2011 HONDA CR-Z check engine

74
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
Low Temperature Indicator Comes on when the engine

•
coolant temperature is low. If the indicator stays on after the

•
engine has reached normal operating temperature, there may be a problem with the temperature sensors. Have the vehicle inspected by a dealer.
—
U.S.
Canada Side Airbag Off Indicator Comes on for a few seconds when

•
you turn the ignition switch to ON
II, then goes off.
Comes on when the passenger side

•
airbag system is automatically shut off. It does not mean there is a problem

•
with your side airbags. Comes on when nobody is sitting

•
in the passenger seat - Have the
vehicle checked by a dealer.Comes on when someone is sitting

•
in the seat - Have the person sit
properly. U.S.
Canada
High Beam Indicator Comes on when the high beam

•
headlights are on.Comes on with reduced brightness

•
when DRL (daytime running lights) are on. —
—
Main MenuTable of Contents

75
Instrument Panel
Indicators
IndicatorName On/Blinking Explanation Message
Lights On Indicator Comes on whenever the light

•
switch is on, or in AUTO when the exterior lights are on. If you remove the key from the

•
ignition switch while the light is on, a chime sounds when the driver’s door is opened.
—
Fog Light Indicator * Comes on when the fog lights are

•
on. ——
Turn Signal IndicatorsThe turn signal indicators blink

•
when you operate the turn signal lever.If you press the hazard warning

•
button, both indicators and all turn signals blink at the same time. Does not blink or blinks rapidly

• -
A turn signal light bulb has blown. Change the bulb immediately. Replacing Light Bulbs P.262, 263—
Immobilizer System IndicatorComes on briefly when you turn

•
the ignition switch to ON
II, then
goes off. Comes on if the immobilizer

•
system cannot recognize the key information. Blinks

• - You cannot start the engine.
Turn the ignition switch to LOCK
0, pull the key out, and then insert
the key and turn it to ON
II again.
Repeatedly blinks

• - The system may
be malfunctioning. Have the vehicle checked by a dealer.Do not attempt to alter this system

•
or add other devices to it. Electrical problems can occur.
—
*Not available on all models
Main MenuTable of Contents

197
Driving
When Driving
Starting the Engine
1. Make sure the parking brake is applied.
Automatic transmission (CVT) model
Check that the shift lever is in
2. P, then
depress the brake pedal.
Although it is possible to start the vehicle in
N, it is safer to start it in P.
Manual transmission model
Check that the shift lever is in
2. N. Then
depress the brake pedal with your right foot, and the clutch pedal with your left foot.
The clutch pedal must be fully depressed to start the engine.
Starting the Engine
Keep your foot irmly on the brake pedal when starting the engine. The engine is harder to start in cold weather and in thinner air found at altitudes above 8,000 feet (2,400 meters). When starting the engine in cold weather, turn off all electrical accessories such as the lights, climate control system, and rear defogger in order to reduce battery drain. If the exhaust sounds abnormal or if you can smell exhaust gas inside the vehicle, have your vehicle checked by a dealer. There may be a problem with the engine or exhaust system.
Brake Pedal
Brake Pedal
Clutch Pedal
continued
Main MenuTable of Contents

198
Driving
When Driving Starting the Engine
3. Turn the ignition switch to START
without depressing the accelerator pedal.
Starting to Drive

■
Automatic transmission (CVT) model
Keeping your right foot on the brake pedal, release the parking brake. Check
1.
that the brake system indicator has gone off.
Parking Brake P.219
Put the shift lever in
2.
D. Select R when reversing.
Gradually release the brake pedal and gently depress the accelerator pedal to
3.
pull away.
Starting the Engine
Do not hold the key in START
for more than 15
seconds.
If the engine does not start right away, wait for

•
at least 10 seconds before trying again. If the engine starts, but then immediately stops,

•
wait at least 10 seconds before repeating step 3 while gently depressing the accelerator pedal. Release the accelerator pedal once the engine starts.
The immobilizer system protects your vehicle from theft. If an improperly coded key (or other device) is used, the engine's fuel system is disabled.
Immobilizer System P.1 0 5
Main MenuTable of Contents

