2010 SKODA FABIA headlight bulb

Fuses and light bulbs
196
Fuse assignment in the dash panelFig. 162 Schematic representation of the fuse
box for vehicles with left-hand steering / right-
hand steeringCertain electrical components are only standard on certain vehicle model versions or only suppliable as optional
equipment for certain models.
No.
Power consumer
Amperes
1
Not assigned
2
START - STOP
5
3
Instrument cluster, headlamp beam adjustment
7,5
4
ABS control unit
5
5
Petrol engine: Cruise control system
5
6
Reversing light (manual gearbox)
10
7
Ignition
15
Engine control unit, automatic gearbox
7,5
8
Brake pedal switch, coolant fan
5
9
Operating controls for the heating, control unit for air condi- tioning system, parking aid, control unit for cornering lights, coolant fan
5
10
Air conditioning
a)
7,5
11
Mirror adjustment
5
12
Control unit for trailer detection
5
13
Control unit for automatic gearbox
5
14
Motor for halogen projector headlights with cornering light function
10
15
Navigation PDA
5
16
Electrohydraulic power steering
5
17
START - STOP - radio
10
Daylight driving lights
7,5
18
Mirror heater
5
19
S-contact
5
20
Engine control unit
5
Engine control unit
7,5
Fuel pump relay
15
Fuel pump control unit
15
21
Reversing light, fog lights with the function “CORNER”
10
22
Operating controls for the heating, control unit for air condi- tioning system, parking aid, mobi
le phone, instrument cluster,
steering angle sender
, ESP, vehicle voltage control unit, multi-
function stee
ring wheel
7,5
23
Interior lighting, storage compartment and luggage compart- ment, side lights
15
24
Central control unit of the vehicle
5
25
Seat heaters
20
26
Rear window wiper
10
27
Not assigned
28
Petrol engine: AKF valve, petrol engine: Control flap
10
29
Injection, water pump
10
No.
Power consumer
Amperes
s3j8.a.book Page 196 Tuesday, April 20, 2010 1:10 PM

Fuses and light bulbs
197
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Replacing fuses at the battery (manual gearbox, automatic gearbox DSG)Fig. 163 The battery: Fuse cover
30
Fuel pump
15
Ignition
20
Cruise control system, operation of PTC relay
5
31
Lambda probe
10
32
High pressure pump, pressure valve
15
33
Engine control unit
30/15
34
Engine control unit
15
Vacuum pump
20
35
Power supply of ignition lock
5
36
Main beam light
15
37
Rear fog light
7,5
38
Fog lights
10
39
Blower
30
40
Heatable windscreen washing no
zzles, windscreen cleaning
system
15
41
Not assigned
42
Rear window heater
25
43
Horn
20
44
Front window wiper
20
45
Central control unit fo
r convenience system
25/10
46
Anti-theft alarm system
15
47
Cigarette lighter, power socket in the luggage compartment
b)
15
48
ABS, START-STOP - DC/DC converter ESP
15
49
Turn signal lights, brake lights
15
No.
Power consumer
Amperes
50
START-STOP - DC/DC converter infotainment
30
Radio
10
51
Electrical power window (front and rear) - left side
25
52
Electrical power window (front and rear) - right side
25
53
Parking light - left side
5
Electric sliding/tilting roof
25
54
START-STOP - instrument cluster
5
Anti-theft alarm system
15
55
Control unit for automatic gearbox DSG
30
56
Headlight cleaning system
25
Parking light - right side
5
57
Left low beam, headlight range adjustment
15
58
Low beam on the right
15
a)Only valid for some countries.b)If the engine is switched off already one electr
ical component which is
connected can discharge
the battery.No.
Power consumer
Amperes
s3j8.a.book Page 197 Tuesday, April 20, 2010 1:10 PM

Fuses and light bulbs
200
Caution
Observe the following guidelines

in “Replace fuses at the battery (automatic
gearbox)”.BulbsReplacing bulbsThe relevant lamp must always be switch
ed off before a light bulb is replaced.
Do not take hold of the glass bulb with naked fingers (even the smallest amount of dirt reduces the working life of the light bulb).
Use a clean cloth, serviette or something
similar. Defect light bulbs should only be replaced
with light bulbs of the same type. The desig-
nation is located on the ligh
t socket or the glass bulb.
Changing certain bulbs is not something whic
h you can do yourself, but requires to be
done by a specialist. Other parts of the vehicle must be removed in order to change the light bulbs. This applies, in particular, to
bulbs which can only be reached from the
engine compartment. We therefore recommend that you have any
bulbs changed by a specialist garage or,
in exceptional cases, by calling
on other professional assistance.
Please note that the engine compartment is a hazardous area
page 166, “Working
in the engine compartment”. We recommend that you always have a small box of replacement bulbs in your vehicle. You can obtain replacement bulbs from Škoda
original accessories or from a specialist
garage
15).
A stowage place for the bulbs is located in the box in the spare wheel.Bulb - Overview15)The small box with replacement bulbs is part of
the basic equipping of th
e vehicle in some coun-
tries.
Front headlight
Halogen headlight
Halogen projector
headlights
Low beam light
H4
H7
Main beam light
H4
H7
Parking lights
W5W, LED
a)
a)Valid for vehicles Scout.Turn signals
PY21W
Fog lights*
H8/HB4
a)
Daylight driving lights*
P21W, LED
b)
b)Valid for RS vehicles with separate lights* for daylight driving lights.Rear light unit
Bulb
Reversing light
P21W
Turn signals
PY21W
Brake lights
P21W
Rear fog light
P21W
Parking lights
2x W5W
Others
Bulb
Side turn signal lights
WY5W
Licence plate light
C5W / T4W (5W)
3. Brake light
LED
Interior lighting front / rear
C10W
Reading lights
W5W
Luggage compartment light
W5W
Lighting in storage compartment
W5W
s3j8.a.book Page 200 Tuesday, April 20, 2010 1:10 PM

