2010 MITSUBISHI GRANDIS maintenance

2. Depress the tab (C) on the harness connector
and pull the harness connector (D) to remove
it. 3. Remove
the entire socket and bulb assembly
(E) by turning it anticlockwise. 4. To
install the bulb, perform the removal
steps in reverse. CAUTION
l
Handle
halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the fog lamps
are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly. Rear combination lamps
E01004201063
1. Insert
a straight blade (or minus) screwdriver
with a cloth over its tip into the notch at the bottom of the lid of the lamp whose bulb you
wish to replace. Use it to lever off the lid.
2. Turn
the socket anticlockwise and remove it.
Withdraw the bulb from the socket. A- Rear turn-signal lamp
B-
Rear fog lamp (driver’s side)Reversing lamp (passenger’s side)
3. To install the bulb, perform the removal steps in reverse. Maintenance
8-29 8
Presented by http://mmc-manuals.ru/ \251

NOTE
l When
installing the lid, make sure the 2 tabs
(C) are aligned with the holes on the vehicle
side. Licence plate lamps
E01004600813
1. Insert
a straight blade (or minus) screwdriver
into the lamp assembly and pry gently to re-
move it. NOTE
l Wrap

a piece of cloth around the tip of the
screwdriver in order to avoid scratching the
lens and the body.
2. Remove the socket by turning it anticlock- wise, and then remove the bulb by pulling out. 3. To
install the bulb, perform the removal
steps in reverse.
NOTE l When installing the lamp, insert tab (A) first
then align and insert tab (B). Room lamp & map lamps
E01004700481
1. Insert
a straight blade (or minus) screwdriver
into the lens and pry gently to remove it.
Remove the bulb from the lamp holder. NOTE
l Wrap

a piece of cloth around the tip of the
screwdriver in order to avoid scratching the
lens.
2. To install the bulb, perform the removal steps in reverse. Maintenance
8-30
8
Presented by http://mmc-manuals.ru/ \251

NOTE
l When
installing the lens, align the tab on the
lens with the hole on the vehicle side. Rear personal lamps
E01005200210
1. Insert
a straight blade (or minus) screwdriver
into the notch of the lens and pry gently to re-
move it.
Remove the bulb from the lamp holder. NOTE
l Wrap

a piece of cloth around the tip of the
screwdriver in order to avoid scratching the
lens.
l When replacing a bulb, keep the interior
lamp switch in the “ ” (OFF) position.
2. To

install the bulb, perform the removal
steps in reverse.
NOTE l When installing the lens, align the tab on the
lens with the hole on the vehicle side. Luggage compartment lamp
E01005300383
1. Insert
a straight blade (or minus) screwdriver
into the notch of the lens and pry gently to re-
move it. Remove the bulb from the lamp holder.
NOTE
l Wrap

a piece of cloth around the tip of the
screwdriver in order to avoid scratching the
lens.
2. To install the bulb, perform the removal steps in reverse.
Door lamps E01005400300
1. Insert
a straight blade (or minus) screwdriver
into the lens and pry gently to remove it. Maintenance
8-31 8
Presented by http://mmc-manuals.ru/ \251

Remove the bulb from the lamp holder.
NOTE
l Wrap
a piece of cloth around the tip of the
screwdriver in order to avoid scratching the
lens.
2. To install the bulb, perform the removal steps in reverse.
NOTE l When installing the lens, align the 2 tabs on
the lens with the holes on the vehicle side. Glove box lamp
E01006100388
1.