200
Driving
When Driving Precautions While Driving
Precautions While Driving
In Rain
■
Avoid driving in deep water and on flooded roads. This can damage the engine or cause electrical component failure.
Other Precautions

■
If there is a strong impact with something under the vehicle, stop in a safe location. Check the underside of the vehicle for damage and fuel or brake fluid leaks.
Precautions While Driving
NOTICE Do not operate the shift lever while pressing the accelerator pedal. You could damage the transmission. If the ignition switch is turned to ACCESSORY

or LOCK while driving, the engine will shut
down and all steering and brake power assist functions will stop, making it dificult to control the vehicle. Do not drive with the shift lever in
, as you will
lose engine braking (and acceleration) performance. During the irst 600 miles (1,000 km) of operation, avoid sudden acceleration or full throttle operation so as to not damage the engine or powertrain. Avoid hard braking for the irst 200 miles (300 km). You should also follow this when the brakes are replaced.
Main MenuTable of Contents

203
Driving
When Driving Shifting
Shift Lever Operation
■ Shift Lever Operation
NOTICE
Before you move the shift lever from to and
vice versa, come to a complete stop and keep the brake pedal depressed.Operating the shift lever before the vehicle has come to a complete standstill can damage the transmission. Use the shift lever position indicator to check the lever position before pulling away. Whichever position the shift lever is in when driving, a blinking
indicator indicates a
transmission problem. Avoid sudden acceleration and have the transmission checked by a dealer as soon as possible. The fuel supply may be cut off if you drive at engine speeds in or over the tachometer red zone (engine speed limit). If this happens, you may experience a slight jolt. It may not be possible to operate the shift lever if the brake pedal is applied while the shift lever release button is held down.Depress the brake pedal irst.
Shift Lever Position Indicator
Tachometer's Red Zone
M (7-Speed Manual Shift Mode) Indicator/Shift Indicator
Depress the brake pedal and press the shift lever release button to shift.
Shift without pressing the shift lever release button.
Press the shift lever release button and shift. P
R
N D
Main MenuTable of Contents

209
Driving
When Driving Shifting
Reverse Lockout
■
The manual transmission has a lockout mechanism that stops you from accidentally shifting into
R from a forward gear while the vehicle is moving at a certain speed.
If you cannot shift to
R when the vehicle is stopped, do the following: 1. Depress the clutch pedal, move the shift lever all the way to the left, and shift to
R.
If you still cannot shift into
2.
R, apply the
parking brake, and turn the ignition switch to ACCESSORY
I or LOCK 0.
Depress the clutch pedal and shift into
3.
R.
Keep depressing the clutch pedal and start
4.
the engine.
Have the vehicle checked by a dealer if you have to go through this procedure repeatedly.
Main MenuTable of Contents

214
Driving
When Driving VSA®
(Vehicle Stability Assist), aka ESC (Electronic Stability Control), System
VSA ®
(Vehicle Stability Assist), aka ESC (Electronic
Stability Control), System VSA ®
helps to stabilize the vehicle during cornering if the vehicle turns more or less
than what was intended. It also assists in maintaining traction on slippery surfaces. It does so by regulating engine output and selectively applying the brakes.
VSA

■®
Operation
When VSA®
activates, you may notice that the
engine does not respond to the accelerator. You may also notice some noise from the hydraulic system. You will also see the indicator blink.
VSA ®
(Vehicle Stability Assist), aka ESC (Electronic
Stability Control), System
The VSA ®
may not function properly if tire type and
size are mixed. Make sure to use the same size and type of tire, and the air pressures as speciied. When the VSA ®
indicator comes on and stays on
while driving, there may be a problem with the system. While this may not interfere with normal driving, have your vehicle checked by a dealer immediately. VSA ®
cannot enhance stability in all driving
situations and does not control the entire braking system. You still need to drive and corner at speeds appropriate for the conditions and always leave a suficient margin of safety. The main function of the VSA ®
system is generally
known as Electronic Stability Control (ESC). The system also includes a traction control function.
VSA ®
System
Indicator
Main MenuTable of Contents