Fuses and light bulbs
201
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
WARNING

Bulbs H7 and H4 are pressurised and
may burst when changing the bulb -
risk of injury!
It is recommended to wear gloves and
safety glasses when changing a bulb.
Note
This Owner's Manual only describes the replacement of bulbs where it is assumed that no major complications will
arise. Other light bulbs should be replaced by your
specialist garage.Front headlightFig. 167 Fitting position of the bulbs: Halo
gen headlights / halogen projector headlights
Positions of the light bulbs in the halogen headlights
fig. 167
on the left and in the
halogen projector headlights
fig. 167
on the right.
- low beam, main beam and side lights - front turn signal light - low beam light - main beam and side lights - front turn signal light
Low beam and main beam (halogen headlights)– Open the bonnet.– Remove the protective cap
fig. 167
.
– Pull off the connector from the lamp, rele
ase the sprung wire clamp and pull out
the lamp towards the rear
fig. 168
.
– Replace the lamp H4, insert into the opening in the reflector (with the fixing lugs in
the recesses), secure with the sprung wi
re clamp, mount the connector and posi-
tion the protective cap.
– We recommend that you have the headli
ght setting checked by a Skoda Service
Partner after replacing the light bulb.
Low beam (halogen projector headlights)– Open the bonnet.
AAABA1A2A3
Fig. 168 Removing the light bulb for the low beam and main beam light
AA
Fig. 169 Removing the light bulb for the low beam light
s3j8.a.book Page 201 Tuesday, April 20, 2010 1:10 PM

Fuses and light bulbs
202
– Remove the protective cap
page 201, fig. 167
on the right.
– Turn the connector with the light bulb up to the stop towards the left
page 201,
fig. 169
and remove.
– Replace the halogen lamp H7, insert the connector with the new halogen lamp and
turn to the right up to the stop.
– Insert the protective cap.– We recommend that you have the headlight setting checked by a Skoda Service
Partner after replacing the light bulb.
Main beam (halogen projector headlights)– Open the bonnet. – Remove the protective cap
page 201, fig. 167
on the right.
– Turn the connector with the light bulb
up to the stop towards the left
fig. 170
and
remove.
– Replace the halogen lamp H7, insert the connector with the new halogen lamp and
turn to the right up to the stop.
– Insert the protective cap.– We recommend that you have the headlight setting checked by a Skoda Service
Partner after replacing the light bulb.
Turn signal light (at the front)– Open the bonnet. – Turn the socket (halogen headlight)
page 201, fig. 167
or the socket
(halogen projector headlight) to the left an
d take it out together with the light bulb
for the turn signal light.
– Replace the defective light bulb.– Insert the lamp holder with light bulb into
the headlight. Secure the lamp holder by
turning it to the right until it locks in place.
Parking light at the front– Open the bonnet. – Remove the protective cap (halogen headlight) or (halogen projector head-
light)
page 201, fig. 167
.
– Grasp the light bulb holder and pull it out of the headlight.– Replace the light bulb in the light bulb
holder and re-insert into the headlight.
Daylight driving lights and fog lightsFig. 171 Front bumper: Protective
grille / removing the fog light
– Switch the ignition and all lights off. – Grasp the grille at the points marked with the arrows
fig. 171
- left and take it out.
A1
Fig. 170 Removing the light bulb for the main beam light
A2
AB
A3
AA
A2
s3j8.a.book Page 202 Tuesday, April 20, 2010 1:10 PM

Fuses and light bulbs
203
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
– Guide your hand into the opening in wh
ich the grille was located and press the
spring bolt
page 202, fig. 171
- right.
– Take out the fog light.– Turn the socket with the bulb for daylight driving light or the socket with the
bulb of the fog light to the left up to stop and take it out.
– Replace the lamp, insert the connector with
the new lamp and turn to the right up
to the stop.
– For the installation, first of all insert the
fog light with the interlock to the side far
away from the marking of the vehicle.
– Press into place the headlight onto the side facing the marking.– First of all put the grille with the latch
in place on the side opposite the marking.
– Press into place the protective grille onto the side facing the marking.Cover of fog lights - Fabia Scout, Fabia RSFig. 172 Front bumper: Fabia Scout / Fabia RSRemoving the cover - Fabia Scout– Switch the ignition and all lights off.– Guide the wire clamp from the vehicle tool
kit into the opening above the fog light
 fig. 172
- left and remove the cover.
Removing the cover - Fabia RS– Switch the ignition and all lights off. – Guide one finger into the opening next to the fog light
fig. 172
- right and
remove the cover.
– In order to reinstall the cover, first of all insert one part of the cover starting on the
side opposite the marking. Then press th
e cover closed on the side facing the
marking.
Fog lights Fabia Scout, Fabia RSFig. 173 Front bumper: Fog
lights / changing the bulb
Removing the fog light–Screw out the screws
fig. 173
- left with the aid of the screwdriver*, which is part
of the vehicle tool kit
16).
– Take out the fog light.Changing the bulb and installing the fog light– Press the locking button
fig. 173
of the plug and remove the plug from
the socket .
– Turn the socket with the bulb to the left up to the stop and take it out.– Change the bulb, insert again the socket wi
th the new bulb and turn it to the right
up to the stop.
AA
AB
16)Valid for Fabia Scout and Fabia RS.
A1
AA
AB
AB
s3j8.a.book Page 203 Tuesday, April 20, 2010 1:10 PM