2010 CADILLAC DTS Owners Manual

{WARNING:
Do not attach more than one child restraint to a
single anchor. Attaching more than one child
restraint to a single anchor could cause the anchor
or attachment to come loose or even break during
a crash. A child or others could be injured. To
reduce the risk of serious or fatal injuries during a
crash, attach only one child restraint per anchor.
{WARNING:
Children can be seriously injured or strangled if a
shoulder belt is wrapped around their neck and
the safety belt continues to tighten. Buckle any
unused safety belts behind the child restraint so
children cannot reach them. Pull the shoulder belt
all the way out of the retractor to set the lock, if
your vehicle has one, after the child restraint has
been installed.
Notice:Do not let the LATCH attachments rubagainst the vehicle’s safety belts. This may damagethese parts. If necessary, move buckled safetybelts to avoid rubbing the LATCH attachments.
Do not fold the empty rear seat with a safety beltbuckled. This could damage the safety belt orthe seat. Unbuckle and return the safety belt to itsstowed position, before folding the seat.
1. Attach and tighten the lower attachments to thelower anchors. If the child restraint does not havelower attachments or the desired seating positiondoes not have lower anchors, secure the childrestraint with the top tether and the safety belts.Refer to your child restraint manufacturerinstructions and the instructions in this manual.
1.1. Find the lower anchors for the desiredseating position.
1.2. Put the child restraint on the seat.
1.3. Attach and tighten the lower attachments onthe child restraint to the lower anchors.
2-49

2. If the child restraint manufacturer recommends thatthe top tether be attached, attach and tighten thetop tether to the top tether anchor, if equipped.Refer to the child restraint instructions andthe following steps:
2.1. Find the top tether anchor.
2.2. Pull open the top tether anchor cover toexpose the anchor.
2.3. If you have an adjustable headrest or headrestraint, raise the headrest or head restraint.
2.4. Route, attach and tighten the top tetheraccording to your child restraint instructionsand the following instructions:
If the position you areusing has a fixed headrestor head restraint andyou are using a singletether, route the tether overthe headrest or headrestraint.
If the position you areusing has a fixed oradjustable headrest orhead restraint and you areusing a dual tether,route the tether around theheadrest or headrestraint.
If the position you areusing has an adjustableheadrest or head restraintand you are using asingle tether, route thetether under the headrestor head restraint andin between the headrest orhead restraint posts.
3. Push and pull the child restraint in differentdirections to be sure it is secure.
2-50

Securing a Child Restraint in a Rear
Seat Position
When securing a child restraint in a rear seating position,study the instructions that came with the child restraint tomake sure it is compatible with this vehicle.
If the child restraint has the LATCH system, seeLower Anchors and Tethers for Children (LATCH) onpage 2-45for how and where to install the child restraintusing LATCH. If a child restraint is secured in thevehicle using a safety belt and it uses a top tether, seeLower Anchors and Tethers for Children (LATCH)on page 2-45for top tether anchor locations.
Do not secure a child seat in a position without a toptether anchor if a national or local law requires that thetop tether be anchored, or if the instructions thatcome with the child restraint say that the top strap mustbe anchored.
In Canada, the law requires that forward-facing childrestraints have a top tether, and that the tether beattached.
If the child restraint does not have the LATCH system,you will be using the safety belt to secure the childrestraint in this position. Be sure to follow theinstructions that came with the child restraint. Securethe child in the child restraint when and as theinstructions say.
If more than one child restraint needs to be installed inthe rear seat, be sure to readWhere to Put theRestraint on page 2-44.
1. Put the child restraint on the seat.
2. Pick up the latch plate, and run the lap and shoulderportions of the vehicle’s safety belt through oraround the restraint. The child restraint instructionswill show you how.
2-51

3. Push the latch plate into the buckle until it clicks.
Position the release button on the buckle so thatthe safety belt could be quickly unbuckled ifnecessary.
4. Pull the rest of the shoulder belt all the way out ofthe retractor to set the lock.
2-52

