2010 Seat Alhambra inflation pressure

Safe driving 14
xBrake early.
Transporting a load
Secure all objects in the vehicle
xDistribute the load throughout the vehicle, on the roof and in a trailer as
uniformly as possible.
xTransport heavy objects as far forward as possible in the luggage
compartment and lock the seat backs in the vertical position.
xSecure luggage in the luggage compartment with suitable straps on the
fastening rings Ÿpage 146.
xCheck the headlight adjustment Ÿpage 113.
xUse the suitable tyre pressure according to the load being transported.
Read the tire inflation information label Ÿpage 323.
xFor vehicles with a tire pressure indicator, change the vehicle load status
Ÿpage 245.
Caution
Objects on the shelf could chafe against the wires of the heating element in
the rear window and cause damage.
Note
Please note the information about loading a trailer Ÿpage 260 and the roof
carrier system Ÿpage 159.
Driving with the tailgate open
Driving with the tailgate open creates an additional risk. Secure all objects
and secure the tailgate correctly and take all measures possible to reduce
toxic gases from entering the vehicle.
WARNING
Driving with the tailgate unlocked or open could cause serious injuries.
xAlways drive with the tailgate closed.
xSecure all objects in the vehicle. Loose items could fall out of the
vehicle and injure other road users or damage other vehicles.
xDrive particularly carefully and think ahead.
xAvoid sudden manoeuvres and braking given that this could cause an
uncontrolled movement of the open tailgate.
xWhen transporting objects that protrude out of the luggage compart-
ment, indicate them suitably. Observe legal requirements.
xIf objects must project out of the luggage compartment, the tailgate
must never be used to “secure” or “attach” objects.
xIf a baggage rack is fitted on the tailgate, it should be removed before
travelling with the tailgate open.
WARNING
Toxic gases may enter the vehicle interior when the tailgate is open. This
could cause loss of consciousness, carbon monoxide poisoning, serious
injury and accidents.
xTo avoid toxic gases entering the vehicle always drive with the tailgate
closed.
xIn exceptional circumstances, if you must drive with the tailgate open,
observe the following to reduce the entry of toxic gases inside the vehicle:
Close all windows and the sliding roof.
WARNING (continued)

Driving245
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
Tyre monitoring systems
Introduction
The tyre monitor indicator monitors the tyre pressure of each wheel using the
ABS sensors. The ABS sensors monitor the tyre tread perimeter and vibra-
tions of each tire. The tyre monitor indicator warns the driver if it detects a
considerable drop in tyre pressure of one or several tyres while driving. Loss
of tyre pressure will be indicated by the indicator
~ as well as a sound and
sometimes a text message on the screen of the instrument panel. When you
open the driver's door, you will find a label indicating the tyre pressure recom-
mended by the manufacturer for the maximum vehicle load for each tyre
approved for the vehicle in question. By pressing the adjustment button on
the tyre monitoring indicator, you may change the reference pressure for the
tyres so that the tyre pressure to be monitored coincides with actual tyre pres-
sure Ÿpage 248.
Suitable use of the adjustment button Ÿpage 248.
Additional information and warnings:
xTransporting Ÿpage 13
xBraking, stopping and parking Ÿpage 210
xCaring for and cleaning the vehicle exterior Ÿpage 269
xWheels and tyres Ÿpage 323
xAccessories, parts replacement, repairs and modifications Ÿpage 285
WARNING
Unsuitable handling of the wheels and tyres may lead to sudden tyre pres-
sure losses, to tread separation or even to a blow-out.
xCheck tyre pressures regularly and ensure they are maintained at the
pressures indicated. If the tyre pressure is too low, the tyres could over-
heat, resulting in tread detachment or even burst tyres.
xTyre pressure should be that indicated on the label when the tyres are
cold at all times Ÿpage 328.
xRegularly check the cold inflation pressure of the tyres. If necessary,
change the tyre pressure of the vehicle tyres while they are cold.
xRegularly check your tyres for damage and wear.
xNever exceed the maximum permitted speed or loads specified for the
type of tyre fitted on your vehicle.
WARNING
Incorrect use of the tyre monitoring indicator button could result in the
indicator giving erroneous messages or prevented from indicating the
danger caused by a defective tyre Ÿpage 248.
Caution
xThe tyre valves may be damaged if the cap is not in place. Check that the
caps are identical to the standard caps and have been correctly tightened. Do
not use metal caps Ÿpage 248.
xDo not damage the valves when changing the tyres Ÿpage 248.
For the sake of the environment
Under-inflated tyres lead to increased fuel consumption and tyre wear.
Note
Do not only rely on the tyre monitoring system. Regularly check your tyres to
ensure that the tyre pressure is correct and that the tyres are not damaged
due to puncture, cuts, tears and impacts/dents. Remove objects from the
tyres only when the tyres have not been pierced by these.
WARNING (continued)

