leaving a window partially open,

- washing your vehicle,

- changing a wheel,

- having your vehicle towed,

- transport by sea. To be effective, this deactivation must be carried out each time the
ignition is switched off.

56

OPERATING FAULT

AUTOMATIC ACTIVATION *
LOCKING THE VEHICLE WITHOUT ACTIVATING
THE ALARM



)
Lock or deadlock the vehicle using the key in the driver's door lock.



When the ignition is switched on, fi xed illumination of the indicator lamp
in the button indicates a fault with the system.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.


2 minutes after the last door or the boot is closed, the system is
activated automatically.


)
To avoid triggering the alarm on entering the vehicle, fi rst press the
unlocking button on the remote control.



* According to country.


FAILURE OF THE REMOTE CONTROL

To deactivate the monitoring functions:



)
Unlock the vehicle using the key in the driver's door lock.

)
Open the door; the alarm is triggered.

)
Switch on the ignition; the alarm stops. The indicator lamp in the
button goes off.




TRIGGERING OF THE ALARM

The monitoring functions remain active until the alarm has been
triggered eleven times in succession.
When the vehicle is unlocked using the remote control, rapid
fl ashing of the indicator lamp in the button informs you that the
alarm was triggered during your absence. When the ignition is
switched on, this fl ashing stops immediately.

This is indicated by sounding of the siren and fl ashing of the direction
indicators for thirty seconds.

2/
ACCESS














ELECTRIC WINDOWS

Fitted with a safety anti-pinch system.


A.
Left-hand electric window control switch.


B.
Right-hand electric window control switch.




ONE-TOUCH ELECTRIC WINDOWS

There are two options:


- manual mode



)
Press or pull the switch gently. The window stops when the
switch is released.

- automatic mode



)
Press or pull the switch fi rmly. The window opens or closes fully
when the switch is released.

)
Pressing the switch again stops the movement of the window.
The electric window switches remain operational for approximately
45 seconds after the ignition is switched off or until the vehicle is
locked after a door is opened.
If the passenger's window cannot be operated from the driver's
door control panel, carry out the operation from the control panel
of the passenger door.
After approximately ten consecutive complete opening/closing
movements of the window, a protection function is activated which
only authorises closing of the windows, so as to prevent damage
to the electric window motor.
Once the window is closed, the switches will become operational
again after approximately 40 minutes.

Safety anti-pinch

When the window rises and meets an obstacle, it stops and partially
lowers again.
If the window cannot be closed (for example, in the presence of ice),
immediately after the movement is reversed:


)
press and hold the switch until the window opens fully,

)
then pull the switch immediately and hold it until the window
closes,

)
continue to hold the switch for approximately one second after
the window has closed.

The safety anti-pinch function is not operational during these
operations.

58

Reinitialisation

If a window does not rise automatically, its operation must be
reinitialised:


)
pull the switch until the window stops,

)
release the switch and pull it again until the window closes fully,

)
continue to hold the switch for approximately one second after the
window has closed,

)
press the switch to lower the window automatically to the low
position,

)
when the window has reached the low position, press the switch
again for approximately one second.

The safety anti-pinch function is not operational during these
operations.



Always remove the key from the ignition when leaving the vehicle,
even for a short time.
If an obstacle is encountered during operation of the electric
windows, you must reverse the movement of the window. To do
this, press the switch concerned.
When the driver operates the switch for the passenger's electric
window, they must ensure that no one is preventing correct
closing of the windows.
The driver must ensure that the passengers use the electric
windows correctly.
Be aware of children when operating the windows.

2/
ACCESS











DOORS


OPENING


From outside



)
After unlocking the vehicle completely using the remote control or
the key, take hold of the door handle then pull it.
The window lowers automatically by a few millimetres to permit
opening of the door.

In freezing conditions, the presence of ice may hinder the automatic
partial opening of the window; remove the ice which may have
formed along the lower seal, located at the base of the window.

When the selective unlocking is activated, the fi rst press of the
remote control unlocking button permits unlocking of the driver's
door only.


From inside



)
Pull the door control to open the door; this unlocks this vehicle
completely.
The window lowers automatically by a few millimetres to permit
opening of the door.


With the selective unlocking activated:


- the driver's door control unlocks the driver's door and the fuel
fi ller fl ap only.

- the passenger's door control unlocks the passenger's door
and the boot.
The interior door controls do not operate when the vehicle is
deadlocked. If you leave the door open for more than one minute, the window
rises again.
Pull the handle again to reactivate the system.

60

CLOSING

The window rises automatically after a few seconds and adjusts to
provide perfect sealing when closed.


- when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,












CENTRAL LOCKING CONTROL

This control permits simultaneous locking or unlocking of the doors,
boot lid and fuel fi ller fl ap from inside the vehicle.


Locking



)
Press this button to lock the vehicle.
The red indicator lamp on the button comes on.
If one of the doors or the boot lid is open, the central locking from
the inside does not take place.


Unlocking



)
Press this button again to unlock the vehicle.
The red indicator lamp on the button goes off.


Locking/deadlocking from the outside

When the vehicle is locked or deadlocked from the outside, the
red indicator lamp fl ashes and the button is inactive.


)
With normal locking, pull on the interior door control lever to
unlock the vehicle.

)
With deadlocking, you have to use the remote control or the
key to unlock the vehicle.

When washing your vehicle:


- fi rst lock the vehicle using the remote control or the key,

- avoid spraying the upper part of the windows,

- keep the end of the high pressure nozzle at least 1 metre from
the windows and door seals.
When a door is not closed correctly: Be aware of the risk of pinching when the window rises
automatically on closing the door.

- when the vehicle is moving
(speed higher than 6 mph (10 km/h)),
this warning lamp comes on, accompanied by an audible signal and
a message in the screen for a few seconds.

2/
ACCESS

Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks the
vehicle, but the vehicle will be locked again when the speed exceeds
6 mph (10 km/h).


Activation/Deactivation

You can activate or deactivate this function.


)
With the ignition on, press the button for more than two seconds.
A confi rmation message appears in the screen.

In the event of a serious impact with triggering of an airbag, the
vehicle's doors unlock automatically to allow the occupants to exit.











EMERGENCY LOCKING

To lock or unlock the doors mechanically in the event of a central
locking system failure or fl at battery.


Locking the driver's door



)
Insert the key in the lock, then turn it to the right.



Unlocking the driver's door



)
Insert the key in the lock, then turn it to the left.



Locking the passenger door



)
Using the key, remove the black cap on the edge of the door.

)
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door.

)
Remove the key and refi t the cap.



Unlocking the passenger door



)
Pull the interior door opening control.




ANTI-ATTACK SECURITY

This function permits automatic and simultaneous locking of the doors,
boot lid and fuel fi ller fl ap as soon as the vehicle speed exceeds 6 mph
(10 km/h).

Operation

If one of the doors is open, the automatic central locking does not take
place.
If the boot lid is open, the automatic central locking of the doors is
active.

62

















BOOT


OPENING



)
Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.

)
Lift the boot lid.
This action also unlocks the doors and the fuel fi ller fl ap.




Using the manual control; vehicle unlocked



)
Press the opening control above the number plate.

)
Lift the boot lid.




CLOSING



)
Lower the boot lid using one of the interior grab handles.

)
If necessary, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly:


- when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When the selective unlocking is activated, the boot can be opened
at the second press of the unlocking button on the remote control.

Using the remote control


Emergency locking

If the central locking system fails (fl at battery), you are advised to
disconnect the battery.

- when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.