Pull out the bulb. 2. To
install the bulb, perform the removal
steps in reverse.
Vanity mirror lamps* E01006200190
1. Insert
a straight blade (or minus) screwdriver
into the notch of the lens and pry gently to re-
move it.
Remove the bulb from the lamp holder. NOTE
l Wrap

a piece of cloth around the tip of the
screwdriver in order to avoid scratching the
lens.
2. To install the bulb, perform the removal steps in reverse. Maintenance
8-32
8
Presented by http://mmc-manuals.ru/ \251

Fuel consumption
E01101100355Item Combined Urban conditions Extra-urban conditions
CO
2 (g/km) Fuel consumption
(L/100 km) Fuel consumption
(L/100 km) Fuel consumption
(L/100 km) Standard Petrol-powered vehicles M/T 221.2
9.312.6 7.3 A/T
234.3 9.913.2 8.0 Diesel-powered vehicles
(Except for 1500 models)
175.0
6.68.45.6 Diesel-powered vehicles
(for DPF models)
175.0
6.68.55.6Full option Petrol-powered vehicles M/T 223.3
9.412.8 7.4 A/T
236.6 10.013.3 8.1 Diesel-powered vehicles
(Except for 1500 models)
175.0
6.68.45.6 Diesel-powered vehicles
(for DPF models)
175.0
6.68.55.6NOTE
l The results given do not express or imply any guarantee of the fuel consumption of the particular vehicle.
The
vehicle itself has not been tested and there are inevitably differences between individual vehicles of the same model. In addition, this vehicle may incor-
porate particular modifications. Furthermore, the driver’s style and road and traffic conditions, as well as the extent to which the vehicle has been driven and
the standard of maintenance, will all affect its fuel consumption. Specifications
9-13 9
Presented by http://mmc-manuals.ru/ \251

Coolant 8-06,9-15
Number 9-02
Oil 8-04
Oil and oil filter
9-14
Overheating 6-04
Specifications 9-08
Used engine oils safety instructions and disposal
information 06
Water temperature gauge 3-04
Error codes 5-28
Exterior and interior lamp operation 8-18
FFluid capacities and lubricants 9-14
Fluid
Automatic transmission fluid

8-08,9-15
Brake fluid 8-09,9-14
Clutch fluid 8-09,9-14
Engine coolant 8-06,9-15
Power steering fluid 8-09,9-14
Washer fluid 8-08,9-14
For cold and snowy weather 8-19
Front automatic air conditioning 5-05
Front fog lamps Bulb capacity 8-25
Indication lamp 3-06
Replacement 8-28
Front fog lamp Switch 3-22
Front seat 2-05
Front turn-signal lamps Bulb capacity 8-25
Replacement 8-28
Fuel consumption 9-13
Fuel Filling the fuel tank 03
Fuel gauge 3-03
Fuel selection 02 Low fuel warning lamp 3-04
Modification/alterations to the electrical or fuel
systems 05
Tank capacity

03
Fuse load capacity 8-20
Fuse replacement 8-24
Fuses 8-20
Fusible links 8-19
G Gauges 3-05
General maintenance

8-18
General vehicle data 9-04
Genuine parts 05
Glove box 5-38
Glove box lamp Bulb capacity 8-26
Replacement 8-32
H Handling of compact discs 5-30
Hazard warning indication lamps

3-06
Head restraints 2-11
Headlamp levelling 3-19
Headlamp levelling switch 3-19
Headlamps Bulb capacity 8-25
Headlamp flasher 3-19
Replacement 8-26
Switch 3-18
Heated mirror 4-08
Heated seats 2-06
High-beam indication lamp 3-06
Hinges and latches lubrication 8-19
Horn switch 3-26 I If the vehicle breaks down 6-02
Ignition switch 4-08
Indication and warning lamps

3-05
Indication lamps 3-06
Inside rear-view mirror 4-06
Inside tailgate release 1-10
Installation of accessories 04
Instrument panel upper box 5-39
Instruments 3-02
Interior lamp switch 5-36
Interior lamps 5-35
J Jacking up the vehicle 6-07
Jack 6-06
Storage 6-06
Jump starting (Emergency starting)

6-02
K Keyless entry system 1-04
Keys 1-02
L Labeling 9-02
Lamp monitor buzzer

3-19
Lamps (headlamps, fog lamp, etc.) auto-cutout func-
tion 3-18
Lamps (room lamps, etc.) auto-cutout function (Ve-
hicles with keyless entry system) 5-37
Leakage (Fuel, engine coolant, oil and exhaust
gas) 8-18
Licence plate lamps Bulb capacity 8-26 Alphabetical index
2
Presented by http://mmc-manuals.ru/ \251