SE-116
< REMOVAL AND INSTALLATION >
FRONT SEAT
SEAT CUSHION : Disa ssembly and Assembly
INFOID:0000000006217426
DISASSEMBLY
1. Remove the seat cushion outer finisher.
1. Remove the metal clips and pawls, and then pull out seat
cushion outer finisher.
2. Disconnect the seat control switch, lumbar support switch harness connector.
2. Remove the seat cushion front finisher.
3. Remove the lap pre-tensioner. Refer to SB-8, "
SEAT BELT BUCKLE : Removal and Installation".
4. Remove the seat cushion inner finisher. 1. Remove the seat cushion inner finisher fixing screw (A).
2. Remove the metal clip and pawls then pull out seat cushioninner finisher.
5. Disconnect the seat cushion heater unit harness connector (A). (with heater seat model only)
6. Remove the seat cushion trim and seat cushion pad. 1. Remove the seat cushion retainer.
2. Remove the seat cushion trim and seat cu shion pad from the seat frame assembly.
3. Remove the hog rings, and separate the seat cushion trim and seat cushion pad.
7. Remove the seat cushion finisher inside. Remove the seat cushion inner finisher inside (front, rear).
Remove the seat cushion outer finisher inside (front, rear).
8. Remove the following parts after removing seat cushion finisher inside. Seat cushion climate controlled seat unit (with climate controlled seat model only).
Refer to SE-117, "
CLIMATE CONTROLLED SEAT UNIT : Disassembly and Assembly".
Seat control unit (driver seat only).
Refer to ADP-135, "
Removal and Installation".
Remove occupant detection system control unit. Refer to SR-30, "
Removal and Installation".
: Pawl
: Metal clip
JMJIA3966ZZ
: Pawl
: Metal clip
JMJIA3977ZZ
: Vehicle front
JMJIA4327ZZ
Revision: 2010 May2011 QX56