Wheels and tyres 328
vendor should provide the manufacturer's certificate with the tyre, indicating
that this type of tyre is suitable for your vehicle. This certificate should always
be carried with the vehicle.
Tyre pressures
Fig. 183 Position of tyre pressure specification plate.
The correct tyre pressures for tyres fitted at the factory is shown on a label and
is valid for summer and winter tyres. This label Ÿfig. 183 is either in the
driver's door strut or inside the fuel cap.
Under-inflation or over-inflation will reduce the life of the tyres considerably
and also impair the car's handling Ÿ. It is essential to maintain the
correct tyre pressures, especially if driving at high speeds. Incorrect tyre pres-
sure causes premature wear and could cause tyre blow-out.The pressure should therefore be checked at least once a month and before
starting a journey.
As a general rule, the pressures given are for cold tyres. When the tyres are
hot, the pressures are greater.
Never deflate a hot tyre in order to obtain the required pressure. This could
result in very low tyre pressures which may lead to sudden blow-outs.
Checking tyre pressures
Tyre pressures should only be checked when the vehicle has not been driven
for more than a few kilometres (miles) at low speeds in the past three hours.
xThe tyre pressures should be checked regularly, and only when the tyres
are cold. Always check all the tyres. Tyre pressures should be checked more
often in colder regions, and only when the vehicle has not been driven
recently. Always use a correctly-operating tyre gauge.
xAdjust tyre pressures to the loads carried in the vehicle.
xAfter checking the pressure, always replace the valve caps, and where
applicable, observe the instructions given for adjusting the tyre control
system Ÿpage 245.
WARNING
If tyre pressures are too high or too low, the tyre may deflate or burst
suddenly while driving. This could result in serious accident.
xIf the tyre pressure is too low, the tyres could overheat, resulting in
tread detachment or even burst tyres.
xWhen driving at high speeds and/or fully loaded, the tyre could
suddenly overheat, burst or be subject to tread detachment, with the
resultant loss of control of the vehicle.
xTyre pressures which are too high or too low reduce the service life of
the tyre, affecting the vehicle's performance.
xTyre pressures should be checked regularly, at least once a month and
before long journeys.

Wheels and tyres333
Safety FirstOperating instructionsPractical tipsTe c h n i c a l D a t a
Tyre code
Fig. 185 Universal code on tyres.
Radial
Rim diameter code
Load index & speed rating
DOT tyre identification number
Severe snow conditions
Tyre ply composition and materials used
Max. load rating
Treadwear, traction and temperature grades
Max. permissible inflation pressure
Passenger car tyre
Nominal width of tyre in millimetres
Ratio of height to width (aspect ratio)A1
A2
A3
A4
A5
A6
A7
A8
A9
A10
A11
A12
Tyre code (example)Meaning
Make, logotypeManufacturer
Product nameName of tyre assigned by manufacturer.
P215 / 55 R 16Size:
PPassenger vehicle code.
215Nominal width between walls, in mm.
55Height/width ratio in %
RTyre type (R indicates "radial").
16Rim diameter in inches
91 VLoad index Ÿpage 334 and speed rating
Ÿpage 334.
XLReinforced tyres.
M+S or M/SWinter tyres (mud and snow tyres) Ÿpage 331.
SSR or DSST, Eufonia,
RFT, ROF, RSC, ZPSpecific manufacturer codes for run-flat tyres.
RADIAL TUBELESSRadial tyre without inner tube.
E4 ...E-mark certifying tyre complies with international
legislation followed by a number denoting the
country granting the authorisation. The authori-
sation number ( several digits) is shown below.

Wheels and tyres 334
Tyres with directional tread pattern
Tyres with directional tread pattern have been designed to operate best when
rotating in only one direction. An arrow on the tyre sidewall indicates the
direction of rotation on tyres with directional tread. Always observe the direc-
tion of rotation indicated when mounting the wheel. This guarantees
optimum grip and helps to avoid aquaplaning, excessive noise and wear.
Tyre load ra tin g
The load rating code indicates the maximum load in kilogrammes each wheel
can carry (load capacity).
91 615 kg (1,356 pounds)
93 650 kg (1,433 pounds)
95 690 kg (1,521 pounds)
97 730 kg (1,609 pounds)
99 775 kg (1,709 pounds)
Speed rating
The speed rating indicates the maximum speed permitted for the tyres.
P max. 150 km/h (93 mph)
Q max. 160 km/h (99 mph)
R max. 170 km/h (106 mph)
S max. 180 km/h (112 mph)
DOT BT RA TY5 1709Tyre identification number (TINa), may be only on
interior wall of wheel) and date of manufacture:
DOTThe tyre complies with the legal require-
ments of the US Department of Transport,
responsible for tyre safety regulations.
BTPlace of manufacture code.
RAInformation about manufacturer and tyre
size.
TY5Manufacturer's tyre specifications.
1709Date of manufacture: Week 17 of 2009.
TWIThis identifies the position of the Tread Wear
Indicator Ÿpage 329.
Made in GermanyCountry of manufacture.
MAX LOAD 615 KG (1356
LBS)US load rating, indicating maximum permitted
load per tyre.
MAX INFLATION 350 KPA
(51 PSI)US limit, indicating maximum permitted tyre
pressure.
SIDEWALL 1 PLY RAYONInformation about tyre wall components:
1 layer of rayon (artificial silk).
TREAD 4 PLIES
1 RAYON + 2 STEEL + 1
NYLONInformation about tread components:
In the example, there are 4 layers below the
tread: 1 layer of rayon (artificial silk), 2 layers of
steel reinforcement and 1 layer of nylon.
Information for the end consumer concerning the comparative values of
the established base tyres (standardised test procedures):
TREADWEAR 280Relative service life of the tyre, with respect to
specific US standard test.
Tyre code (example)Meaning
TRACTION AABraking capacity of tyre on wet surface (AA, A, B
or C).
TEMPERATURE ATyre temperature resistance at higher test speeds
(A, B or C).
If the tyre has other markings, these are specific tyre manufacturer codes
or specific national codes, e.g. for Brazil or China.
a)The letters TIN refer to the tyre serial number.
Tyre code (example)Meaning