5. To tighten the belt, push down on the child restraint,pull the shoulder portion of the belt to tighten thelap portion of the belt and feed the shoulderbelt back into the retractor. When installing aforward-facing child restraint, it may be helpful touse your knee to push down on the child restraint asyou tighten the belt.
6. If the child restraint has a top tether, follow the childrestraint manufacturer’s instructions regarding theuse of the top tether. SeeLower Anchors andTethers for Children (LATCH) on page 2-45for moreinformation.
7. Push and pull the child restraint in differentdirections to be sure it is secure.
To remove the child restraint, unbuckle the vehicle safetybelt and let it return to the stowed position. If the toptether is attached to a top tether anchor, disconnect it.
Securing a Child Restraint in the
Center Front Seat Position
{WARNING:
A child in a child restraint in the center front seat
can be badly injured or killed by the frontal airbags
if they inflate. Never secure a child restraint in the
center front seat. It is always better to secure a
child restraint in a rear seat.
Do not use child restraints in the center front seatposition.
2-53

Securing a Child Restraint in the
Right Front Seat Position
This vehicle has airbags. A rear seat is a safer place tosecure a forward-facing child restraint. SeeWhere toPut the Restraint on page 2-44.
In addition, the vehicle has a passenger sensing systemwhich is designed to turn off the right front passengerfrontal airbag and seat-mounted side impact airbagunder certain conditions. SeePassenger SensingSystem on page 2-67andPassenger Airbag StatusIndicator on page 4-51for more information, includingimportant safety information.
A label on the sun visor says, “Never put a rear-facingchild seat in the front.” This is because the risk tothe rear-facing child is so great, if the airbag deploys.
{WARNING:
A child in a rear-facing child restraint can be
seriously injured or killed if the right front passenger
airbag inflates. This is because the back of the
rear-facing child restraint would be very close to the
inflating airbag. A child in a forward-facing child
restraint can be seriously injured or killed if the right
front passenger airbag inflates and the passenger
seat is in a forward position.
Even if the passenger sensing system has turned
off the right front passenger frontal airbag, no
system is fail-safe. No one can guarantee that an
airbag will not deploy under some unusual
circumstance, even though it is turned off.
Secure rear-facing child restraints in a rear seat,
even if the airbag is off. If you secure a
forward-facing child restraint in the right front seat,
always move the front passenger seat as far back
as it will go. It is better to secure the child restraint in
a rear seat.
SeePassenger Sensing System on page 2-67for
additional information.
2-54

If the child restraint has the LATCH system, seeLowerAnchors and Tethers for Children (LATCH) onpage 2-45for how and where to install the child restraintusing LATCH. If a child restraint is secured using asafety belt and it uses a top tether, seeLower Anchorsand Tethers for Children (LATCH) on page 2-45fortop tether anchor locations.
Do not secure a child seat in a position without a toptether anchor if a national or local law requires that thetop tether be anchored, or if the instructions thatcome with the child restraint say that the top strap mustbe anchored.
In Canada, the law requires that forward-facing childrestraints have a top tether, and that the tether beattached.
You will be using the lap-shoulder belt to secure thechild restraint in this position. Follow the instructions thatcame with the child restraint.
1. Move the seat as far back as it will go beforesecuring the forward-facing child restraint.
When the passenger sensing system has turned offthe right front passenger frontal airbag andseat-mounted side impact airbag, the off indicatoron the passenger airbag status indicator should lightand stay lit when you start the vehicle. SeePassenger Airbag Status Indicator on page 4-51.
2. Put the child restraint on the seat.
3. Pick up the latch plate, and run the lap and shoulderportions of the vehicle’s safety belt through oraround the restraint. The child restraint instructionswill show you how.
2-55

4. Push the latch plate into the buckle until it clicks.
Position the release button on the buckle so thatthe safety belt could be quickly unbuckled ifnecessary.
5. Pull the rest of the shoulder belt all the way out ofthe retractor to set the lock.
2-56